Lipid components,fatty acid distributions of triacylglycerols and phospholipids in rice brans

Endogenous tocochromanols in extracted lipids from rice brans of the five cultivars were determined by high-performance liquid chromatography, and were investigated in relation to the fatty acid (FA) distribution of triacylglycerols (TAG) and phospholipids (PL). The dominant tocols were α-tocopherol and γ-tocotrienol, followed by α-tocotrienol and with much smaller amounts of γ-tocopherol and δ-tocotrienol. The lipids of these rice brans comprised mainly TAG (80.6–86.0 wt.%), free FA (4.2–9.0 wt.%), and phospholipids (5.5–6.7 wt.%), whilst other components were also detected in minor proportions (0.2–2.1 wt.%). The PL components included phosphatidyl choline (31.8–46.8 wt.%), phosphatidyl ethanolamine (25.0–38.9 wt.%) and phosphatidyl inositol (20.2–23.2 wt.%). Comparison of these different cultivars showed, with a few exceptions, no significant differences (P > 0.05) in FA distribution. FA distribution of TAG among the five cultivars was evident in the rice brans: unsaturated FA were predominantly concentrated at the sn-2 position and saturated FA primarily occupying the sn-1 or sn-3 position. These results suggest that the tocopherol content, lipid component, and FA distribution in rice brans are not dependent on the cultivation areas during the growing season.     

Effect of mixing ratio on bactericidal action of MgO–CaO powders

MgO–CaO powders were prepared with different molar ratios (MgO/CaO) at 1400 °C for 2 h in air. By using the powder samples obtained, the change in bactericidal effect as a function of MgO–CaO composition was studied by colony count method. From the XRD measurements, it was found that CaO solid solution was formed by the replacement of Mg²⁺ ion with larger Ca²⁺ ion. However, no formation of MgO solid solution was observed. The average particle size and the specific surface area of the samples used in this study were about 0.2 m and 10.5m²g^–1, respectively. The pH values of physiological saline containing powder samples increased with the increase of CaO content, and the value reached 12.1 in sample with the molar ratio (MgO/CaO) of 0.25. From the results of bactericidal tests for Staphylococcus aureus, it was found that the bactericidal effect increased with the increase of CaO content in the samples.     

Novel circular-beam equalizing techniques that use graded-index fiber optics for a high-power laser diode

We demonstrate a novel method of equalizing a laser diode (LD) beam into a circular beam. This method uses the twist effect of graded index (GI) fiber optics. An asymmetric LD beam with beam qualities of M2 = 500 in the slow axis and M2 = 4 in the fast axis is converted successfully into a symmetric circular beam with a beam quality of M2 = 175. The circular-output beam with 92% coupling efficiency from the fiber input to the fiber output is obtained with a 5-m-long GI1200 (1200 means a core diameter of 1200 microm) fiber for a 2-W LD array. We extend the experiments to a higher-power source with higher asymmetric beam qualities of M2 = 3000 and M2 = 4. By slightly bending the GI10000 (10000 means a core diameter of 10,000 microm) fiber, we have succeeded in generating a symmetric beam with a improved beam quality of M2 = 2000. The average beam quality is preserved when the asymmetric ratio is not high, and the beam quality degradation ratio is investigated up to asymmetric ratios of 750.     

Antifungal activity of the fermentation product of herbs by lactic acid bacteria against tinea

The fermentation product of herbs by lactic acid bacteria (FHL), in which Enterococcus faecalis TH10 predominated, was assayed for antifungal activity against tinea. The antifungal activity of FHL was as high as that of a synthetic fungicide. Autoclaving FHL did not reduce its antifungal activity, whereas neutralizing it did. The results suggested that nonproteinaceous compounds or organic acids in FHL could inhibit the growth of the dermatophyte tinea under low-pH conditions, and that malonic acid and acetic acid could have especially high antifungal activity against tinea.     

A New CMC-AA Resin/Inorganic-gel Super Absorbent Material

A super absorbent material was prepared with the super absorbent resin （ SAR ） and inorganic gel. The SAR of the carboxymethyl cellulose grafting acrylic acid （ CMC-AA ） was copolymer synthesized using the method of inverse-phase suspension polymerization. The influences of the monomer concentration, neutralization degree, the initiator, dispersion agent, cross-linking agent, reaction and drying temperature on the grafting copolymer properties were examined. Meanwhlie, its properties was investigated and the model for absorption mechanism of this absorbent composite was proposed.     

Behavior of Buried Flexible Pipe under High Fills and Design Implications

The existing design guidelines for buried flexible pipes are limited to depth up to 10?m. The increasing use of difficult terrains for infrastructure, landfills, and residential and industrial developments has prompted installation of drainage pipelines under 20–30?m high fills. This paper presents the behavior of an instrumented flexible pipe buried under a 47.1?m deep fill. For filling above 20?m, the measured vertical stress above the pipe exhibited a concave distribution, corresponding to 90 and 110% of the average vertical pressure at the center and edges of the pipe, respectively. The measured results suggest that a triangular lateral pressure distribution can lead to overly conservative and uneconomical results for high fills while Spangler’s analysis is unconservative. Based on the measured results, a revised vertical and lateral earth pressure diagram was proposed for the design of flexible pipe under high fills >20?m. This paper proposes closed-form analyses for estimating the moments and displacements of the pipe subjected to high fill earth pressures. These closed-form solutions agree well with the measured pipe displacements and strains.     

Multiple fuzzy state-value functions for human evaluation through interactive trajectory planning of a partner robot

The purpose of this study is to develop partner robots that can obtain and accumulate human-friendly behaviors. To achieve this purpose, the entire architecture of the robot is designed, based on a concept of structured learning which emphasizes the importance of interactive learning of several modules through interaction with its environment. This paper deals with a trajectory planning method for generating hand-to-hand behaviors of a partner robot by using multiple fuzzy state-value functions, a self-organizing map, and an interactive genetic algorithm. A trajectory for the behavior is generated by an interactive genetic algorithm using human evaluation. In order to reduce human load, human evaluation is estimated by using the fuzzy state-value function. Furthermore, to cope with various situations, a self-organizing map is used for clustering a given task dependent on a human hand position. And then, a fuzzy state-value function is assigned to each output unit of the self-organizing map. The robot can easily obtain and accumulate human-friendly trajectories using a fuzzy state-value function and a knowledge database corresponding to the unit selected in the self-organizing map. Finally, multiple fuzzy state-value functions can estimate a human evaluation model for the hand-to-hand behaviors. Several experimental results show the effectiveness of the proposed method.     

Spatial indexing of high-dimensional data based on relative approximation

We propose a novel index structure, the A-tree (approximation tree), for similarity searches in high-dimensional data. The basic idea of the A-tree is the introduction of virtual bounding rectangles (VBRs) which contain and approximate MBRs or data objects. VBRs can be represented quite compactly and thus affect the tree configuration both quantitatively and qualitatively. First, since tree nodes can contain a large number of VBR entries, fanout becomes large, which increases search speed. More importantly, we have a free hand in arranging MBRs and VBRs in the tree nodes. Each A-tree node contains an MBR and its children VBRs. Therefore, by fetching an A-tree node, we can obtain information on the exact position of a parent MBR and the approximate position of its children. We have performed experiments using both synthetic and real data sets. For the real data sets, the A-tree outperforms the SR-tree and the VA-file in all dimensionalities up to 64 dimensions, which is the highest dimension in our experiments. Additionally, we propose a cost model for the A-tree. We verify the validity of the cost model for synthetic and real data sets. Edited by T. Sellis. Received: December 8, 2000 / Accepted: March 20, 2002 Published online: September 25, 2002     

Effects of4He coverage on the propagation of fourth sound in superfluid3He

We report measurements on the effects of⁴He coverage and pressure on the fourth sound propagation in superfluid³He in confined geometries of four different pore sizes.