FBOLES—outline of a frequency-based on-line expert system approach for fault diagnoses in nuclear power plants

The basic concept of a novel frequency-based on-line expert system (FBOLES) approach for on-line fault diagnoses in nuclear power plants has been presented previously. This paper reports further progress, and includes how to express the uncertainties of expert opinion in knowledge-bases and propagate then in inferences, and how to deal with imperfect knowledge-bases. It also describes the main elements of FBOLES and outlines how the system works under complex conditions including the dynamic behavior of signals during accidents, multiple failures, and on-line changes of plant operation mode. Its ability to diagnose root causes of accidents has been tested using the main steam and feedwater condensate systems of a full-scale, three-loop, 950 MW nuclear power plant simulated by the Tsinghua simulator. So far the results seem good.     

氧气放电辅助激光淀积原位制备高T_c超导薄膜

采用低压氧气放电辅助的激光淀积方法,原位外延生长出零电阻温度91K,临界电流密度10~5A/cm~2的Y-Ba-Cu-O高温超导薄膜。扫描电镜和X光衍射分析结果表明,薄膜中超导相晶粒的生长具有c轴垂直于表面的择优取向。     

关于水利勘察设计院改制问题研究

水利勘察设计单位转制改企是一项复杂的系统工程，涉及问题多，各种应素复杂。本文通过原水利部直属的七大勘测设计研究院，在改企转制工作中的共性问题，研究、探讨相应的解决措施。     

发射极δ掺杂的InGaAs/InPDHBT的特性分析

设计了一种新结构的InGaAs/InP双异质结晶体管(DHBT),其中发射结采用δ掺杂和阻挡层结构,集电极采用N+掺杂复合结结构.考虑隧穿作用和发射结空间电荷区复合电流的影响,计算了δ掺杂浓度和N+、n-层厚度等参数变化对InGaAs/InP DHBT电流、I-V输出特性、电流增益的影响,计算结果表明,随着这些参数值增大,InGaAs/InP DHBT输出特性逐渐改善.当δ掺杂浓度大于2×1012cm-3时,电流增益趋于饱和.     

纸张用有机硅抗水剂的制备

采用氨基硅油、十二烷基三甲氧基硅烷、甲基三乙氧基硅烷配成11种抗水剂,用于纸张的抗水处理.通过渗透法和接触角法测试发现,有机硅抗水剂对实验选择的9种纸张均有明显的抗水效果;其中采用氨基硅油配制的抗水剂效果最好,经其处理的生宣纸与空白样相比,接触角由完全润湿提高到125°,渗透时间由0提高到18 s.最佳应用工艺为:将氨基硅油配制成质量分数为2.041%的甲苯溶液,按照10g/m2的涂布量喷涂于纸张表面,自然晾干3～5天至恒定质量.     

中山古镇风韵独具

特殊的自然地理环境和社会、经济、文化的影响,形成了重庆市江津中山镇鲜明的地域文化特色,这些特色突出地表现在城镇形态格局、街巷空间布局、建筑空间开合等方面。本文对此进行了深入的研究。     

Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

改烧贵州煤后栲胶脱硫系统存在的问题及解决

栲胶法脱硫具有硫容高、副反应少、传质速率快、脱硫效率高且稳定、原料消耗低、腐蚀轻、硫磺回收率高等优点, 自投入工业应用以来,已在中小氮肥厂、炼焦、城市煤气、环保等行业得到了广泛应用.从实际应用情况看,绝大多数厂脱硫效果良好,但有关栲胶脱硫对不同煤种的适应性这一问题目前还少有文章进行探讨.本文对我公司从山西煤改烧贵州煤后栲胶脱硫系统出现的问题及解决办法作一介绍.     

CX6112车铣复合机床设计方案的研究与探讨

文章较系统地论述了车铣复合机床设计方案的形成过程，同时分析了该设计方案的持点，并简要介绍了该产品的主要技术参数和用途，简评了该产品的技术水平。