Fluid jet polishing of optical surfaces

We present a new finishing process that is capable of locally shaping and polishing optical surfaces of complex shapes. A fluid jet system is used to guide a premixed slurry at pressures less than 6 bars to the optical surface. We used a slurry comprising water and 10% #800 SiC abrasives (21.8 mum) to reduce the surface roughness of a BK7 sample from 350 to 25 nm rms and to vary the shape of a polished sample BK7, maintaining its surface roughness of 1.6 nm rms, thereby proving both the shaping and polishing possibilities of the presented method.     

Laser-speckle angular-displacement sensor: theoretical and experimental study

A novel, to our knowledge, method for the measurement of angular displacement for arbitrarily shaped objects is presented in which the angular displacement is perpendicular to the optical axis. The method is based on Fourier-transforming the scattered field from a single laser beam that illuminates the target. The angular distribution of the light field at the target is linearly mapped on a linear image sensor placed in the Fourier plane. Measuring this displacement facilitates the determination of the angular displacement of the target. It is demonstrated both theoretically and experimentally that the angular-displacement sensor is insensitive to object shape and target distance if the linear image sensor is placed in the Fourier plane. A straightforward procedure for positioning the image sensor in the Fourier plane is presented. Any transverse or longitudinal movement of the target will give rise to partial speckle decorrelation, but it will not affect the angular measurement. Furthermore, any change in the illuminating wavelength will not affect the angular measurements. Theoretically and experimentally it is shown that the method has a resolution of 0.3 mdeg ( approximately 5 murad) for small angular displacements, and methods for further improvement in resolution is discussed. No special surface treatment is required for surfaces giving rise to fully developed speckle. The effect of partially developed speckle is considered both theoretically and experimentally.     

Efficient Nd:YAG Laser Frequency Doubling with Periodically Poled KTP

Periodically poled flux-grown KTiOPO(4) was used for efficient extracavity 1064-nm Nd:YAG laser frequency doubling. A conversion efficiency exceeding 65% was obtained in Q-switched operation, and 1.34 W of average frequency-doubled power was generated with 2.2 W of mode-locked laser output. The conversion efficiency is approximately two times higher for periodically poled KTP than for conventional type II phase-matched KTP. The measurements indicate that periodically poled KTP is less susceptible to optical damage than type II KTP.     

Linearity of the Faraday-rotation-type ac magnetic-field sensor with a ferrimagnetic or ferromagnetic rotator film

We analyze the linearity and modulation depth of ac magnetic-field sensors or current sensors, using a ferrimagnetic or ferromagnetic film as the Faraday rotator and employing the detection of only the zeroth-order optical diffraction component from the rotator. It is theoretically shown that for this class of sensor the condition of a constant modulation depth and that of a constant ratio error give an identical series of curves for the relationship between Faraday rotation angle Θ and polarizer/analyzer relative angle Φ. We give some numerical examples to demonstrate the usefulness of the result with reference to a rare-earth iron garnet film as the rotator.     

Simulations of time series of atmospherically distorted wave fronts

A comparatively simple way to generate time series of atmospherically distorted wave fronts is described and tested. Temporal power spectra of Zernike aberrations, extracted from the time series, agree very well with theoretical predictions. A method for generation of longer time series is also shown to give results in accordance with theory, except for the lowest temporal frequencies modeled. A way to superimpose several time series of wave fronts to generate a multilayer model of the atmosphere is briefly discussed.     

Polarization-dependent photothermal beam deflection for the determination of the order parameter C(2) in a laser-oriented polymer system

We demonstrate polarization-dependent photothermal beam deflection as a powerful tool for analyzing quasi-two-dimensional molecular orientation. As examples we used two laser-beam-oriented polymer systems: DR1 in poly(methyl methacrylate) (PMMA) and PMMA with covalently bound DR1 and for comparison Phenol Blue in PMMA. Different order parameters C(2), for these systems have been found. It was also possible to orient by laser beam the DR1 chromophores cyclically by changing the polarization direction of the orienting laser beam and following these chromophore reorientations. The long-term stability of the orientation was investigated as well. The irreversible bleaching that is due to this laser treatment could be determined. Angular hole burning could easily be detected in these systems.     

Three-dimensional optical bit-memory recording and reading with a photorefractive crystal: analysis and experiment

We analyze the three-dimensional refractive-index distribution that is induced locally when a laser beam is focused onto a very small region in a photorefractive crystal. The formation of the index distribution is deduced from the temporal behavior of the electron density distribution in the crystal under non-steady-state conditions. The density distribution is computed by the use of a set of the recurrence relations that was derived from Kukhtarev's equations, which describe the transport of electrons in time. In particular, we calculated the index distribution formed in Fe-doped LiNbO(3) crystals. To verify the validity of our analysis, we read, by using a phase-contrast microscope, refractive-index dots that were recorded in Fe-doped LiNbO(3) crystals. A good agreement was obtained between experimental results and the calculated phase-contrast images when the characteristics of the imaging system are taken into account. We also found that the induced index change is largest when the c axis of the LiNbO(3) crystal is oriented parallel to the polarization direction of the reading beam. Under this optimal condition, we succeeded in recording up to 10 layers of readable data in a LiNbO(3) crystal.     

Highly efficient wideband continuum generation in a single-mode optical fiber by powerful broadband laser pumping

By pumping a single-mode optical fiber with a powerful broadband nonselective dye laser, we obtain a high-efficiency wideband continuum (530-930 nm) with nonlinear conversion efficiency exceeding 90%. Experimental conditions for a coherent regime of broadband stimulated Raman scattering are created, which in combination with the broadband self-phase modulation and the four-photon parametric processes leads to a spectral broadening and to the continuum formation. The influence of the pump laser spectral linewidth on the nonlinear conversion efficiency is analyzed and investigated by comparative experiments at narrow-band and broadband laser excitations.     

Perpendicular-incidence photometric ellipsometry of biaxial anisotropic thin films

A new measurement technique for the characterization of uniaxial as well as biaxial anisotropic surfaces and thin films is introduced. This technique is based on perpendicular-incidence photometric ellipsometry, in which a spectral-photometric dynamic ellipsometer with a rotating polarizer is used. This method is sensitive, contactless, nondestructive, and efficient for the estimation of anisotropic behavior. Furthermore, the spectroscopic measurement directly provides the anisotropy dispersion down to the UV wavelength range. Results on structurally anisotropic HfO(2) coatings are presented.     

Intraneuronal information processing, directional selectivity and memory for spatio-temporal sequences

Interacting intracellular signalling pathways can perform computations on a scale that is slower, but more fine-grained, than the interactions between neurons upon which we normally build our computational models of the brain (Bray D 1995 Nature 376 307-12). What computations might these potentially powerful intraneuronal mechanisms be performing? The answer suggested here is: storage of spatio-temporal sequences of synaptic excitation so that each individual neuron can recognize recurrent patterns that have excited it in the past. The experimental facts about directionally selective neurons in the visual system show that neurons do not integrate separately in space and time, but along straight spatio-temporal trajectories; thus, neurons have some of the capacities required to perform such a task. In the retina, it is suggested that calcium-induced calcium release (CICR) may provide the basis for directional selectivity. In the cortex, if activation mechanisms with different delays could be separately reinforced at individual synapses, then each such Hebbian super-synapse would store a memory trace of the delay between pre- and post-synaptic activity, forming an ideal basis for the memory and response to phase sequences.