人力资源投资评价应解决的两个重要问题

阐述了企业人力资源投资财务评价应解决的两个重要问题：评价对象的分类和项目的财务现金流量的内容。     

土的最大干密度和最优含水率快速测定法

对快速击实试验研究成果进行了总结,并介绍了应用快速击实试验研究成果的经验.不论是重型击实还是轻型击实,也不论击实试验所给定的击实功能多大,应用"一点法"或"快速法"击实试验原理,对土料都有一定要求."一点法"击实试验与快速击实试验所用土体的比重在2.67～2.73之间,当被测土样的比重超越此范围时,在绘制击实曲线时可适当偏离ρdmax计算值的点,但这个误差是很小的,通常ρdmax的影响在±0.01 g/cm3以内,而对ωop的影响在±0.5%以内.结合工程实例,对击实试验成果的简化校正作了详细介绍.     

Trace elements in particles of motor vehicle exhaust in Shanghai

A nuclear microprobe with high spatial resolution and high analytical sensitivity was applied to analyze trace elements,especially lead,in vehicle exhaust of Shanghai city.The result shows that the chemical composition and its corresponding x-ray relative intensity are different among different vehicle exhausts.There are many kinds of metal elements in particles of vehicle exhaust.most are harmful to people,such as Ti,Cr,Mn,Pb,etc.We found that the lead concentration was 6820μg/g and the bromine concentration was 5300μg/g in the exhaust from Santana using leaded gasoline(SULG).which is higher than any other kinds of vehicle exhausts.We have also detected the minimum lead in the particles of unleaded gasoline and its content varies from one to another.Its mean concentration was 450μg/g and the highest reached 6210μg/g.The unleaded gasoline‘s Pb existed in the whole particle while the leaded gasoline‘s enriched in the surface of the particle and was more harmful to the human beings.     

纳米碳酸钙制备过程中添加剂作用机理探讨

采用鼓泡碳化法 ,在最佳反应温度、反应物浓度的条件下 ,考察了添加剂对产物形状及粒径大小的影响 ,得到了直径为 2 0～ 30nm、长径比在 2 0左右且分散性能良好的针状纳米碳酸钙 ,并对添加剂作用机理进行了分析。     

"大学城"建设的冷思考

基于大学校园建设实践,分析目前新校园建设中存在的共性问题,并为校园建设发展提出若干建议。     

场激活加压燃烧合成WC-Ni复合材料的工艺参数研究

以钨、碳和镍为原料,在电场激活下,材料的燃烧合成和致密化同时进行,短时间内完成了碳化钨镍复合材料的制备。研究了场激活 加压燃烧合成中的工艺参数,如脉冲电流、能量控制模式、升温速率、最高温度和压力对反应的影响。测量了在反应合成和致密化前后的样品 收缩率。所制备的复合材料的相对密度,490N载荷下Vickers硬度和断裂韧性分别为99.2%,13.965GPa和5.9MP·m1/2。     

第二代反坦克导弹射击训练计算机成绩评定方法

文中应用数理统计方法并结合教学及实弹射击实践,提出了在第二代反坦克导弹模拟训练器材中实现智能化评定射击训练成绩的主要方法.     

浅析异步电机电子软起动器的现状和展望

本文在分析异步电机电子软起动器的现状和展望的基础上，以一个当前正在设计完善的电子软起动器为例，基本说明新型电子软起动器的特点和结构功能。     

Optimal diagonal precoder for multiantenna communication systems

In this paper, we examine a multiantenna single-user wireless communication system fitted with a QR-based successive cancellation receiver (QR receiver). Initially, our consideration is confined to uncoded binary phase shift keying (BPSK) signals transmitted through independent and identically distributed (IID) Rayleigh fading channels and to the design of an optimum precoder for the transmitter. For minimum feeding back of the channel state information (CSI) to the transmitter from the receiver, we stipulate the precoder to be in the form of a power loading square diagonal matrix. We proceed to develop the theory for the design of this diagonal matrix based on the minimization of the lower bound of the average bit error rate (BER) of transmission. The design obtained provides substantially lower error rates than most of other existing schemes under the same environment. The corresponding gain in signal-to-noise ratio (SNR) can be several decibels. To further improve the performance, we extend the design to include an optimal detection order of the received bits using an iterative approach. This iterative process proves to have fast convergence and results in a design providing significant SNR gain. We also propose a subchannel dropping scheme for cases in which SNR is low, and when the minimum BER precoder is equipped with this scheme, its average performance can be substantially superior to the Vertical Bell Laboratories Layered Space-Time (V-BLAST) detection. We extend our design of the optimum precoder to quadrature amplitude modulation (QAM) modulation scheme and similar performance gain has been observed.