气-电纺PHB引导组织再生膜的仿生矿化研究

实验将PHB通过气流-高压静电纺丝制成无纺膜，利用扫描电镜（SEM）、X射线衍射（XRD）对其形态和结构进行表征。在体外研究中，分别将无纺膜样本浸入37℃1．5倍仿生体液（SBF）中3、7、14、28d后对其表面形态和结构进行表征。结果表明，气电纺PHB无纺膜由超细纤维交织而成，纤维之间有多孔形成；通过气流一静电纺丝之后，PHB的结晶度及晶体的有序度降低；PHB膜在SBF中浸泡3天之后就有矿化结晶在纤维的表面形成，随着浸泡时间的增长，矿化结晶的数目增加，结晶度也随之增高，XRD及FTIR表明形成的结晶为含有碳酸根的磷灰石晶体。     

Synergistic inhibition between o-phenanthroline and chloride ion for steel corrosion in sulphuric acid

The corrosion inhibition of cold rolled steel in 0.5 M sulphuric acid in the presence of o-phenanthroline and sodium chloride (NaCl) has been investigated by using weight loss and electrochemical techniques. The experimental data suggest that the inhibition efficiency increases with increasing NaCl concentration in the presence of 0.0002 M o-phenanthroline, but decreases with increasing temperature. A synergistic effect is observed when o-phenanthroline and chloride ions are used together to prevent cold rolled steel corrosion in 0.5 M sulphuric acid. The polarization curves showed that the complex of o-phenanthroline and NaCl acts as a mixed type inhibitor. The experimental results suggested that the presence of chloride ions in the solution stabilized the adsorption of o-phenanthroline molecules on the metal surface and improved the inhibition efficiency of o-phenanthroline. The adsorption of the complex accords with the Langmuir adsorption isotherm. Some thermodynamic parameters such as adsorption heat, adsorption entropy and adsorption free energy have been calculated by employing thermodynamic equations. Kinetic parameters such as apparent activation energy and pre-exponential factor have been calculated and discussed.     

单级单开关不连续导电模式功率因数校正电路新方案

分析了几种单级单开关不连续导电、带输出电压隔离的功率因数校正电路，分别讨论了其优缺点，并提出了一种新的功率因数校正电路。     

Mn含量对0.15C-0.6Si-Mn TRIP钢组织和力学性能的影响

经过在两相区退火和贝氏体区等温处理，研究了两种不同锰含量的低硅TRIP钢的组织和力学性能，试验结果表明，低硅和低锰钢的残留奥氏体量少，力学性能差；增加锰含量，能提高残留奥氏体量及拉伸强度和伸长率，其力学性能与常规低碳Si-MnTRIP钢的水平相关，用电子探针测试了两相区退火钢中锰和硅的分布情况，发现锰在临界区退火时不发生再分配。     

STRENGTHENING OF THE Fe-0.04Nb-0.02C ALLOY

Fe-0.04Nb-0.02C合金经1175—900℃轧制并随即在600℃等温处理后,获得直径为7—22微米等轴细晶粒的α-Fe。在α-Fe中保留相当数量的三维和二维位错网络,并沉淀析出细小的NbC粒子。通过细化晶粒,NbC第二相粒子和位错亚结构的综合强化,合金下屈服强度可提高到35—38公斤/毫米~2。下屈服强度σ_(1y)与晶粒的平均直径d之间的关系符合Hall-Petch公式: σ_(1y)=σ_i+k_yd~(-(1/2)) 其中k_y=2.2公斤/毫米~(3/2);对于600℃等温30秒,40分及3小时者,σ_i分别为21.5,13.5及13.5公斤/毫米~2。理论计算结果表明,σ_i值是NbC第二相粒子弥散强化,位错亚结构强化和点阵阻力对屈服强度贡献σ_p,σ_d和σ_1的叠加,即 σ_i=σ_p+σ_d+σ_1 合金的位错密度随拉伸变形程度的增高而增加。平均位错密度ρ与对应的流变应力值σ_f的关系可表达成下式 σ_f=σ_0+αGbρ~(1/2) 其中α=0.37;σ_0是除位错交互作用外其他因素对流变应力的贡献,对于600℃等温30秒,40分和3小时者,σ_0分别为34,30及30公斤/毫米~2。 在α-Fe中沉淀析出的NbC粒子周围观察到“沉淀生长”位错圈,对其形成机理进行了分析,它们的强化作用尚需进一步探明。     

知识·权力和学术自由

本文对学术自由的合法性依据 ,即“对真理的追求”进行了质疑 ,指出知识还具有权力性特征 ,正是这一特征造成了学术自由与外部权威的紧张关系。学术史就是知识和权力交织、纽结的历史。在学术自由已为各国法律普遍认可之后 ,学术自由的理论和实践层面依然存在着诸多悬而未决的疑难。     

粉末注射成形耐热不锈钢的工艺研究

以元素混合粉为原料,研究了耐热不锈钢的注射成形工艺.重点讨论了烧结温度、时间及气氛对耐热不锈钢致密度、力学性能及微观组织的影响,获得的最佳工艺为烧结温度1375℃,时间60 min,真空气氛.在此条件下制备了致密度98.12%、抗拉强度510 MPa、铁素体组织的PIM耐热不锈钢.     

MICROSTRUCTURE AND PROPERTIES OF C-Cu NANOSTRUCTURE THIN FILM

Nanostructured C-Cu thin films were deposited by reactive sputtering method and co-sputtering method. The relationships between microstructures, properties, and depo-sition parameters were studied and the results obtained from TEM, AFM, and XPS.indicate that the thin films are nanostructural, and have good in-depth uniformity. Theselected area electron diffraction (SAED) found that the nanosize Cu particles havethe fcc structure and the others are amorphous carbon or nanocrystallized graphiticcarbon. The peak positions of the Cu and C in XPS indicate them to be at the ele-mental state. In the IR transmission spectrum, diamond two-phonon absorption andgraphite Raman peaks were observed, which suggests microcrystal diamond particlesand graphite components exist in the C-Cu film. The higher electrical resistivity wasobtained.     

EFFECT OF NaOH CONCENTRATION AND AlO_2~- SPECIES ON CAUSTIC STRESS CORROSION CRACKING OF A LOW ALLOY STEEL AT 260℃

用慢应变速率法（ＳＳＲＴ）、动电位扫描和循环伏安法研究１６ＭｎＲ钢在氧化铝溶出过程中的高温碱脆行为。结果表明，在２６０℃，１６ＭｎＲ钢的碱脆敏感性随ＮａＯＨ浓度（７．４２－１０．０６ｍｏｌ／Ｌ）的升高而增大；当碱液中含有ＡｌＯ２＾－离子时，１６ＭｎＲ钢的碱脆敏感电位区缩小，样品表面腐蚀产物保护性好，ＡｌＯ２＾－离子对低合金钢高温碱脆有一定抑制作用；１６ＭｎＲ钢在２６０℃碱液中生成的腐蚀产物为Ｆｅ３     

Nd：NaR（WO4）2晶体光谱性能研究（R=Bi，Y）

采用提拉法生长出了掺钕钨酸铋钠（分子式Nd：NaBi（WO4）2，简称Nd：NBW）和掺钕钨酸钇钠（分子式Nd：NaY（WO4）2，简称Nd：NYW）晶体。通过TG-DTA分析得到Nd：NBW的熔点为936．2℃，Nd：NYW的熔点为1209．07℃。由吸收光谱可以看出，Nd：NBW在802nm有较强的吸收峰，Nd：NYW在804nm，752nm，586nm附近有较强、较宽的吸收峰，二者均适合于LD泵浦；并计算了晶体中Nd^＋3＋的吸收截面积。通过比较Nd：NBW和Nd：NYW的红外光谱和拉曼光谱结果，认为二者结构基本相同，为四方晶系、白钨矿结构、141/a空间群。