Characterization of a multilayer film activated with Lactobacillus curvatus CRL705 bacteriocins

BACKGROUND: Bacteriocins produced by lactic acid bacteria offer enormous promise for food safety preservation. In this study an active multilayer film obtained by the incorporation of lactocin 705 and lactocin AL705, two bacteriocins produced by Lactobacillus curvatus CRL705 with antimicrobial activity against Lactobacillus plantarum CRL691 and Listeria innocua 7, respectively, was characterized for its potential application in active packaging technology. Film activity performance at different storage conditions, bacteriocins transfer into water and sunflower oil, and film surface properties were evaluated. RESULTS: Film activity against L. innocua 7 was maintained during 2, 4 and 6 weeks at 30, 10 and 5 °C respectively. At 30 and 10 °C, activity loss against L. plantarum CRL691 was observed on the second week of storage and after the fourth week at 5 °C. Results showed no significant difference for active multilayer film contact angle and seal properties compared to the control (without bacteriocins). A decrease in lactocin 705 inhibitory activity after sunflower oil contact was observed, while lactocin AL705 remained unaffected. After water contact, film activity was retained for both bacteriocins. CONCLUSIONS: As demonstrated by antimicrobial activity and physico‐mechanical properties retention, lactocin 705 and AL705 active multilayer film present potential for application in active packaging technology. Copyright © 2011 Society of Chemical Industry     

Isolation of a powerful antioxidant from Olea europaea fruit-mill waste: 3,4-Dihydroxyphenylglycol

Nutritional and antioxidant properties of phenolic compounds are important in relation to human health and palatability of products. 3,4-Dihydroxyphenylglycol (DHPG) is a strong antioxidant found in small amounts in virgin olive oil and table olives, with an antioxidant activity even higher than that of the powerful hydroxytyrosol. The origin of this antioxidant is completely unclear since has never been reported as a free plant metabolite. In this respect possible precursors of DHPG have also been discussed in this study. The presence of soluble compounds that either contain DHPG in their molecular structure or act as substrates for its synthesis has been showed for the first time. The quantities of DHPG recovered in olive drupe tissue by thermal treatment exceed widely the values indicated in the literature, showing the release or formation of additional DHPG from precursors after heating. In addition, DHPG obtained under certain extraction conditions from fresh solid waste of two-phase olive oil extraction systems (alperujo) is its most important phenolic compound. Therefore, the solid olive waste is a good source of this simple monomer phenol. The chemical structure, purity and racemic nature of isolated DHPG were also analysed for the first time by NMR experiments.     

Ionic liquid recovery alternatives in ionic liquid‐based three‐phase partitioning (ILTPP)

Ionic liquid‐based three‐phase partitioning (ILTPP) is a promising technique to recover high‐added value proteins at the liquid–liquid interface. Its economic and environmental performance highly depends on the net ionic liquid consumption. Alternatives to maximize the fraction of ionic liquid that can be recycled are studied. It is demonstrated that the addition of extra salt, previously proposed in literature, has a very limited effect on ionic liquid recovery for relatively high protein concentrations in the feed stream, and that it may even lead to an increase of the ionic liquid losses under certain conditions. However, small additions of salt are shown to be effective and profitable from an economic point of view. Vacuum evaporation is shown to allow for the complete ionic liquid and salt recovery, reinforcing the sustainability and viability of ILTPP processes. © 2014 American Institute of Chemical Engineers AIChE J, 60: 3577–3586, 2014     

Heterocyclic polyimides containing siloxane groups in the main chain

BACKGROUND: Among the polymers widely studied for applications in advanced techniques, aromatic polyimides have received considerable attention due to their outstanding thermal stability associated with good electrical and mechanical properties. However, these polymers are usually difficult to process, being insoluble and without a glass transition. To improve the processing characteristics of polyimides, modification of their structure is often achieved by the introduction of flexible linkages in the macromolecular chain or various substituents on the aromatic rings. RESULTS: A series of polyimides and intermediate polyamidic acids were synthesized from aromatic oxadiazole‐diamines and a dianhydride containing a siloxane bridge (? R₂Si? O? SiR₂? ). These polymers exhibit good solubility in certain organic solvents and can be cast into thin and very thin films from their solutions. They exhibit high thermal stability with decomposition being above 440 °C and relatively low glass transition temperatures in the range 160–190 °C. These polymers show strong photoluminescence in the blue spectral region. CONCLUSION: The introduction of oxadiazole rings together with siloxane groups into the chains of aromatic polyimides gives highly thermostable polymers with remarkable solubility and film‐forming ability and that emit blue light, being attractive for applications in micro‐ and nanoelectronics and other related advanced fields. Copyright © 2009 Society of Chemical Industry     

Three-layer flow membrane system on a microchip for investigation of molecular transport

A stable three-layer flow system, water/organic solvent/water, has been successfully applied for the first time in a microchannel to get rapid transport through an organic liquid membrane. In the continuous laminar flow region, the analyte (methyl red) was rapidly extracted across the microchannel from the donor to the acceptor phase through the organic solvent phase (cyclohexane). Thermal lens microscopy was used to monitor the process. The thickness of the organic phase, sandwiched by the two aqueous phases, was approximately 64 microm, and it was considered as a thin liquid organic membrane. Permeability studies showed the effects of molecular diffusion, layer thickness, and organic solvent-water partition coefficient on the molecular transport. In the microchip, complete equilibration was achieved in several seconds, in contrast to a conventionally used apparatus, where it takes tens of minutes. The thickness of the organic and aqueous boundary layers was defined as equal to the microchannel dimensions, and the organic solvent-water partition coefficient was determined on a microchip using the liquid/liquid extraction system. Experimental data on molecular transport across the organic membrane were in agreement with the calculated permeability based on the three-compartment water/organic solvent/water model. This kind of experiment can be performed only in a microspace, and the system can be considered as a potential biological membrane for future in vitro study of drug transport.     

Elastic properties of natural rubber tubes produced by dip‐coating

The mechanical properties of rubber tubes produced by dip‐coating technique and the influence of the fabrication process on their structural properties were evaluated. Cyclic tension versus deformation tests were performed to investigate the elastic properties of the samples and to understand the changes in rubber tubes behavior under repetitive stress. The effect of the wall thickness on the elastic response of the tubes was also studied. The mechanical properties of opened tubes were also investigated for transversal and longitudinal directions to evaluate the influence of the fabrication process on the alignment of the polymer chains. This investigation indicated that the fabricated tubes are resistant and extremely elastic. They can be elongated up to 800% of its initial length before rupture, and thicker tubes are a bit more resistant to elongation than the thinner ones. In addition, the fabricated tubes have an anisotropic structure due to the fabrication process. Finally, natural rubber tubes may have a great potential to be used as vascular prosthesis, or in other applications that require a large range of resistance and elasticity. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 702–707, 2006     

Selectivity of recognition of variable (V) regions of autoantibodies by intravenous immunoglobulin (IVIg)

In the present study, we demonstrate that intravenous immunoglobulin (IVIg) is capable of binding to variable (V) regions of anti-endothelial cell antibodies (AECA) of healthy donors and patients with systemic lupus erythematosus (SLE). Among V regions of AECAs, IVIg selectively recognized certain idiotypes expressed by the autoantibodies of a given individual, in the case of both natural and SLE-associated AECAs. These observations provide new and direct evidence that IVIg interacts idiotypically with V regions of autoantibodies and that the efficacy of such interaction depends on individual autoantibody specificity. Our findings may be relevant for the understanding of the mechanisms that control expression of natural autoantibody activity in serum and for that of the differences in response to IVIg therapy that are seen between patients with autoimmune disease.     

Infection of human marrow stroma by human immunodeficiency virus-1 (HIV-1) is both required and sufficient for HIV-1-induced hematopoietic suppression in vitro: demonstration by gene modification of primary human stroma

Patients with human immunodeficiency virus-1 (HIV-1) infection often present with bone marrow (BM) failure that may affect all hematopoietic lineages. It is presently unclear whether this failure reflects a direct viral impairment of the CD34+ hematopoietic progenitor cells or whether the virus affects the BM microenvironment. To study the effects of HIV-1 on the BM microenvironment, we examined the stromal cell monolayers in long-term BM culture (LTBMC), which are the in vitro equivalent of the hematopoietic microenvironment. We assessed the hematopoietic support function (HSF) of human stromal layers by determining the cellular proliferation and colony-forming ability of hematopoietic progenitors from BM cells grown on the stromal layers. We show that the HSF is reduced by in vitro infection of the human stromal cell layer by a monocytotropic isolate of HIV-1 (JR-FL). There is no loss of HSF when the stromal cell layer is resistant to HIV-1 replication, either using murine stromal cell layers that are innately resistant to HIV-1 infection or using human stromal cells genetically modified to express a gene that inhibits HIV-1 replication (an RRE decoy). Decreased HSF was seen using either human or murine hematopoietic cells, if the stromal cells were human cells that were susceptible to HIV-1 infection. These in vitro studies implicate HIV-1 replication in the stroma as the essential component causing decreased hematopoietic cell production in HIV-1 infection.     

Growth in height of indigenous and non indigenous Chilean children

The aim of this study was to compare growth curves of stature in indigenous and non-indigenous children belonging to two levels of poverty and to establish the onset and evolution of the deficit. Children of indigenous and non-indigenous background living in communities of extreme and low poverty in Chile were studied and their height-for-age Z-score from birth until 6 year of age were compared. Mean weight at birth was within normal range, and no differences were found in ethnicity and levels of poverty. Length at birth was below the reference with the exception of the non indigenous newborn from counties of low poverty. Deficit in growth showed an early start, furthermore in indigenous children belonging to the extreme poverty, is from birth and progress through the 18 months. At 72 months the deficit reached -1.1 z scores in the indigenous of the extreme poverty versus -0.7 in the non indigenous group. Children from the low poverty had a Z-score of -0.4 z scores at 72 months without differences between ethnias. Indigenous of the extreme poverty had less accumulative growth while the indigenous of the low poverty areas growth satisfactory without differences with the non indigenous.