Effects of Al2O3 particle reinforcement on the lubricated sliding wear behavior of ZA-27 alloy composites

The present investigation deals with the effect of Al₂O₃ particle reinforcement on the lubricated sliding behavior of ZA-27 alloy. The composites with 3, 5, and 10 wt% of Al₂O₃ particles were produced by the compocasting procedure. Tribological properties of alloy and composites were studied, using block-on-disk tribometer at different specific loads and sliding speeds. The test results revealed that composite specimens exhibited significantly lower wear rate, but higher coefficient of friction than the matrix alloy specimens in all the combinations of applied loads and sliding speeds. The improved antiwear characteristics of the composites were influenced by positive effects of higher frictional heating on compatibility of the composite phases and suppressing micro-cracking tendency. Due to that, effects of reinforcing hard particles were manifested through the reduced wear rate of composites, especially in conditions of higher load, lower sliding speeds and higher Al₂O₃ particle content. In present wear tests, the significant forming of mechanically mixed layers was not noticed, what is confirmed by the SEM microphotographs.     

Defining a strategy for chemical imaging of industrial pharmaceutical samples on Raman line-mapping and global illumination instruments

The performance of line-mapping and global illumination Raman systems for two pharmaceutical tablets and a powder blend are assessed in this study. The chemical images were obtained from the placebo, real tablets, and powder blend by using x20, x50, and x100 objectives, as well as via the (pseudo) confocal set-up. The chemical images were produced via univariate wavenumbers and as re-folded principal component (PC) scores (known as score images). In most cases it was easy to image two or three major components of the tablets directly, while the minor components were only imaged via PC scores. The active pharmaceutical ingredients (APIs) were located relatively easily even if present in quite low concentrations (less than 1%) owing to the high Raman scattering coefficients of these materials. The strength of the Raman signal of the API makes it almost ubiquitous in the chemical images of real tablets. Thorough discussion is given on the strategies used to produce chemical images, the prospects of making composite images of all components present in the tablets, and the effects of packing density with relation to the diffusion of the excitation laser light inside the sample. The strengths and weaknesses of the Raman imaging techniques used are emphasized and suggestions are given regarding which instrument is preferable with respect to the goal of the experiment and material under study. For example, mapping technology is preferred for analyzing minor components, while the global illumination approach is recommended for imaging of spatially isolated strong Raman scatterers.     

Oily water treatment using a new steady-state fiber-bed coalescer

This study was concerned with the possibility of oil separation from two heavily polluted wastewater types: formation water and wastewater from hardening shop, using bed a newly developed coalescer. Experiments were carried out using original wastewaters and an artificial model wastewater. Results obtained for seven samples of formation water of very different quality showed that the water properties had no significant effect on bed coalescence efficiency. In contrast to this, crude oil properties strongly influenced steady-state bed coalescence. In the treatment of hardening oily wastewater in situ during a 4-month period oil concentration in the effluent was less than 20mg/l in all experiments. It appeared that oil concentration and water quality had no effect on bed separation efficiency. Special design of the coalescer and use of two filter materials ensured its good performance. Namely, the pipe-in-pipe construction provided the water orientation change several times while passing through the unit, making inertia one of dominant separation mechanisms.     

INFERENCE PROCEDURES FOR FUZZY KNOWLEDGE REPRESENTATION SCHEME

This article presents a formal model of the knowledge representation scheme based on the fuzzy Petri net (FPN) theory. The model is represented as a 13-tuple consisting of the components of the FPN, two functions that give semantic meanings to the scheme and a set of contradictions. For the scheme, called the knowledge representation scheme based on the fuzzy Petri nets theory (KRFPN) the fuzzy inheritance and fuzzy recognition-inference procedures based on the dynamical properties of the FPN, are described in detail. The upper-time complexity of both the proposed inference algorithms is O(nm), where n is the number of places (concepts) and m is the number of transitions (relations) in the scheme. Illustrative examples of the fuzzy inheritance and the fuzzy recognition algorithms for the knowledge base, designed by the KRFPN, are given.     

A Mathematical Model for the Calculation of the Adhesion of a Flame Sprayed Coating of Aluminum on S 235 JR Steel

In this work the method of response surfaces was used for the purpose of drawing up a mathematical model for the calculation (forecasting) of the adhesion of a flame sprayed coating of powdered aluminum on S 235 JR steel. Experimental work was conducted according to a fractional central-composite design at three levels. The adhesion of the coatings made with combinations of input parameters of the procedure according to the experiment plan mentioned is measured in line with the EN 582 standard. A mathematical model was derived describing the dependence of the experimentally obtained adhesion values on the input parameters of the procedure. The possibility of analyzing the influence of the parameters on the adhesion for a certain combination of input parameters has been presented with the use of perturbation plots.     

Substituted imino and amino derivatives of 4-hydroxycoumarins as novel antioxidant,antibacterial and antifungal agents: Synthesis and in vitro assessments

A series of imino and amino derivatives of 4-hydroxycoumarins were synthesised and evaluated for antioxidant potential, through different in vitro models such as (DPPH) free radical-scavenging activity, linoleic acid emulsion model system, reducing power assay and phosphomolybdenum method. Also, antimicrobial activity of obtained coumarins was evaluated against 13 bacteria and eight fungi. All prepared compounds possessed good antioxidant activity and among them a p-nitrophenol derivative with IC₅₀ at 25.9 μM possessed radical-scavenging activity which was comparable to BHT. Observed data for antibacterial activity indicated strong activity of all tested amino derivatives, while imines showed better antifungal properties.     

Identification of Secretory Compounds from the European Callipodidan Species <Emphasis Type="Italic">Apfelbeckia insculpta</Emphasis>

Defensive secretions of the callipodidan species Apfelbeckia insculpta contain a p-cresol as the main component and phenol in traces. This is the first identification of these compounds in a European callipodidan species. The repugnatory glands of A. insculpta are of the spirobolid type and consist of a spherical reservoir, a simple duct, and a valvular cuticular infolding that opens onto the lateral surface of the millipede via a pore.     

Chemical composition of currant seed extracts and their protective effect on human lymphocytes DNA

On the basis of LC/UV/MS analysis, 35 compounds from the extracts of seeds of black, red, and white currants (2 cultivars of each) were identified. Black currants cultivars contained protocatechuic acid and p-hydroxybenzoic acid, and traces of nitril containing phenolic acids. The presence of synapoyl glucoside was characteristic for cv. Malling Jewel. Sesquiterpenoid glycosides and carboxymethylindol glycosides were present mainly in white and red currant cultivars. Blackcurrant seeds contained higher amounts of flavonoids, especially rutin, isoquercetin, and taxifolin. The currant seed extracts were tested for in vitro protective effect on chromosome aberrations in peripheral human lymphocytes using cytochalasin-B blocked micronucleus (CBMN) assay. The frequency of MN was scored in binucleated cells, and the cultivars of black currants showed the best antioxidant potential. At a concentration of only 0.17 mg/mL, extract of the seed cv. Malling Jewel effected a decrease in the frequency of MN of 60% compared with control cell cultures. PRACTICAL APPLICATION: Our results provide evidence of protective effects of currant seed extracts and isolated pure compounds on cytogenetic damages in human lymphocytes. Thus, currant seed extracts could exert beneficial effects in quite a few diseases, for many of the biological actions have been attributed to their antioxidant properties.     

Optimization of bioprocess for production of copper-enriched biomass of industrially important microorganism Saccharomyces cerevisiae

The production of Saccharomyces cerevisiae cells enriched with copper and the effects of adding copper ions to different media on yeast cell growth and ethanol production were studied. In the media Cu(2+) concentrations of up to 0.094 mM had no effect on alcoholic fermentation, whereas higher Cu(2+) concentrations markedly decreased yeast cell growth rate and ethanol production. Under static conditions, the maximum amounts of copper uptake (i.e., 1.16 mg/g, 1.2 mg/g and 0.81 mg/g dry matter yeast biomass for glucose, sucrose and molasses media, respectively) were obtained after 8 h of fermentation, whereas under dynamic conditions smaller amounts of copper uptake (i.e., 0.98 mg/g, 1.02 mg/g and 0.7 mg/g dry matter yeast biomass for glucose, sucrose and molasses media, respectively) were obtained after 6 h of fermentation.