Numerical simulation model for exhaust gas transportation of dust in the BOF

During the BOF process for the production of crude steel, the specific amount of dust emitted is of the order of 2 % of the steel weight at turn down. The process gas conveys the dust through the boiler system into the primary and secondary dust catchers. The transportation of dust particles is influenced by blowing parameters; physical properties of process gas and of dust phases; and, type and layout of the converter and the filter system. In this work, a numerical simulation model is developed that simulates the pneumatic conveyance and sedimentation of primarily coarse dust particles in the BOF gas cleaning system. Comparison is then made of predicted coarse dust characteristics with values for dust sampled from an existing plant in order to verify the plausibility of the developed model.     

Heat transfer mechanisms in gas fluidized beds. Part 3: Heat transfer in circulating fluidized beds

Part 1 of this contribution reported on the effects of system properties on heat transfer between heating or cooling surfaces and bubbling fluidized beds. This investigation produced four correlations which define the respective maximum heat transfer. Part 2 of this study suggests that the heat transfer between exchanger surfaces and bubbling fluidized beds depends on superficial gas velocity, expressed as dimensionless excess gas velocity. The present paper shows that heat transfer coefficients in circulating fluidized beds can be predicted by evaluation of a state diagram, which combines three dimensionless groups: Nusselt number, Archimedes number and a dimensionless pressure gradient. A comparison of coal combustion experiments with own cold model measurements indicates that the radiative component of heat transfer coefficients is only evident at very low dimensionless pressure gradients.     

Autothermal two-stage gasification of low-density waste-derived fuels

In order to increase the efficiency of waste utilization in thermal conversion processes, pre-treatment is advantageous. With the Herhof Stabilat^® process, residual domestic waste is upgraded to waste-derived fuel by means of biological drying and mechanical separation of inerts and metals. The dried and homogenized waste-derived Stabilat^® fuel has a relatively high calorific value and contains high volatile matter which makes it suitable for gasification. As a result of extensive mechanical treatment, the Stabilat^® produced is of a fluffy appearance with a low density. A two-stage gasifier, based on a parallel-arranged bubbling fluidized bed and a fixed bed reactor, has been developed to convert Stabilat^® into hydrogen-rich product gas. This paper focuses on the design and construction of the configured laboratory-scale gasifier and experience with its operation. The processing of low-density fluffy waste-derived fuel using small-scale equipment demands special technical solutions for the core components as well as for the peripheral equipment. These are discussed here. The operating results of Stabilat^® gasification are also presented.     

FODA — the formal specification of ODA document structures and its use as a basis for conformance testing

The Office Document Architecture (ODA) is an International Standard which is developed by TC 97/sc 18 of the International Organization for Standardization (ISO) in close collaboration with CCITT's Study Group VIII and with ECMA. This paper describes the current state of a formal specification of the ODA document structures by mathematical means and its use for conformance specification and conformance testing.     

Near-wall porosity characteristics of fixed beds packed with wood chips

Packed beds of fuel wood chips are commonly found in thermal conversion processes such as combustion or gasification. Wood chips in particular are mostly used as fuel for small-scale domestic heating boilers but also for commercial-scale combustion units. The characterization of spatial voidage distribution inside the wood chip beds is of great importance for flow and reactor modelling. This study focuses on the radial porosity variations of cylindrical beds of three different types of commercially available wood chips including chips classified as G30 size class. The conventional technique of consolidating packed beds with a resin was chosen as the experimental procedure. The radial voidage distribution in different cylindrical beds is determined by image analysis of sections of the solidified packings. Additionally, a packing of monosized spheres was investigated in order to assess the selected procedure in comparison with widely available literature data for spheres. The results are discussed and summarized in a mathematical expression correlating the radial voidage distribution depending on average wood chip size, packing core porosity and dimensionless distance from the tube wall.