精轧油膜轴承密封失效机理的初步分析

对油膜轴承密封出现的进水、漏油现象作了大量的调查、测量和统计分析，找出了产生质量事故的根本原因，提出了解决措施。     

Direct measurement of single-molecule diffusion and photodecomposition in free solution

Continuous monitoring of submillisecond free-solution dynamics of individual rhodamine-6G molecules and 30-base single-stranded DNA tagged with rhodamine was achieved. Fluorescence images were recorded from the same set of isolated molecules excited either through the evanescent field at the quartz-liquid interface or as a thin layer of solution defined by micron-sized wires, giving diffraction-limited resolution of inter-connected attoliter volume elements. The single-molecule diffusion coefficients were smaller and the unimolecular photodecomposition lifetimes were longer for the dye-DNA covalent complex as compared with those of the dye molecule itself. Unlike bulk studies, stochastic behavior was found for individual molecules of each type, and smaller diffusion coefficients were observed.     

Synthesis and Crystal Structure of RE[CH_2(CH_2)_4CONC_4H_9]_3(NO_3)_3(RE=Dy,La)

ＳｙｎｔｈｅｓｉｓａｎｄＣｒｙｓｔａｌＳｔｒｕｃｔｕｒｅｏｆＲＥ［ＣＨ２（ＣＨ２）４ＣＯＮＣ４Ｈ９］３（ＮＯ３）３（ＲＥ＝Ｄｙ，Ｌａ）ＷａｎｇＨａｎｚｈａｎｇ（王汉章），ＸｕＱｉｎｇｆｅｎｇ（徐庆锋），ＱｉａｎＰｕ（钱朴）ＳｕｎＪｉａｎｐｉｎｇ（孙建...     

雁翎油田注氮气提高采收率工艺技术

在现有的提高采收率方法中,注气驱是应用较广、效果较好的方法,特别是注氮气驱由于其气源广泛、价廉经济、无腐蚀性,以及要求的油藏地质结构特征和原油的物理性质等因素的变化范围广泛等特产,这种提高采收率的方法应用的最为普及,代表了目前提高采收率的发展方向。结合雁翎油田实例,简要介绍了注氮气提高采收率的机理、注气井组建设、制氮工艺及注气后的采油完井方式、方法。     

乙烯基三甲基硅烷等离子体聚合反应历程

应用色谱—质谱(GC-MS)及裂解色谱-质谱(PGC-MS)测定了乙烯基三甲基硅烷等离子体聚合反应中的气体冷凝物及聚合物,研究推导了等离子体聚合反应历程。单体在气相中被电子撞击,然后扩散到基底,在基底发生链增长和链终止反应。     

On-line multiversion database concurrency control

This paper presents a new model for studying the concurrency vs. computation time tradeoffs involved in on-line multiversion database concurrency control. The basic problem that is studied in our model is the following: Given:a current database system state which includes information such as which transaction previously read a version from which other transaction; which transaction has written which versions into the database; and the ordering of versions previously written; anda set of read and write requests of requesting transactions. Question: Does there exist a new database system state in which the requesting transactions can be immediately put into execution (their read and write requests satisfied, or in the case of predeclared writeset transactions, write requests are guaranteed to be satisfied) while preserving consistency under a given set of additional constraints? (The amount of concurrency achieved is defined by the set of additional constraints). In this paper we derive “limits” of performance achievable by polynomial time concurrency control algorithms. Each limit is characterized by a minimal set of constraints that allow the on-line scheduling problem to be solved in polynomial time. If any one constraint in that minimal set is omitted, although it could increase the amount of concurrency, it would also have the dramatic negative effect of making the scheduling problem NP-complete; whereas if we do not omit any constraint in the minimal set, then the scheduling problem can be solved in polynomial time. With each of these limits, one can construct an efficient scheduling algorithm that achieves an optimal level of concurrency in polynomial computation time according to the constraints defined in the minimal set.     

单片机的显示接口电路设计

介绍了利用单片机的串、并行接口和专用显示接口 IC 设计显示接口电路的方法,并提供了4种动态和静态显示的硬件接口电路。     

The investigation of 32P wire for catheter-based endovascular irradiation

The dose distribution from a 32P source has been measured and calculated in order to evaluate its application in endovascular irradiation. The source dimension was 27 mm in length and 0.3 mm in diameter and was embedded in the end of a Ni-Ti wire. Dose measurements were performed using radiochromic film in several specially designed tissue equivalent phantoms. Loevinger's point dose kernel was used for the calculation. The approximate dose rate at a radial distance of 1.5 mm from the center of the source was found to be 6.75 cGy/s per GBq (0.25 cGy/s per mCi), which allows the delivery of a therapeutic dose in a short time interval with a satisfactory homogeneity without stepping the source. However, the dose rate falls off almost exponentially along the radial distance. Therefore it may not be suitable for treating large diameter vessel from a centrally located source. The effect of a curved 32P wire source on the radial dose distribution was also investigated. The results showed that for a maximum bend of 180 degrees the dose rate was increased by as much as 20% along the inner radial distance but decreased by as much as 20% along the outer radial distance compared to the dose along a straight wire. However, for curvatures normally encountered in a clinical situation, the dose rate was changed less than 5%.     

Influence of Lanthanum on Fluorescence Properties of Ag-BaO Thin Films

Ag-BaO thin films doped with lanthanum were prepared by vacuum deposition. Compared with the normal Ag-BaO thin film, there is almost no change with the shape and the peak site of the fluorescence spectrum; however, fluores-cence emission strength of the whole observation band(325 -600 nm)increases about 40%, and the increase of short wavelength range is more remarkable than that of long wavelength range, which we named “blue-stronger“ phenomenon. Analytic results show that, with the forming of intermetallic compounds between silver and lanthanum, the 4f-state energy levels lie just below the Fermi level within 5 eV. It is the energy exchange between the 4f energy levels and the conduction band that causes the increase effect of fluorescence emission, and it is the optical absorption cross section of 4f electron, which increases with the increase of energy of incidence photon, that gives rise to the “blue-stronger“ phenomenon.