The geometry effects for stress intensity factor of sandwich specimen for measuring interfacial fracture toughness

The interfacial stress intensity factors for three types of sandwich specimens: the single edge crack tensile specimen, the three point bend specimen and the four point shear specimen were obtained by the finite element analysis and compared with the asymptotic solutions. The results show that the geometric effect for mode II specimen is larger than mode I specimen. The limit curves for geometry factor equal to 1.05 were obtained to indicate the usable range of validity of the asymptotic solution.     

A Study of the Specific Heats of the Compounds in the Sm_2O_3-BaO-CuO System

By means of X-ray diffraction and adiabatic scanning calorimeter,the specific heatsof five compounds in the Sm_2O_3-BaO--CuO system,such as Sm_2BaO_4,Sm_2CuO_4,BaCuO_4,Sm_2BaCuO_5,SmBa_2Cu_3O_(7-x),from -150℃ to 800℃ have been measured.It is found that the specific heats ofthese compounds increase smoothly with the increase of temperature.     

淀积条件对GDa—SiNx薄膜电学特性的影响

本文讨论了用辉光放电法制备氮化硅薄膜时衬底温度、射频功率和气体流量比对薄膜的电导率、介电常数和击穿强度的影响。通过优化生长条件，制备了优质非晶氮化硅薄膜，其介电常数为７．５、击穿强度为５．５ＭＶ／ｃｍ、电导率为１０－１３（Ωｃｍ）－１。     

A quantum amplifier model for predicting temporal variations in theoutput power from a semiconductor laser on a picosecond time scale

A new model for simulating temporal fluctuations in the power emitted by a semiconductor laser is described. Light in the cavity is assumed to circulate in the form of traveling photon packets, in which the photon number fluctuates due to the processes of spontaneous emission, stimulated emission, absorption, scattering, and reflection. The dipole dephasing time T plays a critical role in modeling the interaction of the photon packets and gain medium. The Monte Carlo method is used to simulate the temporal behavior of a continuously pumped Fabry-Perot laser. The laser output power is found to exhibit periodic fluctuations at the cavity transit time frequency (longitudinal mode beat frequency). The amplitude of these fluctuations, as well as the relaxation oscillation, which occurs at a much lower frequency, is strongly influenced by the magnitude of T. The results of these simulations are related to the temporal behavior expected from a conventional FP laser     

固液相变蓄能的数学模型和自然对流换热系数的实验研究

引入自然对流换热系数 ,将固液蓄能数学模型简化为仅用能量方程加以描述。并通过实验测得相变过程的实际温度场 ,证明了自然对流固液相变换热的影响不可忽略 ,验证了固液相变界面移动速率随自然对流换热系数的增大而增大的定性关系     

偏振模色散统计特性的研究

利用动态方程研究了偏振模色散矢量的统计特性 ,分别用统计系综和频率系综两种方法进行数值模拟。数值结果表明 ,统计系综和频率系综两种方法的结果一致。在大归一化距离条件下 ,均方根时延的平方随归一化距离线性变化 ;偏振模色散矢量的各个分量服从高斯分布 ,差分群时延服从麦克斯韦分布 ;偏振模色散矢量弥散于整个邦加球     

起重搬运作业的安全风险分析

用安全系统的理论和方法 ,以起重作业为研究对象 ,通过危险识别 ,对造成人员损伤的危险事件发生的可能性和导致伤害后果的严重程度 ,进行了定性的风险分析 ,介绍了我国采取的针对性综合管理对策     

A new kind of compound solid-state quasi-optical power combiner

In this paper, a new kind of solid-state quasi-optical power combiner is presented. It consists of two or more singlecavity multiple-device power combiners and a Fabry-Perot cavity. The experimenal results using six Gunn diodes at X-band show that the total output power is higher than 400 mW, the total combining efficiency is as high as 83%, and the frequency stability is better than 10^?5.     

单模光纤的传输衰减随温度变化的研究

本文从实验上测量了单模石英光纤在－50～120℃范围内的损耗。随着温度升高，光纤的损耗随之降低，在常温附近达到最小。其后损耗随着温度的继续升高而增加。损耗的变化主要是由于杂质的吸收和微弯损耗。本文对杂质的吸收以及微弯损耗进行了数值模拟，并且从理论上定性地解释了损耗对温度的依赖关系。