Use of radial forces for fault detection in tapping

A model-based method for fault detection in tapping based on torque and radial forces is proposed. The method allows the identification of faults typical of a tapping operation including axial misalignment, tap runout, tooth breakage both singly and together. The validation experiments have been run on aluminum 356 workpieces for different combinations of process faults. Results have shown that the model predictions are in good agreement with the experimental radial force and torque signals under various fault conditions.     

纳米技术与“纳米涂料”之我见

概述了纳米技术、纳米材料、“纳米涂料”的现状 ,重点讨论了纳米技术在涂料中应用遇到的问题和建议措施 ,对纳米技术的科研方向及其在涂料中应用的发展提出了看法。     

中关村中心区水文地质及工程地质特征

本文全面、系统地分析了北京市中关村中心区的水文地质及工程地质特征 ,为该地区的工程建设提供可靠的地质资料     

电站锅炉制粉系统的爆炸原因与防范对策

火力发电厂制粉系统爆炸事故时有发生 ,重大设备损坏 ,造成了严重的经济损失。本文通过分析研究 ,找出制粉系统爆炸的原因 ,从措施上、煤的质量控制上及制粉系统结构改造上提出了防范的对策。     

Influence of ethyl methacrylate content on the volume‐phase transition of temperature‐sensitive poly[(N‐isopropylacrylamide)‐co‐(ethyl methacrylate)] microgels

A novel series of temperature‐sensitive poly[(N‐isopropylacrylamide)‐co‐(ethyl methacrylate)] (p(NIPAM‐co‐EMA)) microgels was prepared by the surfactant‐free radical polymerization of N‐isopropylacrylamide (NIPAM) with ethyl methacrylate (EMA). The shape, size dispersity and volume‐phase transition behavior of the microgels were investigated by transmission electron microscopy (TEM), ultraviolet–visible (UV–Vis) spectroscopy, dynamic light scattering (DLS) and differential scanning calorimetry (DSC). The transmission electron micrographs and DLS results showed that microgels with narrow distributions were prepared. It was shown from UV–Vis, DLS and DSC measurements that the volume‐phase transition temperature (VPTT) of the p(NIPAM‐co‐EMA) microgels decreased with increasing incorporation of EMA, but the temperature‐sensitivity was impaired when more EMA was incorporated, causing the volume‐phase transition of the microgels to become more continuous. It is noteworthy that incorporation of moderate amounts of EMA could not only lower the VPTT but also enhance the temperature‐sensitivity of the microgels. The reason for this phenomenon could be attributed to changes in the complicated interactions between the various molecules. Copyright © 2004 Society of Chemical Industry     

Delay Analysis of Interacting Queues with an Approximate Model

An approximate model of coupled Markov chains is proposed and analyzed for a slotted ALOHA system with a finite number of buffered nodes. This model differs from earlier ones in that it attempts to capture the interdependence between the nodes. The analytical results lead to a set of equations that, when solved numerically, yield the average packet delay. Comparison between computational and simulation results for a small number of nodes show excellent agreement for most throughput values, except for values near saturation. Numerical comparisons for a two-node system show that a nonsymmetric loading of the system provides better delay-throughput performance than a symmetric one.     

A new polysilicon CMOS self-aligned double-gate TFT technology

In this paper, a new polysilicon CMOS self-aligned double-gate thin-film transistor (SA-DG TFT) technology is proposed and experimentally demonstrated. The self-alignment between the top- and bottom-gate is realized by a backlight exposure technique. The structure has an ultrathin channel region (300 /spl Aring/) and a thick source/drain region. Experimental results show that this technology provides excellent current saturation due to a combination of the effective reduction in the drain field and the full depletion of the ultrathin channel. Moreover, for n-channel devices, the SA-DG TFT has a 4.2 times higher on-current (V/sub gs/=20V) as compared to the conventional single-gate TFT. Whereas for the p-channel devices, the SADG TFT has a 3.6 times higher on-current (V/sub gs/=-20V) compared to the conventional single-gate device.     

A subspace detection method of analog space-time codes for multiantenna ultra-wideband transmissions

In this letter, we propose a subspace based detection method for space-time block codes (STBC) wedded with ultra-wideband (UWB) transmissions. Without the need of channel information, the proposed algorithm yields the estimation of transmitted symbols by minimizing some quadratic form built on the orthogonality between signal and noise subspaces. Simulations in flat-faded application scenarios show that the subspace method can achieve the same diversity and a loss of about 2 dB at the 10/sup -3/ level with more than four successive space-time codes being decoded jointly, compared to the coherent decoding algorithm.     

End-to-End QoS for Video Delivery Over Wireless Internet

Providing end-to-end quality of service (QoS) support is essential for video delivery over the next-generation wireless Internet. We address several key elements in the end-to-end QoS support, including scalable video representation, network-aware end system, and network QoS provisioning. There are generally two approaches in QoS support: the network-centric and the end-system centric solutions. The fundamental problem in a network-centric solution is how to map QoS criterion at different layers respectively, and optimize total quality across these layers. We first present the general framework of a cross-layer network-centric solution, and then describe the recent advances in network modeling, QoS mapping, and QoS adaptation. The key targets in end-system centric approach are network adaptation and media adaptation. We present a general framework of the end-system centric solution and investigate the recent developments. Specifically, for network adaptation, we review the available bandwidth estimation and efficient video transport protocol; for media adaptation , we describe the advances in error control, power control, and corresponding bit allocation. Finally, we highlight several advanced research directions.     

Craze yielding and fracture mechanism in PE/PS/PE laminated films

The change in polystyrene (PS) layer thickness, which has been simultaneously determined during post-yield deformation, shows that crazing is the basic mechanism of toughening in all laminated films, and that shear deformation supplements the contribution of crazing especially for samples with high polyethylene (PE) volume fractions. Crazes formed in PS layers in the laminated films are slender and regular compared with the short and lenticular crazes formed in bulk PS film. When PE volume fraction increased, craze advance speed decreased because of the reduction of the stress concentration effect at craze tips. The life-time of the first mature craze to be formed at a given strain rate increased with PE volume fraction because the PE supporting the mature crazes could effectively inhibit craze rupture and blunt out the propagating crack by absorbing the stored elastic energy in the PS layer that would have been dissipated as fracture surface energy.