Use of Double Wash-Coatings of Platinum and Zeolite Catalysts to Improve Selective Reduction of NOx by Hydrocarbons

The selective catalytic reduction by hydrocarbons (HC-SCR) of NO _x under lean conditions has been improved by the use of double-layered catalysts with a lower layer of Pt/SiO₂ and an upper layer of a zeolite such as H-, Ce-, and Cu-ferrierite (-FER). H-FER wash-coated over Pt/SiO₂ (H-FER//Pt/SiO₂) performed best among the samples examined. The promotional effect was attributed to the synergy of the oxidation catalyst (Pt/SiO₂) in converting NO into NO₂, which is more reactive to C₃H₆, and the HC-SCR catalyst (H-FER). Cu-FER//Pt/SiO₂ was also effective at widening the temperature window, but with this combination the performance was attributed to a simple summation of the activity of two HC-SCR catalysts that were active at different temperatures.     

采用Ni—Cr合金热喷涂延长连铸结晶器寿命

三岛光产所开发的Ni-Cr合金热喷涂结晶器,是通过对连铸结晶器表面喷涂Ni-Cr合金涂层,使其寿命达到原来镀Ni结晶器的3-6倍,本文介绍Ni-Cr合金热喷涂结晶器的特性、使用效果和使用上的注意点。     

金属有机物分解法制备的La0.67Ca0.33MnOz薄膜的磁输运特性

利用金属有机物分解法在石英衬底上制备了多晶La0.67Ca0.33MnOx薄膜。研究了薄膜输运特性及其与温度的关系,发现薄膜的金属－半导体转变温度Tp(约172K）远低于其居里温度（约247K）;在平行于膜面的1T磁场下,77K－302K温度范围内,没有磁电阻（MR）峰,而是在Tp温度以下,有一宽的平台,平台处MR值约为21％－24％,在Tp温度以上,MR随温度上升而迅速降低;在77K温度上,薄膜具有显著的低场磁电阻效应。上述磁输运特性与载流子在晶界附近的输运行为如强的自旋相关散射和晶粒间自旋极化隧道效应等有关。在77K温度下,还观察到退磁效应引起的磁电阻垂直各向异性。     

Purification and properties of extracellular chitinases from the parasitic fungus Isaria japonica

Two chitinases (P-1 and P-2) induced with colloidal chitin were purified from the culture supernatant of Isaria japonica by chromatography on DEAE Bio-Gel, chromatofocusing and gel filtration with Superdex 75 pg. The enzymes were electrophoretically homogeneous and estimated to have a molecular mass of 43,273 (±5) for P-1 and 31,134 (±6) for P-2 by MALDI-MS. The optimum pH and temperature was 3.5–4.0 and 50°C for P-1 and 4.0–4.5 and 40°C for P-2. P-1 acted against chitosan 7B (degree of deacetylation, 65–74%) = glycol chitin> colloidal CHITIN = chitosan 10B (degree of deacetylation, above 99%) and P-2 against chitosan 7B> glycol CHITIN = chitosan 10B> colloidal chitin in order of activity. The products of hydrolysis of chitin and chitosan hexamer were analyzed by MALDI-MS. The products from the chitin hexamer obtained with P-1 were almost all dimers with only a small amount of trimer whereas those obtained with P-2 were mainly trimers with some dimer and tetramer. No hydrolysis of chitosan hexamer was observed. High homology in the amino-terminal sequence for chitinase P-1 was exhibited by chitinases from Trichoderma harzianum, Candida albicans and Saccharomyces cerevisiae in the range of 48–39%. The highest homology for Chitinase P-2 was shown by an endochitinase from Metarhizium anisopliae of 66%, while 44% homology was exhibited by chitinases of Leguminosae plants.     

Damage to and recovery of coastlines polluted with C-heavy oil spilled from the Nakhodka

The damage to and recovery of the Japanese coastline from Suzu, Ishikawa Prefecture to Mikuni, Fukui Prefecture was investigated visually over three years after a C-heavy oil spill from the Russian tanker "Nakhodka" in the Japan Sea on January 2, 1997. The beached C-heavy oil tended to remain for a long time on coasts of bedrock and boulder/cobble/pebble but it was removed rapidly from coasts of gravel/sand and man-made structures such as concrete tetrapods. On the coasts of the latter type, wave energy appeared to be the main force removing the oil. One year after the spill, C-heavy oil tended to remain strongly on the sheltered coasts of bedrock and boulder/cobble/pebble. Even on coasts of this type, the contamination was remarkably absent by 2 years after the spill. The concentration levels of polycyclic aromatic hydrocarbons (PAHs) in oil lumps, sand and seawater were monitored during 3 years following the spill. The concentrations of PAHs having 2 or 3 rings decreased more quickly than did those of PAHs having 4 or more rings, suggesting that volatilization was the main cause of the decrease. On the other hand, the concentrations of PAHs having 4 to 6 rings did not start to decrease until 7 months after the spill. The main cause of the decrease seemed to be photolysis. The concentration of BaP in seawater off the polluted coasts was high 1 month after the spill and then decreased. Three years after the spill, the level fell to the sub ng/L level, which was as low as the level in seawater along unpolluted clean coasts in Japan. The concentration of BaP in greenling was higher than the normal level only during the first two months after the spill. These results suggest that the coastlines in Ishikawa and Fukui Prefectures that were polluted with C-heavy oil recovered in 3 years.     

Accumulation of uranium derived from long-term fertilizer applications in a cultivated Andisol

The U concentrations in the soils of experimental fields with continuous fertilizer applications and in neighboring non-agricultural soils were determined. The surface soils in the three experimental fields with fertilizer applications contained higher amounts of U compared with the non-agricultural surface soils. The amount of U elevated in the soil was estimated by the vertical profile of U concentration, and an increase of about 200 mg m-2 of U was found in the soils at 0-35 cm depth during a 61-year cultivation period. The estimated value was almost the same as the amount of U added through the fertilizers as calculated from U concentrations in the applied fertilizers. Therefore, almost all the U from the fertilizers would still remain in the upper part of the soils. Chemical extraction results suggested that organic substances and noncrystalline clay minerals in the surface soil should play an important role for accumulation of U derived from the fertilizers.     

A new method for evaluating biological safety of environmental water with algae, daphnia and fish toxicity ranks

In this study, an innovative approach to evaluate biological safety of environmental water with toxicity ranks was proposed. Widely used species, algae (Selenustrum capricornutum), daphnia (Daphnia magna) and fish (Oryzias latipes larvae) belonging to three trophic levels in aquatic ecosystem, were selected and combined as a test set to measure the bio-toxicity of water sample. Maximum exposure concentrations for algae, daphnia and fish test were respectively designed as 10-, 50- and 50-fold of river water based on a simplification of conventional toxicity extrapolation method EU Directive EEC/93/67. A novel assessment index "safety score" of 1, 2, 3 and 4 with 1 being the safest was established for normalizing the toxicity effects. Safety score was determined according to the highest exposure concentration where adverse ecotoxicological effects could not be observed, and a triangle figure was designed to visually describe the safety scores of three toxicity tests. Finally, in order to conveniently evaluate the biological safety of environmental water, an integrated assessment index "bio-safety rank" (BSR) was established and determined according to the safety scores of the three tests, and with the index BSR, water sample could be ranked as A, B, C or D with A being the safest. It was shown that the proposed new method was effective for screening and evaluating the biological safety of river water in case studies.     

Manganese doped gallium oxynitride prepared by nitridation of citrate precursor

Manganese doping of gallium oxynitride was investigated to obtain a magnetic semiconductor by nitriding a precursor in ammonia flow. The precursor was obtained by prefiring a mixed gel made of Mn²⁺ and Ga³⁺ nitrates and citric acid in aqueous solution. The products were isostructural with hexagonal GaN. The doping limit was 10 and 5 at% in the samples nitrided at 750 and 850 °C, respectively. Chemical analysis of the products suggested that they were manganese doped gallium oxynitrides. Oxide and nitride ions were randomly distributed in the anion sites in the latter product. Manganese oxide cluster might be formed in the former. The product nitrided at 850 °C showed an antiferromagnetic interaction with a Weiss temperature θ = −38 K, while the product nitrided at 750 °C was paramagnetic.     

Collection efficiency of cylindrical and elliptic cyclone dust collectors with vortex breaker

IntroductionUntil now there are many papers concerning thecollection efficiency and the cut-size Xo for thereturned type, axial type and also rotary flow typesof the cyclone dust collectors[1'2'3'4]. The crosssection of these cyclones is the circular cylindricalbody. One of the main reasons for the circularsection is that the flow control on the threedimensional turbulent rotational flow becomeseasy and also the movement of the solid particlesalong the concave wall surface becomes smooth. Sot…