Impact fracture behavior of ethylene ionomer and structural change after stretching

We carried out tensile impact test and very low speed tensile test on ethylene‐based Ionomers (E/15wt %MAA) to clarify the relation between impact toughness and high‐ordered structure. We also studied the changes in high‐ordered structure under deformation by observing Differential Scanning Calorimetory (DSC) and Small‐Angle X‐ray Scattering (SAXS) of fractured surface. Na Ionomers showed ductile fracture in both high speed tensile impact (3 m/s) and very low speed tensile (2 mm/min). The disappearance of secondary melting point (Ti) in Na Ionomers was due to the destruction of ordered structure surrounding the ionic aggregate. Similar behavior was observed in 60% (or less) neutralized Zn Ionomers. However, 80% neutralized Zn Ionomer showed brittle failure in high‐speed tensile impact, and Ti did not disappear. SAXS studies of Na and Zn Ionomers after fracture, show no change both after molding (no aging) and after aging. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 81: 1712–1720, 2001     

Thermodynamic Properties of Ionic Semiclathrate Hydrate Formed with Tetrabutylammonium Propionate

The phase equilibrium temperature and dissociation heat of tetrabutylammonium propionate (TBAPr) hydrate are reported. TBAPr hydrate is a type of ionic semiclathrate hydrates and also could potentially be used as thermal energy storage material. The temperature‐composition phase diagram of the TBAPr hydrate was determined in a defined range of mass fractions. Considering the dissociation heat of differential scanning calorimetry (DSC) measurements, multiple peaks of heat flow were observed in the TBAPr‐water system at the TBAPr mass fraction lower than 0.35, and there was a single peak at the mass fraction higher than 0.37.     

Oral Secretions Affect HIPVs Induced by Generalist (<Emphasis Type="Italic">Mythimna loreyi</Emphasis>) and Specialist (<Emphasis Type="Italic">Parnara guttata</Emphasis>) Herbivores in Rice

Plants synthesize variable mixtures of herbivore-induced plant volatiles (HIPVs) as part of their evolutionary conserved defense. To elucidate the impact of chewing herbivores with different level of adaptation on HIPV profiles in rice, we measured HIPVs released from rice seedlings challenged by either the generalist herbivore Mythimna loreyi (MYL) or the specialist Parnara guttata (PAG). Both herbivores markedly elicited the emission of HIPVs, mainly on the second and third days after attack compared to control plants. In addition, side-by-side HIPV comparisons using MYL and PAG caterpillars revealed that generalist feeding induced comparably more HIPVs relative to specialist, particularly on day two as highlighted by multivariate analysis (PLS-DA) of emitted HIPVs, and further confirmed in mimicked herbivory experiments. Here, mechanically wounded plants treated with water (WW) released more VOCs than untreated controls, and on top of this, oral secretions (OS) from both herbivores showed differential effects on volatile emissions from the wounded plants. Similar to actual herbivory, MYL OS promoted higher amounts of HIPVs relative to PAG OS, thus supporting disparate induction of rice indirect defenses in response to generalist and specialist herbivores, which could be due to the differential composition of their OS. (196 words).     

Pilot-Scale Operation of a Concrete Sludge Recycling Plant and Simultaneous Production of Calcium Carbonate

A pilot-scale plant to treat concrete sludge and produce calcium carbonate (CaCO₃) and an environmental purification agent (phosphorus adsorbent derived from concrete sludge, PAdeCS®) was designed, constructed, and operated. Concrete sludge from a concrete pile and pole production plant, boiler gas containing CO₂, and groundwater were used in the plant. The process involved calcium extraction from concrete sludge into water, followed by reaction of the calcium with CO₂ to produce crystalline CaCO₃. The pilot-scale plant was operated for 1 week, and the mass flows, conversion of CO₂ to CaCO₃, and net CO₂ emissions of the process were estimated. High-purity CaCO₃ (>97%) suitable for industrial use was obtained. Based on the power consumption of the process and the amount of CO₂ sequestered into CaCO₃, a net reduction in CO₂ emissions can be achieved using this process. The produced PAdeCS can be used as an inexpensive substitute for calcium series environmental purification agents.     

Acceleration of the Rate of Silver Nanoparticle Formation Using Microbubbles in a Sonochemical Process

The effect of the addition of microbubbles on the formation of silver nanoparticles produced in an ultrasonic radiation-mediated process was investigated. The addition of microbubbles with an area-based median diameter of 26.0?µm and a bubble volume density of 0.18?cm³/L significantly increased the silver nanoparticle formation rate during the sonochemical process. The size distribution of the silver nanoparticles was largely unaffected by the addition of the microbubbles. The influence of changes in the microbubble volume density on the formation of the silver nanoparticles was also investigated; it was confirmed that the rate of formation of the silver nanoparticles increased moderately with increasing volume density. The gradient in absorption spectra was approximately 30 times larger for the case when microbubbles (median diameter: 28.3?µm) were added at 0.74?cm³/L, compared with the case without microbubbles. The results suggested that the microbubbles provided reaction sites similar to cavitation bubbles in the ultrasonic reaction.     

Grazing-incidence wide-angle X-ray diffraction study on molecular aggregation state of imprinted polyimide film before and after hard baking

Nanoimprint lithography (NIL) was carried out on precursor of polyimide (PI), poly(amic acid) film, and then hard baking to obtain imprinted PI film. The molecular aggregation states of imprinted PI films before and after hard baking were investigated by grazing-incidence wide-angle X-ray diffraction comparing with the one of flat PI film. It was found that NIL and hard baking can strongly affect the molecular aggregation states of PI film. Before hard baking, PI chain is aligned parallel to the line direction on the line. After hard baking, the alignment in ordered domain was changed to that the PI molecule of which chain axis is perpendicular to the line direction is significantly increased, while, PI molecule of which chain axis is parallel to the line direction is decreased after hard baking. Through comparing with the flat PI, crystallinity of imprinted PI film has been significantly enhanced.     

Increased Lipid Synthesis and Decreased β-Oxidation in the Liver of SHR/NDmcr-cp (cp/cp) Rats, an Animal Model of Metabolic Syndrome

SHR/NDmcr-cp (cp/cp) rats (SHR/NDcp) are an animal model of metabolic syndrome. A previous study of ours revealed drastic increases in the mass of palmitic (16:0), oleic (18:1n-9), palmitoleic (16:1n-7), cis-vaccenic (18:1n-7) and 5,8,11-eicosatrienoic acids in the liver of SHR/NDcp. However, detailed information on the class of lipid accumulated and the mechanism responsible for the overproduction of the accumulated lipid in the liver was not obtained. This study aimed to characterize the class of lipid accumulated and to explore the mechanism underlying the lipid accumulation in the liver of SHR/NDcp, in comparison with SHR/NDmcr-cp (+/+) (lean hypertensive littermates of SHR/NDcp) and Wistar Kyoto rats. In the liver of SHR/NDcp, de novo synthesis of fatty acids (16:0, 18:1n-9 and 16:1n-7) and triacylglycerol (TAG) synthesis were up-regulated and fatty acid β-oxidation was down-regulated. These perturbations of lipid metabolism caused fat accumulation in hepatocytes and accumulation of TAG, which were enriched with 16:0, 18:1n-9 and 16:1n-7, in the liver of SHR/NDcp. On the other hand, no changes were found in hepatic contents of diacylglycerol and unesterified fatty acid (FFA); among FFA, there were no differences in the hepatic concentrations of unesterified 16:0 and stearic acid between SHR/NDcp and two other groups of rats. Moreover, little change was brought about in the expression of genes responsive to endoplasmic reticulum stress in the liver of SHR/NDcp. These results may reinforce the pathophysiological role of stearoyl-CoA desaturase 1 and fatty acid elongase 6 in the liver of SHR/NDcp.     

An Engineered Biocatalyst for the Synthesis of Glycoconjugates: Utilization of β1,3‐N‐Acetyl‐D‐glucosaminyltransferase from Streptococcus agalactiae Type Ia Expressed in Escherichia coli as a Fusion with Maltose‐Binding Protein

A fusion protein composed of β1,3‐N‐acetyl‐D ‐glucosaminyltransferase (β1,3‐GlcNAcT) from Streptococcus agalactiae type Ia and maltose‐binding protein (MBP) was produced in Escherichia coli as a soluble and highly active form. Although this fusion protein (MBP‐β1,3‐GlcNAcT) did not show any sugar‐elongation activity to some simple low‐molecular weight acceptor substrates such as galactose, Galβ(1→4)Glc (lactose), Galβ(1→4)GlcNAc (N‐acetyllactosamine), Galβ(1→4)GlcNAcβ(1→3)Galβ(1→4)Glc (lacto‐N‐tetraose), and Galβ(1→4)GlcβCer (lactosylceramide, LacCer), the multivalent glycopolymer having LacCer‐mimic branches (LacCer mimic polymer, LacCer primer) was found to be an excellent acceptor substrate for the introduction of a β‐GlcNAc residue at the O‐3 position of the non‐reducing galactose moiety by this engineered enzyme. Subsequently, the polymer having GlcNAcβ(1→3)Galβ(1→4)Glc was subjected to further enzymatic modifications by using recombinant β1,4‐D ‐galactosyltransferase (β1,4‐GalT), α2,3‐sialyltransferase (α2,3‐SiaT), α1,3‐L ‐fucosyltransferase (α1,3‐FucT), and ceramide glycanase (CGase) to afford a biologically important ganglioside; Neu5Aα(2→3)Galβ(1→4)[Fucα(1→3)]GlcNAcβ(1→3)Galβ(1→4)GlcCerα(IV3Neu5Acα,III3Fucα‐nLc4Cer) in 40% yield (4 steps). Interestingly, it was suggested that MBP‐β1,3‐GlcNAcT could also catalyze a glycosylation reaction of the LacCer mimic polymer with N‐acetyl‐D ‐galactosamine served from UDP‐GalNAc to afford a polymer carrying trisaccharide branches, GalNAcβ(1→3)Galβ(1→4)Glc. The versatility of the MBP‐β1,3‐GlcNAcT in the practical synthesis was preliminarily demonstrated by applying this fusion protein as an immobilized biocatalyst displayed on the amylose resin which is known as a solid support showing potent binding‐affinity with MBP.     

The surface condition effect of Cu2O flower/grass-like nanoarchitectures grown on Cu foil and Cu film

Cu₂O flower/grass-like nanoarchitectures (FGLNAs) were fabricated directly on two category specimens of Cu foils and Cu film using thermal oxidation method. The FGLNAs are approximately 3.5 to 12 μm in size, and their petals are approximately 50 to 950 nm in width. The high compressive stress caused by a large oxide volume in the Cu₂O layer on the specimen surface played an important role in the growth of FGLNAs. The effects of surface conditions, such as the surface stresses, grain size, and surface roughness of Cu foil and Cu film specimens, on the FGLNA growth were discussed in detail.

PACS

81. Materials science; 81.07.-b Nanoscale materials and structures: fabrication and characterization; 81.16.Hc Catalytic methods