Influence of high titers of maternal antibody on the serologic response of infants to diphtheria vaccination at three, five and twelve months of age

Diphtheria antitoxin was determined in serum from 44 pregnant women, of whom 26 had received one injection of diphtheria toxoid during pregnancy. Their infants were vaccinated with a combined diphtheria-tetanus vaccine at 3, 5 and 12 months of age. This vaccination schedule has been used in Sweden since 1986, replacing the old schedule of vaccination at 3, 4.5 and 6 months of age originally designed for diphtheria-tetanus-pertussis vaccine, which had not been used after cessation of general vaccination against pertussis in 1979. Serum samples from the infants were obtained at 3, 7 and 18 months of age. After 2 injections infants of mothers with high antitoxin titers, > or = 0.1 IU/ml, tended to have lower antitoxin titers than infants of mothers with low antitoxin concentrations (P = 0.067). All children had, however, antitoxin above the minimum protective level of 0.01 IU/ml. Median antitoxin titers were 1.6 IU/ml in both groups after the third booster injection. Four infants of mothers who had been vaccinated during pregnancy and who had titers of > or = 0.4 IU/ml did not reach the 0.1 IU/ml level after 2 injections: all 4 responded with high antitoxin titers after the third dose. Thus all infants were primed by 2 doses of vaccine, irrespective of maternal antibody concentration. The repressive effect of maternal antibody on titers noted after 2 doses was no longer observed after the third, booster dose.     

Effect of grain refinement on the fluidity of two commercial Al-Si foundry alloys

The effect of grain refinement on the fluidity of AlSi7Mg and AlSi11Mg has been investigated by spiral tests. Two different types of grain refiners have been evaluated. An AlTi5Bl master alloy was added to different Ti contents. Since the commercial alloys had a high initial content of titanium, model alloys were made to investigate the fluidity at low grain refiner additions. Commercial alloys grain refined only by boron additions have also been investigated. The results from the fluidity measurements have been verified by measuring the dendrite coherency point of the different cast alloys. Although different, the two methods show similar trends. The spirals from each fraction grain refiner cast were subsequently investigated metallographically at the tip of the spirals and at a reference point a distance behind, but no obvious difference in structure was observed. For both alloys, an increase in fluidity is observed as the content of grain refiner increases above 0.12 pct Ti, while the fluidity is impaired with increased grain refinement below 0.12 pct Ti. The alloys grain refined with ~0.015 pct B show the highest fraction solid at dendrite coherency, the smallest grain size, and the best fluidity.     

The Danish Twin Apartment Study – Part II: Mathematical modeling of the relative strength of sources of indoor air pollution

Abstract This study deals with the modeling of air pollution in apartments from laboratory measurements of source strengths, using formaldehyde and Total Volatile Organic Compounds (TVOCs) as model pollutants. The sources in two test apartments were grouped into two: building-related sources and occupant-related sources. The measured source strengths and ventilation rates were used for the prediction of concentrations expected in the apartments. These predictions were compared to measurements in the apartment over 12 months. The conclusions were that the model predictions based on emission rates measured in the laboratory can be used to predict the long-term concentration of the two model pollutants in the apartments. Considering the measured differences in ventilation between the apartments, an occupant emission rate of between 0.2 and 0.3 mg/h/kg body weight could be estimated. Based on previous suggested limits of acceptable exposures of humans to VOCs, an acceptable average emission rate of VOCs from building materials in general was estimated to be about 30 (μ/m²/h. The modeling showed that during the first 200 days, building materials dominated the emissions. After this, sources relating to the occupants dominated. On average about half of the VOC pollution originated from the building materials.     

Simulating Ramsey-Type Fringes in a Pulsed Microwave-Driven Classical Josephson Junction

We present evidence for a close analogy between the nonlinear behaviour of a pulsed microwave-driven Josephson junction at low temperature and the experimentally observed behaviour of Josephson systems operated below the quantum transition temperature under similar conditions. We specifically address observations of Ramsey-type fringe oscillations, which can be understood in classical nonlinear dynamics as results of slow transient oscillations in a pulsed microwave environment. Simulations are conducted to mimic experimental measurements by recording the statistics of microwave-induced escape events from the anharmonic potential well of a zero-voltage state. Observations consistent with experimentally obtained Ramsey-type oscillations are found in the classical model. An erratum to this article can be found at     

Parameter estimation using a sensor array in a Ricean fading channel

The estimation of the Direction-Of-Arrival (DOA) and the variance of the angular spread, using an array of sensors in the case of a Ricean channel is considered, using the Maximum-Likelihood, Least-Squares and Weighted Least Squares criteria. The Cramér-Rao bound is also obtained for the problem of interest. Simplification of the cost functions to reduce the dimension of the problem has been carried out and the performance of the methods has been studied based on numerical experiments. A major part of the work was carried out when K V S Hari was visiting the Department of Signals, Sensors and Systems during Jul–Sep 1995, on leave from the Indian Institute of Science     

A Comparison of Presentation Methods for Reading on Mobile Phones

A study compares two methods of reading text-based content on mobile phones: traditional scroll-based reading and Rapid Serial Visual Presentation, which displays words rapidly in a sequence. University students used a prototype called Feedo to test both methods, and their reading comprehension, efficiency, and preference ratings were measured. The results show that efficiency increases with fast RSVP, comprehension is equal, and preference rating is lower than with self-paced scroll.     

Separation of the enantiomers of ibuprofen and its major phase I metabolites in urine using capillary electrophoresis

This report describes a simple, rapid, automated microassay for measuring in vitro changes of oxidative burst of phagocytes following challenge with metals for orthopedic devices. The production of reactive oxygen species (ROS) by polymorphonuclear leukocytes (PMNs) was measured using 2',7'-dichlorofluorescin-diacetate (DCFH-DA) as fluorescent probe. DCFH-DA enters the cells and is oxidized by ROS to fluorescent DCF. The DCF generated was directly proportional to ROS produced intracellularly: The fluorescence intensity was read and converted to an index of ROS production by cells. In our experimental system, granulocytes (PMNs) were isolated from normal human blood and seeded in microplates. To verify if metals could influence ROS production, chromium, cobalt, nickel, molybdenum, titanium, aluminum, and vanadium prepared as aqueous extracts in phosphate-buffered saline were tested onto PMNs using phorbolmyristate acetate (PMA) as positive control. Molybdenum, aluminum, and vanadium increased ROS generation by PMNs, while signals not different from unstimulated PMNs were recorded for chromium, cobalt, nickel, and titanium. The DCFH-DA microplate-based assay provides an in vitro tool for the detection of oxygen-reactive species generated by PMNs as a response to metals.