Characterization of silicon oxynitride films using ion beam analysis techniques

Heavy-ion elastic recoil detection analysis (HIERDA) is the ideal technique for quantitative analysis of silicon oxynitride films on silicon because of its unique ability to measure simultaneously all elements of interest (i.e., H, C, N, O and Si), thereby permitting key parameters such as the O/N-ratio to be determined in a single measurement. However, high-energy accelerators suitable for such HIERDA measurements are becoming much less readily available. Hence, the present paper investigates and calibrates an alternative IBA technique for simultaneous O, N and C analysis – namely, the use of (d,p) and (d,) nuclear reactions. Under optimum analysis conditions (850 keV deuterons and 150° detector angle), the Si background level sets a lower detection limit of 1×10¹⁶ nitrogen atoms/cm² and 3×10¹⁵ oxygen atoms/cm². H analysis is carried out separately, using low-energy ERDA and a 2 MeV ⁴He beam. Absolute cross-sections have been obtained for each of the (d,p) and (d,) groups. Comparison with data in the recent Handbook of Modern Ion Beam Materials Analysis shows reasonable agreement (10–15%) for the (d,p) reactions on oxygen and carbon. However, in the case of nitrogen, the measured cross-section values are 70% larger than the Handbook data. Several silicon oxynitride samples have been analyzed, first at UWO using 850 keV deuterons, and subsequently at ANU using HIERDA and a 200 MeV Au beam. The resulting O/N-ratios agree to within 10%. The relative importance of radiation damage effects is briefly discussed.     

Premarin Reduces Neurodegeneration and Promotes Improvement of Function in an Animal Model of Spinal Cord Injury

Spinal cord injury (SCI) causes significant mortality and morbidity. Currently, no FDA-approved pharmacotherapy is available for treating SCI. Previously, low doses of estrogen (17β-estradiol, E2) were shown to improve the post-injury outcome in a rat SCI model. However, the range of associated side effects makes advocating its therapeutic use difficult. Therefore, this study aimed at investigating the therapeutic efficacy of Premarin (PRM) in SCI. PRM is an FDA-approved E2 (10%) formulation, which is used for hormone replacement therapy with minimal risk of serious side effects. The effects of PRM on SCI were examined by magnetic resonance imaging, immunofluorescent staining, and western blot analysis in a rat model. SCI animals treated with vehicle alone, PRM, E2 receptor antagonist (ICI), or PRM + ICI were graded in a blinded way for locomotor function by using the Basso–Beattie–Bresnahan (BBB) locomotor scale. PRM treatment for 7 days decreased post-SCI lesion volume and attenuated neuronal cell death, inflammation, and axonal damage. PRM also altered the balance of pro- and anti-apoptotic proteins in favor of cell survival and improved angiogenesis and microvascular growth. Increased expression of estrogen receptors (ERs) ERα and ERβ following PRM treatment and their inhibition by ER inhibitor indicated that the neuroprotection associated with PRM treatment might be E2-receptor mediated. The attenuation of glial activation with decreased inflammation and cell death, and increased angiogenesis by PRM led to improved functional outcome as determined by the BBB locomotor scale. These results suggest that PRM treatment has significant therapeutic implications for the improvement of post-SCI outcome.     

Facilitating GL13K Peptide Grafting on Polyetheretherketone via 1-Ethyl-3-(3-dimethylaminopropyl)carbodiimide: Surface Properties and Antibacterial Activity

In the present work, the antimicrobial peptide (AMP) of GL13K was successfully coated onto a polyetheretherketone (PEEK) substrate to investigate its antibacterial activities against Staphylococcus aureus (S. aureus) bacteria. To improve the coating efficiency, 1-ethyl-3-(3-dimethylaminopropyl)carbodiimide (EDC) was mixed with a GL13K solution and coated on the PEEK surface for comparison. Both energy-dispersive X-ray spectroscopy (EDX) and X-ray photoelectron spectroscopy (XPS) data confirmed 30% greater peptide coating on PEEK/GL13K-EDC than PEEK without EDC treatment. The GL13K graft levels are depicted in the micrograms per square centimeter range. The PEEK/GL13K-EDC sample showed a smoother and lower roughness (Rq of 0.530 µm) than the PEEK/GL13K (0.634 µm) and PEEK (0.697 µm) samples. The surface of the PEEK/GL13K-EDC was more hydrophilic (with a water contact angle of 24°) than the PEEK/GL13K (40°) and pure PEEK (89°) samples. The pure PEEK disc did not exhibit any inhibition zone against S. aureus. After peptide coating, the samples demonstrated significant zones of inhibition: 28 mm and 25 mm for the PEEK/GL13K-EDC and PEEK/GL13K samples, respectively. The bacteria-challenged PEEK sample showed numerous bacteria clusters, whereas PEEK/GL13K contained a little bacteria and PEEK/GL13K-EDC had no bacterial attachment. The results confirm that the GL13K peptide coating was able to induce antibacterial and biofilm-inhibitory effects. To the best of our knowledge, this is the first report of successful GL13K peptide grafting on a PEEK substrate via EDC coupling. The present work illustrates a facile and promising coating technique for a polymeric surface to provide bactericidal activity and biofilm resistance to medical implantable devices.     

Assessing support alternatives for longwall gateroads subject to changing stress

Longwall gateroad entries are subject to changing horizontal and vertical stress induced by redistribution of loads around the extracted panel. The stress changes can result in significant deformation of the entries that may include roof sag, rib dilation, and floor heave. Mine operators install different types of supports to control the ground response and maintain safe access and ventilation of the longwall face. This paper describes recent research aimed at quantifying the effect of longwall-induced stress changes on ground stability and using the information to assess support alternatives. The research included monitoring of ground and support interaction at several operating longwall mines in the U.S., analysis and calibration of numerical models that adequately represent the bedded rock mass, and observation of the support systems and their response to changes in stress. The models were then used to investigate the impact of geology and stress conditions on ground deformation and support response for various depths of cover and geologic scenarios. The research results were summarized in two regression equations that can be used to estimate the likely roof deformation and height of roof yield due to longwall-induced stress changes. This information is then used to assess the ability of support systems to maintain the stability of the roof. The application of the method is demonstrated with a retrospective analysis of the support performance at an operating longwall mine that experienced a headgate roof fall. The method is shown to produce realistic estimates of gateroad entry stability and support performance, allowing alternative support systems to be assessed during the design and planning stage of longwall operations.     

Thermophysical Properties of ZrB2 and ZrB2–SiC Ceramics

Thermophysical properties were investigated for zirconium diboride (ZrB₂) and ZrB₂–30 vol% silicon carbide (SiC) ceramics. Thermal conductivities were calculated from measured thermal diffusivities, heat capacities, and densities. The thermal conductivity of ZrB₂ increased from 56 W (m K)⁻¹ at room temperature to 67 W (m K)⁻¹ at 1675 K, whereas the thermal conductivity of ZrB₂–SiC decreased from 62 to 56 W (m K)⁻¹ over the same temperature range. Electron and phonon contributions to thermal conductivity were determined using electrical resistivity measurements and were used, along with grain size models, to explain the observed trends. The results are compared with previously reported thermal conductivities for ZrB₂ and ZrB₂–SiC.     

Ta2O5/Nb2O5 and Y2O3 Co-doped Zirconias for Thermal Barrier Coatings

Zirconia doped with 3.2–4.2 mol% (6–8 wt%) yttria (3–4YSZ) is currently the material of choice for thermal barrier coating topcoats. The present study examines the ZrO₂-Y₂O₃-Ta₂O₅/Nb₂O₅ systems for potential alternative chemistries that would overcome the limitations of the 3–4YSZ. A rationale for choosing specific compositions based on the effect of defect chemistry on the thermal conductivity and phase stability in zirconia-based systems is presented. The results show that it is possible to produce stable (for up to 200 h at 1000°–1500°C), single (tetragonal) or dual (tetragonal + cubic) phase chemistries that have thermal conductivity that is as low (1.8–2.8W/m K) as the 3–4YSZ, a wide range of elastic moduli (150–232 GPa), and a similar mean coefficient of thermal expansion at 1000°C. The chemistries can be plasma sprayed without change in composition or deleterious effects to phase stability. Preliminary burner rig testing results on one of the compositions are also presented.     

Satisfying America's Fruit Gap: Summary of an Expert Roundtable on the Role of 100% Fruit Juice

The 2015 to 2020 Dietary Guidelines for Americans (DGAs) recognize the role of 100% fruit juice in health and in helping people meet daily fruit recommendations and state that 100% fruit juice is a nutrient‐dense beverage that should be a primary choice, along with water and low‐fat/fat‐free milk. The DGAs note that children are consuming 100% fruit juice within recommendations (that is, 120 to 180 mL/d for children aged 1 to 6 y and 236 to 355 mL/d for children aged 7 to 18 y). Evidence shows that compared to nonconsumers, those who consume 100% fruit juice come closer to meeting daily fruit needs and have better diet quality. In children, 100% fruit juice is associated with increased intakes of nutrients such as vitamin C, folate, and potassium. When consumed within the DGA recommendations, 100% fruit juice is not associated with overweight/obesity or childhood dental caries and does not compromise fiber intake. Preliminary data suggest that polyphenols in some 100% fruit juices may inhibit absorption of naturally occurring sugars. Given its role in promoting health and in helping people meet fruit needs, experts participating in a roundtable discussion agreed that there is no science‐based reason to restrict access to 100% fruit juice in public health nutrition policy and programs such as the Special Supplemental Nutrition Program for Women, Infants, and Children (WIC). Reducing or eliminating 100% fruit juice could lead to unintended consequences such as reduced daily fruit intake and increased consumption of less nutritious beverages (for example, sugar‐sweetened beverages).     

Polybrominated diphenyl ethers in the sediments of the Great Lakes. 3. Lakes Ontario and Erie

Sediment cores were taken in 2002 in Lakes Ontario and Erie at four locations. A total of 48 sediment samples were characterized, dated using 210Pb, and analyzed for 10 congeners of polybrominated diphenyl ethers (PBDEs) including BDE209 as well as 39 congeners of polychlorinated biphenyls (PCBs). The surficial concentrations of nine tri- through hepta-BDE congeners (sigma9PBDE) are 4.85 and 6.33 ng g(-1), at sampling sites ON40 and ON30 in Lake Ontario, and 1.83 and 1.95 ng g(-1) at ER37 and ER09 in Lake Erie, respectively, based on dry sediment weight. The surficial BDE209 concentrations are 242 and 211 ng g(-1) at ON40 and ON30 and 50 and 55 ng g(-1) at ER37 and ER09. The sigma(9-) PBDEs fluxes to the sediment around 2002 are 147 and 195 pg cm(-2) year(-1) at ON40 and ON30 and 136 and 314 pg cm(-2) year(-1) at ER37 and ER09, respectively. The fluxes of BDE209 are 6.5 and 7.3 ng cm(-2) year(-1) at ON30 and ON40 and 3.7 and 8.9 ng cm(-2) year(-1) at ER37 and ER09, respectively. Dramatic increases in PBDE concentrations and fluxes upward toward the sediment surface and the present time are evident at both locations in Lake Ontario, while PCBs concentrations peak in the middle of sediment cores around the dated time of 1970s and 1960s. For both locations of Lake Erie, the increasing trends of both PBDEs and PCBs from the bottom to the surficial segments were distorted by sediment mixing. BDE209 is the most abundant congener among PBDEs in the sediments, constituting about 96 and 91% of the total PBDEs on mass basis in Lakes Ontario and Erie, respectively.