吸入短寿命氡子体动物肺组织剂量与体重关系的探讨

本文介绍吸入短寿命氡子体的不同种动物肺组织吸收剂量与体重的关系。实验结果表明,吸收剂量随体重的增加而减小。     

（1S，2S，5R）-薄荷基取代烯烃的合成

以(L)-薄荷基氯为原料,通过薄荷基氯化镁分别与烯丙基溴、2-甲基-3-氯丙烯、1-溴-3-甲基-2-丁烯在Cul催化下发生偶联反应,首次合成了3-(1S,2S,5R)-薄荷基-1-丙烯,2-甲基-3-(1S,2S,5R)-薄荷基-1-丙烯和2-甲基-4-(1S,2S,5R)-薄荷基-2-丁烯,总收率分别为80.5%、83.1%和79.6%.探讨了影响反应的多种因素,找到了较好的合成条件,并用IR、 1HNMR和元素分析对产物进行了表征.     

Origin of the threshold voltage instability in SiO/sub 2//HfO/sub 2/ dual layer gate dielectrics

The magnitude of the V/sub T/ instability in conventional MOSFETs and MOS capacitors with SiO/sub 2//HfO/sub 2/ dual-layer gate dielectrics is shown to depend strongly on the details of the measurement sequence used. By applying time-resolved measurements (capacitance-time traces and charge-pumping measurements), it is demonstrated that this behavior is caused by the fast charging and discharging of preexisting defects near the SiO/sub 2//HfO/sub 2/ interface and in the bulk of the HfO/sub 2/ layer. Based on these results, a simple defect model is proposed that can explain the complex behavior of the V/sub T/ instability in terms of structural defects as follows. 1) A defect band in the HfO/sub 2/ layer is located in energy above the Si conduction band edge. 2) The defect band shifts rapidly in energy with respect to the Fermi level in the Si substrate as the gate bias is varied. 3) The rapid energy shifts allows for efficient charging and discharging of the defects near the SiO/sub 2//HfO/sub 2/ interface by tunneling.     

Heading towards an advanced signalling system for multimedia,multiparty services in broadband ISDN

Introduction of the broadband integrated services digital network (B-ISDN) will enable network users to make use of advanced multimedia, multiparty services. With this aim in view, RACE II project R2044, MAGIC, is investigating long-term signalling requirements, architecture and protocols for B-ISDN. New service concepts are being developed in MAGIC which will provide more flexibility when compared to narrowband ISDN (N-ISDN). The service requirements and other signalling requirements, such as the separation between call and associated connections at the network-node interface, are used to determine the distribution of functions over the network. The signalling protocols which are used to exchange the signalling information are subsequently developed. These signalling protocols are simulated to prove the performance and the feasibility of call handling concepts     

Fuel management of the HTR-10 including the equilibrium state and the running-in phase

The mode of fuel management of the HTR-10 was studied, including the simulation of the fuel shuffling process and the measurement of the burnup of a fuel element. The prior consideration was the design of the equilibrium state. Based on this the fuel loading of the initial core and the fuel shuffling mode from the initial core through the running-in phase into the equilibrium state were studied. The code system VSOP was used for the physical layout of the HTR-10 at the equilibrium state and in the running-in phase. For the equilibrium state, in order to lessen the difference between the peak and the average burnup, 5-fuel-passage-through-the-core was chosen for the fuel management. The average burnup of the spent fuel for the equilibrium core is 80 000 MWd t⁻¹, and the peak value of it is less than 100 000 MWd t⁻¹ when the burnup of the recycled fuel element is under 72 000 MWd t⁻¹. The mixture of fuel element and graphite element was used for the initial core loading, the volume fractions of the fuel and the graphite elements were 0.57 and 0.43, respectively. During the running-in phase, the volume fraction of graphite will decrease with the fresh fuel elements being loaded from the top of the core and the graphite elements discharged from the bottom of the core. The fuel shuffling mode is similar to that of the equilibrium state. The burnup limit of recycled fuel element is also 72 000 MWd t⁻¹ and the peak burnup is less than 100 000 MWd t⁻¹. Finally the core will be full of fuel elements with a certain profile of burnup and reaches the equilibrium state. According to the characteristics of the pebble-bed high temperature gas-cooled reactor, a calibrating method of concentration of ¹³⁷Cs was proposed for the measurement of fuel burnup.     

Error monitoring issues for common channel signaling

Motivated by field data which showed a large number of link changeovers and incidences of link oscillations between in-service and out-of-service states in common channel signalling (CCS) networks, a number of analyses of the link error monitoring procedures in the SS7 protocol were performed by the authors. This paper summarizes the results obtained thus far and include the following: (a) results of an exact analysis of the performance of the error monitoring procedures under both random and bursty errors; (b) a demonstration that there exists a range of error rates within which the error monitoring procedures of SS7 may induce frequent changeovers and changebacks; (c) an analysis of the performance of the SS7 level-2 transmission protocol to determine the tolerable error rates within which the delay requirements can be met; (d) a demonstration that the tolerable error rate depends strongly on various link and traffic characteristics, thereby implying that a single set of error monitor parameters will not work well in all situations; and (e) some recommendations on a customizable/adaptable scheme of error monitoring with a discussion on their implementability. These issues may be particularly relevant in the presence of anticipated increases in SS7 traffic due to widespread deployment of advanced intelligent network (AIN) and personal communications service (PCS) as well as for developing procedures for high-speed SS7 links currently under consideration by standards bodies     

焊接史

本文追溯了19世纪末发明的电弧焊接的历史。当Oscar Kjellberg成立伊萨公司以探索他发明的涂层焊条时，伊萨从一开始就和电弧焊的发展结下了不解之缘。     

Surface charge accumulation and decay on a spacer stressed with DC voltages at atmospheric conditions

Contents Surface charge accumulation and its decay at a GIS spacer are studied at atmospheric conditions employing a two step-calibration method. The results show that the accumulation saturates within 30 minutes; the dominant mechanism of surface charge accumulation is the drift of charged particles via air, while that of the decay is surface conduction. The characteristics are similar at both polarities.

---

Sättigungskonzentration und Abklingverhalten der Oberflächenladung an einem mit Gleichspannung beanspruchten Abstandshalter unter atmosphärischen Bedingungen

Übersicht Die Konzentration und das Abklingen von Oberflächenladungen an einem GIS Abstandshalter wurden unter atmosphärischen Bedingungen mit Hilfe eines zweistufigen Kalibrierungsverfahrens untersucht. Die Ergebnisse zeigen eine Sättigung der Ladungskonzentration innerhalb von 30 Minuten. Als Hauptursache der Ladungskonzentration ist die Drift geladener Teilchen in Luft anzusehen, während das Abklingen auf die Oberflächenleitung zurückzuführen ist. Ähnliche Charakteristiken ergeben sich mit beiden Polaritäten.

     

CdSe量子点的制备与荧光特性研究

主要讨论了CdSe量子点的制备及荧光特性。CdSe量子点由化学方法制备，通过选择不同的反应时间得到不同尺度的量子点样品。用荧光方法研究了量子点样品在石英衬底和有机溶剂中的荧光特性。实验表明，这些量子点都有良好的荧光特性。还用无限深球方势阱模型分析了量子点样品的电子态，并根据荧光参数估算了量子点的尺度．各样品荧光峰具有一致的半峰宽，表明CdSe量子点的成核过程在反应开始时同时完成。