Direct-current measurements of oxide and interface traps onoxidized silicon

A direct-current current-voltage (DCIV) measurement technique of interface and oxide traps on oxidized silicon is demonstrated. It uses the gate-controlled parasitic bipolar junction transistor of a metal-oxide-silicon field-effect transistor in a p/n junction isolation well to monitor the change of the oxide and interface trap density. The dc base and collector currents are the monitors, hence, this technique is more sensitive and reliable than the traditional ac methods for determination of fundamental kinetic rates and transistor degradation mechanisms, such as charge pumping     

Efficient PDFA module using high-NA PbF/sub 2//InF/sub 3/-based fluoride fiber

The highest reported single-pass gain coefficient of 0.36 dB/mW has been achieved using a newly developed Pr/sup 3+/-doped high-NA PbF/sub 2//InF/sub 3/-based fluoride fiber, with a /spl Delta/n of 6.6%, a core diameter of 1.2 /spl mu/m and a transmission loss of 250 dB/km at 1.2 /spl mu/m. This fiber was used to construct an efficient PDFA module with a MOPA-LD. A small-signal net gain of 22.5 dB was achieved at 1.30 /spl mu/m with a pump power of 23m mW.     

Modeling of NBTI saturation effect and its impact on electric field dependence of the lifetime

Negative Bias Temperature Instability of pMOSFETs is investigated under various stress gate voltages and temperatures. It is shown that degradation tends to saturate and the dependence of lifetime on electric field (E_ox) is expressed as a power-law of E_ox. We propose new empirical and kinetic models. The E_ox dependence of the lifetime described by the power-law is derived from our empirical model describing the saturation of degradation. Moreover, our kinetic model explains the saturation behavior.     

Novel muscle spindles containing muscle fibers devoid of sensory innervation in the extensor digitorum longus muscle of aged rats

We examined the structural features of muscle spindles at the equatorial and juxtaequatorial regions in the extensor digitorum longus muscle of adult (12 months) and aged (25 months) rats. In aged muscle spindles, the lamellated layers of the spindle capsule were a little increased in number compared to those in the adult ones. Two novel muscle spindles were observed in the aged muscle. In one muscle spindle, the spindle capsule contained four thin intrafusal muscle fibers invested by the inner capsule and two muscle fibers between the layers of the spindle capsule. Serial semithin sections revealed that the latter lacked the investment of the spindle capsule at the polar region. The other muscle spindle contained four intrafusal muscle fibers: two thin sensory-innervated muscle fibers invested by the inner capsule and two thick muscle fibers similar in structural features to neighboring extrafusal muscle fibers and lacking sensory innervation within the wide periaxial space. These findings suggest that two muscle fibers between the layers of the spindle capsule may be invested by the newly formed capsular cells during aging, while two thick fibers within the periaxial space may fail to receive the sensory innervation during the early development and follow the course of extrafusal fiber differentiation.     

The sensory region of muscle spindles in the posterior cricoarytenoid muscle of the marmoset

We examined muscle spindles in the posterior cricoarytenoid (PCA) muscle of the marmoset. The spindle capsule contained only one intrafusal muscle fiber which did not form a typical aggregation of equatorial nuclei such as bags and chains. The intrafusal fiber was innervated by sensory endings which branched and arranged irregularly. These sensory endings lay on the surface of the fiber in shallow grooves or deeply penetrated into it. These findings suggest that the muscle spindles in the marmoset PCA muscle are strikingly different in the structure of intrafusal fibers in the arrangement of sensory endings from those in common mammalian skeletal muscles.     

Reliability of rare-earth-doped fluoride fibers for optical fiberamplifier application

We have clarified the strength and estimated lifetime of fluoride fibers for optical amplifier use. We fabricated a UV-curable epoxy-acrylate coated fluoride fiber with a strength of 542 MPa. We estimated the lifetime of the fluoride fiber to be longer than 25 years at 80°C and 50% RH     

Gain-flattened tellurite-based EDFA with a flat amplificationbandwidth of 76 nm

We describe a tellurite-based Er³⁺-doped fiber amplifier (EDFA) with a flat amplification bandwidth of 76 nm and a noise figure of less than 7 dB. Furthermore, a parallel-type amplifier composed of this EDFA and a 1.45-μm-band Tm³⁺-doped fluoride fiber amplifier achieved a flat amplification bandwidth of 113 nm     

CW Operation of a Submillimeter Wave Gyrotron (Gyrotron Fu IV) for High Stability of the Output Frequency

The first cw operation of our submillimeter wave gyrotron (Gyrotron FU IV) using a 12 T superconducting magnet has been successfully carried out. Output power is more than 20 W at a frequency of 301 GHz in the TE₀₃₁ resonant cavity mode. Time-resolved frequency measurement s shows that the frequency fluctuation of the gyrotron output is smaller than 2 MHz. This frequency fluctuation is mainly due to the fluctuation in the output voltage of the power supply.     

An experimental 1.5-V 64-Mb DRAM

Low-voltage circuit technologies for higher-density dynamic RAMs (DRAMs) and their application to an experimental 64-Mb DRAM with a 1.5-V internal operating voltage are presented. A complementary current sensing scheme is proposed to reduce data transmission delay. A speed improvement of 20 ns was achieved when utilizing a 1.5-V power supply. An accurate and speed-enhanced half-V_CC voltage generator with a current-mirror amplifier and tri-state buffer is proposed. With it, a response time reduction of about 1.5 decades was realized. A word-line driver with a charge-pump circuit was developed to achieve a high boost ratio. A ratio of about 1.8 was obtained from a power supply voltage as low as 1.0 V. A 1.28 μm² crown-shaped stacked-capacitor (CROWN) cell was also made to ensure a sufficient storage charge and to minimize data-line interference noise. An experimental 1.5 V 64 Mb DRAM was designed and fabricated with these technologies and 0.3 μm electron-beam lithography. A typical access time of 70 ns was obtained, and a further reduction of 50 ns is expected based on simulation results. Thus, a high-speed performance, comparable to that of 16-Mb DRAMs, can be achieved with a typical power dissipation of 44 mW, one tenth that of 16-Mb DRAMs. This indicates that a low-voltage battery operation is a promising target for future DRAMs     

All-optical logic gates containing a two-mode nonlinear waveguide

We propose a new element containing a two-mode nonlinear waveguide consisting of Kerr-like material for all-optical logic circuits. The proposed element, incorporated into the Mach-Zehnder interferometer, functions like a phase shifter. Although the optical waves propagating in the proposed element are monochromatic and identical in polarization, its function is insensitive to the relative phase difference between the incident beams. Using this element, we can realize various logic functions. In this paper, we demonstrate such logic circuits as inverters, distributors, and AND gates