Two-stage nuclear demagnetization refrigerator

Two-stage nuclear demagnetization has been performed using PrCu₆ and Cu as coolants. The Cu nuclear stage reached temperatures as low as 10 K with a rate of temperature rise of less than a few K/h. The corresponding conduction electron temperature is estimated to be less than 50 K. A nuclear orientation thermometer of Al ⁵⁴Mn has been successfully used to measure temperatures down to 10 K.Supported by the Japan Society for the Promotion of Science.     

Low Frequency Pulsed Resonant Converter for Energy Harvesting

A pulsed-resonant ac-dc converter and an integrated circuit (IC) controller have been designed, fabricated, and tested for harvesting energy from low-voltage (1.2V), low-power (1-100muW) energy transducers with output frequency in the 10-Hz-1-kHz range. Simulations using foundry models suggest that the silicon loss could be as low as 0.6muW, and the efficiency could reach 70%. With the IC experimentally packaged, the measured efficiency is between 50% and 70%, depending on the size and the loss in the resonant inductor     

Continuous‐Flow C?H Borylation of Arene Derivatives

A new continuous‐flow system for C H borylation has been developed. An insoluble catalyst prepared from chloro(1,5‐cyclooctadien)iridium(I) dimer and 2,2′‐bipyridine‐4,4′‐dicarboxylic acid in the presence of bis(pinacolato)diboron exhibited high reactivity under continuous‐flow processing without the loss of expensive iridium metal.     

Accelerated weathering-induced degradation of poly(lactic acid) fiber studied by near-infrared (NIR) hyperspectral imaging

Hydrolysis degradation of a set of drawn poly(lactic acid) (PLA) fibers was induced by an accelerated weathering test, radiating ultraviolet (UV) light under a certain temperature and humidity. The fine features of the transient behavior of the PLA fibers were captured by near-infrared (NIR) hyperspectral imaging. The PLA fibers showed a gradual decrease in mechanical property (e.g., tensile strength), indicating hydrolysis degradation. Thus, the detailed analysis of the spectral variation, in turn, offers useful information on the molecular-level degradation behavior of the drawn PLA fibers. The variation of the spectral intensity as well as band position shift of the crystalline band of PLA was analyzed. The spectral intensity of the crystalline band of PLA showed gradual decrease, suggesting the decrease in molecular weight induced by the hydrolysis degradation. In addition, the crystalline band also exhibited a coinciding shift to the lower wavenumber direction with the weathering test, revealing cleavage-induced crystallization of the PLA samples. Consequently, the hydrolysis degradation induced by the weathering test substantially accelerates predominant degradation of the amorphous structure of the PLA and such variation of the molecular structure, in turn, brings less ductility to the PLA fiber.     

An EMQ-switched CO2 laser as a pump source for afar-infrared laser with a high peak power and a high repetitionrate

A modified current pulsed Q (EMQ)-switched CO₂ laser which is Q-switched by a mechanical beam chopper in combination with a pulsed discharge current is discussed. The laser produces a very stable output with a peak power greater than 1 kW at a repetition rate of 1000 p.p.s. for all transitions in the P and R branches of the CO₂ spectrum. A CH₃F laser pumped by the EMQ-switched laser produces 496 μm radiation in a 6.5 W peak, 100 ns pulses at 500 p.p.s. in the lowest loss EH₁₁ mode     

Recycling of aluminum matrix composites

Separation of matrix metals in composites was tried on alumina short fiber-reinforced aluminum and 6061 alloy composites and SiC whisker-reinforced 6061 alloy composite for recycling. It is possible to separate molten matrix metals from fibers in the composites using fluxes that are used for melt treatment to remove inclusions. About 50 vol pct of the matrix metals was separated from the alumina short fiber-reinforced composites. The separation ratio of the matrix from the SiC whisker-reinforced 6061 alloy composite was low and about 20 vol pct. The separation mechanism was discussed thermodynamically using interface free energies. Since the flux/fiber interface energy is smaller than the aluminum/fiber interface energy, the replacement of aluminum with fluxes in composites takes place easily. Gases released by the decomposition of fluxes act an important role in pushing out the molten matrix metal from the composite. The role was confirmed by the great amount cavity formed in the composite after the matrix metal flowed out.     

Correlated double sampling technique for continuous-time filters

A correlated double sampling technique, applicable to continuous-time active-RC filters, is proposed. It provides suppression of DC offset and 1/f noise, and performs gain boosting and level shifting for the opamps used. A biquad lowpass filter is described to demonstrate the application of the technique.     

Estimate of physiological variability of peak latency in single sweep P300

Lengthening is generally accepted method of treatment for extremity length discrepancy. This attractive method carries the risk of many complications that may ruin primary treatment plan. The aim of this paper was to analyze complications and their management in own material consisting of 60 extremities in 58 patients aged 8-37 years. Limb length discrepancy was caused by congenital bony hypoplasia in 44 cases, trauma in 8 and infection in 8 cases. Initial shortening ranged from 4 to 15 cm (mean 6.5 cm). Ilizarov technique was used in 20 cases, Wagner method in 6 cases and DeBastiani in 34 cases. Expected elongation has been achieved in 60% cases; in remaining 40% complications occurred. New bone formation disturbances and axial malalignement were among most severe ones. An autogenic marrow injections were used to stimulate callus formation, osteogenon was administered. Axial malalignement was corrected by osteotomy. Percentage of complications decreased as number of elongations performed increased.     

Acquisition of Female-Attracting Fragrance by Males of Oriental Fruit Fly from a Hawaiian Lei Flower, Fagraea berteriana

Males of the Oriental fruit fly, Bactrocera dorsalis, are strongly attracted to and compulsively feed on a fragrant lei flower, Fagraea berteriana. A series of phenylpropanoid components, trans-3,4-dimethoxycinnamyl alcohol, its acetate, and trans-3,4-dimethoxycinnamaldehyde were characterized as male attractants. The alcohol stimulated the same level of feeding activity as methyl eugenol. Males that fed on flowers selectively converted the attractant components into trans-coniferyl alcohol and stored it in rectal glands. Males scented with the phenylpropanoids were more successful in mating than unfed males, indicating the advantage of acquiring the fragrance in mating success.