Effect of refrigerant charge on the performance of air conditioning systems

An air conditioning system operates in an optimal condition if the system is fully charged with a specified amount of refrigerant. Poor field maintenance or refrigerant leakage causes low level of charge resulting in a lower thermal performance and higher operating cost. An experimental investigation was conducted to study the effect of low charge level of R‐22 on the performance of a 3‐ton residential air conditioning system. The experimental results show that if a system is undercharged to 90 per cent then the effect is small: a 3.5 per cent reduction in cooling capacity and a 2 per cent increase in the coefficient of performance (COP). However, the system performance suffers serious degradation if the level of charge drops below 80 per cent. An ice layer formed on the outer surface of the cooling coil impedes the heat transfer between the warm air and cold refrigerant vapour. An economic analysis shows that the cost of properly charging an under‐charged system which is at an 85 per cent charge level, can pay for itself in savings in a short period of 3–4 months. Copyright © 2001 John Wiley & Sons, Ltd.     

Nanoscale Ⅲ-V on Si-based junctionless tunnel transistor for EHF band applications

A single gate Ⅲ-V junctionless tunnel field effect transistor (SG-JLTFET) has been reported which shows excellent dc characteristics at low power supply operation. This device has a thin uniformly n-type doped channel of GaSb i.e. gallium antimonide which is grown epitaxially over silicon substrate. The DC performance parameters such as I_ON, I_ON/I_OFF, average and point subthreshold slope as well as device parameters for analog applications viz. transconductance g_m, transconductance generation efficiency g_m/I_D, various capacitances and the unity gain frequency f_T are studied using a device simulator. Along with examining its endurance to short channel effects, the performances are also compared with a Silicon Dual Gate Junctionless Tunnel FET (DG-JLTFET). The DC and small signal analog performance reflects that GaSb SG-JLTFET has immense purview for extreme high-frequency and low-power applications.     

Thermal energy storage technologies and systems for concentrating solar power plants

This paper presents a review of thermal energy storage system design methodologies and the factors to be considered at different hierarchical levels for concentrating solar power (CSP) plants. Thermal energy storage forms a key component of a power plant for improvement of its dispatchability. Though there have been many reviews of storage media, there are not many that focus on storage system design along with its integration into the power plant. This paper discusses the thermal energy storage system designs presented in the literature along with thermal and exergy efficiency analyses of various thermal energy storage systems integrated into the power plant. Economic aspects of these systems and the relevant publications in literature are also summarized in this effort.     

First and second law analysis of a new power and refrigeration thermodynamic cycle using a solar heat source

The first and second laws of thermodynamics were used to analyze a novel thermodynamic cycle proposed by Goswami in 1995 that uses an ammonia–water binary mixture as the working fluid, while producing both power and refrigeration simultaneously. The thermodynamic performance of the cycle was optimized for maximum second law efficiency using a commercially available optimization program. A maximum second law efficiency of 65.8% was obtained at a heat source temperature of 420 K. An exergy analysis was performed to study losses in different components of the cycle. It is seen that the largest contribution to cycle irreversibility comes from the absorber, with the rectifier and solution heat exchanger also contributing significantly. Irreversibility generation in the boiler is high at very low heat source temperatures, but drops at higher temperatures.     

Monitoring of energy exergy efficiencies and exergoeconomic parameters of geothermal district heating systems (GDHSs)

In this work, the monitoring energy and exergy efficiency results of the last heating seasons of operation of the geothermal district heating systems (GDHSs) and their technical availability analysis and monitoring exergoeconomic parameters are presented. The case studies cover the actual system data taken from the systems in Afyon and Salihli GDHSs, Turkey. General energy, exergy, technical availability, and exergoeconomic analysis of the GDHSs are introduced. Furthermore, the average technical availability, real availability, capacity factor and energy and exergy efficiencies value of GDHSs have been analyzed.     

An experimental study of the exergetic performance of an underground air tunnel system for greenhouse cooling

The present study highlights the exergetic performance characteristics of an underground air tunnel for greenhouse cooling with a 47 m horizontal, 56 cm nominal diameter U-bend buried galvanized ground heat exchanger. This system was designed and installed in the Solar Energy Institute, Ege University, Izmir, Turkey. Underground air tunnel systems, also known as earth-to-air heat exchangers, are recognized to be outstanding heating, cooling and air heating systems. On the other hand, they have not been used yet in the Turkish market. Greenhouses also have important economical potential in Turkey’s agricultural sector. Greenhouses should be cooled during the summer or hot days. In order to establish optimum growth conditions in greenhouses, renewable energy sources should be utilized as much as possible. It is expected that effective use of underground air tunnels with a suitable technology in the modern greenhouses will play a leading role in Turkey in the foreseeable future. The exergy transports between the components and the destructions in each of the components of the system are determined for the average measured parameters obtained from the experimental results. Exergetic efficiencies of the system components are determined in an attempt to assess their individual performances and the potential for improvements is also presented. The daily maximum cooling coefficient of performances (COP) values for the system are also obtained to be 15.8. The total average COP in the experimental period is found to be 10.09. The system COP was calculated based on the amount of cooling produced by the air tunnel and the amount of power required to move the air through the tunnel, while the exergetic efficiency of the air tunnel is found to be in a range among 57.8–63.2%. The overall exergy efficiency value for the system on a product/fuel basis is found to be 60.7%.     

A review of thermodynamic cycles and working fluids for the conversion of low-grade heat

This paper presents a review of the organic Rankine cycle and supercritical Rankine cycle for the conversion of low-grade heat into electrical power, as well as selection criteria of potential working fluids, screening of 35 working fluids for the two cycles and analyses of the influence of fluid properties on cycle performance. The thermodynamic and physical properties, stability, environmental impacts, safety and compatibility, and availability and cost are among the important considerations when selecting a working fluid. The paper discusses the types of working fluids, influence of latent heat, density and specific heat, and the effectiveness of superheating. A discussion of the 35 screened working fluids is also presented.     

Study of an aqueous lithium chloride desiccant system: air dehumidification and desiccant regeneration

Desiccant systems have been proposed as energy saving alternatives to vapor compression air conditioning for handling the latent load. Use of liquid desiccants offers several design and performance advantages over solid desiccants, especially when solar energy is used for regeneration. For liquid–gas contact, packed towers with low pressure drop provide good heat and mass transfer characteristics for compact designs. This paper presents the results from a study of the performance of a packed tower absorber and regenerator for an aqueous lithium chloride desiccant dehumidification system. The rates of dehumidification and regeneration, as well as the effectiveness of the dehumidification and regeneration processes were assessed under the effects of variables such as air and desiccant flow rates, air temperature and humidity, and desiccant temperature and concentration. A variation of the Öberg and Goswami mathematical model was used to predict the experimental findings giving satisfactory results.     

Synthesis,characterization and corrosion performance evaluation of DDR membrane for H2 separation from HI decomposition reaction

An all silica DDR (deca dodecasil rhombohedral) zeolite membrane with dense, interlocked structure has been developed for separation of H₂ from HI/I₂ mixture of HI decomposition reaction. In this work, the DDR zeolite membrane was synthesized on the seeded clay-alumina substrate within 5 days. The seeds were synthesized by sonication mediated hydrothermal process within short crystallization time which enhanced the nucleation for the membrane growth. The synthesized membranes along with seed crystals were characterized by X-ray diffraction (XRD), Fourier transform infrared (FTIR), Field emission scanning electron microscope (FESEM) and energy dispersive X-ray spectroscopy (EDAX). The selectivity of hydrogen with respect to CO₂ and Ar was evaluated by single gas permeation studies at room temperature. The tests for corrosion resistance were carried out upto 120 h with both support and DDR membrane at 130 °C which confirmed the stability of membrane under the harsh HI/I₂ environment.