用φ20mm离心萃取器两步法制取高纯钇

本文研究了中钇富镧稀土的氧化物溶液在环烷酸中的萃取行为，测定了镧钇组成、温度变化与分离系数的关系；在Ｐ＿（５０７）体系中研究了ｐＨ值与分配比的关系；提出用环烷酸、Ｐ＿（５０７）两种萃取剂制备高纯钇的工艺流程。用８４台φ２０ｍｍ离心萃取器进行了一个月的台架试验，结果证明两种萃取剂有很好的互补性，在满足钇的纯度要求下有较高收率。离心萃取器具有易分相、体系存留量少、液流密闭性好等优点，它更适宜于粘度大、级数多、产品纯度要求高的体系。     

关于Ada95变体部分等语法的修正意见

本文指出了Ａｄａ９５ 参考手册中记录变体部分、记录聚集、分情形语句与异常处理段等语法描述中存在的问题，并分别给出了它们的修正方案。     

川东地区长兴组缝洞型储层的识别

本文针对四川东部地区上二叠统长兴组(P_2~2)缝洞型储层的低孔、低渗及非均质性等特点,分析了影响这类储层识别的主要因素,提出了利用现有的地球物理测井手段定性识别储层的指标和定量综合识别储层的方法,这可望提高测试成功率。     

^60Coγ射线对刚地弓形虫缓殖子感染性的影响

应用不同剂量的~(60)Coγ射线照射含NT株弓形虫包囊的鼠脑匀浆后,以0.4％胰蛋白酶液消化,使弓形虫缓殖子从包囊中释放出来,并用生理盐水作连续10倍稀释,使成为含不同数量缓殖子的悬液,将此悬液接种小鼠,用生物检测方法确定其感染性。另设未经照射处理的缓殖子悬液感染小鼠的对照组。结果表明,γ射线0.55kGy剂量为控制鼠脑中NT株弓形虫感染性的最小有效剂量。γ射线0.1kGy剂量对弓形虫缓殖子感染性无明显影响,而0.45kGy照射后,其感染性较前者下降了10~4倍。     

普通砂型铸造中球铁件冒口的CAD

根据球铁件凝固原理，对常用湿砂铸型中制造球铁件，用计算机完成控制压力冒口的设计，流程框图适于各工厂和车间之用。     

在役加氢反应器试验板脆化和氢损伤的测定与研究

充分利用了带主焊缝的役后试板，在国内首次开展回火脆化、氢介质下断裂韧性与疲劳扩展的研究，结果表明，加氢反应器焊缝有明显的脆化表现。同时，核查了反应器开停车升温速度和降温速度规定，以及确定了裂纹允许尺寸的参考数据，为今后安全运行提供了充分的依据。     

Acidity near eroding polylactide-polyglycolide in vitro and in vivo in rabbit tibial bone chambers

Eroding poly(DL-lactide-co-glycolide)(PDLLG) washers were observed chronically in vitro and in vivo following loading in a bone chamber tibial implant (BCI). Images were recorded using intravital microscopy of the implanted rabbit and direct pH measurements were obtained of the tissue in the bone chamber using a combination probe-reference microelectrode. While statistically significant pH differences were found between the control (unloaded) and experimental (PDLLG-bearing) BCIs, they were only of the order of 0.2 pH units. This value proved to be physiologically insignificant as no statistically significant difference in bone defect healing, as indicated by angiogenesis, was detected. It was shown that the measured small pH changes during PDLLG washers erosion would result whether the buffer was phosphate-buffered saline replaced weekly or interstitial fluid subject to vascular exchanges.     

分子结构对增塑聚氯乙烯性能的影响

研究了聚合度、分子量分布和支化结构对增塑聚氯乙烯加工流变性能和物理力学性能的影响。结果表明，增塑ＰＶＣ的加工流变性能随聚合度的增加而恶化；拓宽分子量分布和引入支化结构均有利于加工流变性能的提高；增塑ＰＶＣ的拉伸强度随聚合度的增加而提高，而压缩永久变形却随之减小；分子量分布对物理力学性能的影响不大；支化ＰＶＣ的拉伸强度略有下降。     

全局最小均方算法

本文提出了一种基于全局均方误差最小准则的全局最小均方（ＴＬＭＳ）算法，在理论上分析了它的统计特性和收敛性，用数字仿真技术优良地它的性能。     

Performance evaluation of TCP/RLP protocol stack over CDMA wireless link

Due to the high frame error rate in wireless communication channels, an additional link layer protocol, Radio Link Protocol (RLP), has been introduced in the newly approvedData Services Option Standard for Wideband Spread Spectrum Digital Cellular System. In this paper, we investigate performance issues of a typical Cod Division Multiple Access (CDMA) wireless link using the protocol stack given in the standard. In particular, we focus on the dynamics of the TCP and RLP layers of the protocol stack since the fluctuation of system performance is largely caused by Automatic Repeat Request (ARQ) mechanisms implemented at these two layers. We compare the network performance of default parameter setting to those of other possible parameter settings. Analytical and simulation results presented in this paper can provide guidance to those attempting to further improve performance of interest.