Low dose powdered activated carbon addition at high sludge retention times to reduce fouling in membrane bioreactors

The addition of a low concentration of PAC (0.5 g L⁻¹ of sludge, i.e. a dose of 4 mg L⁻¹ of wastewater), in combination with a relatively long SRT (50 days), to improve membrane filtration performance was investigated in two pilot-scale MBRs treating real municipal wastewater. Continuous filterability tests at high flux showed the possibility to run for 18 h at 72 L m⁻² h⁻¹ and 180 h at 50 L m⁻² h⁻¹, while significant fouling occurred without PAC. In addition, measurements of the critical flux showed an increase of 10% for this strategy. Low dosage and high retention time makes it feasible and cost effective. Further advantages with regard to permeate quality and possible micropollutants removal are currently under investigation.     

Effect of Co,Pd and Pt ultra-thin films on the Ni-silicide formation: investigating the sandwich configuration

The effect of Co, Pd and Pt ultrathin films on the kinetics of the formation of Ni-silicide by reactive diffusion is investigated. 50 nm Ni/1 nm X/ 50 nm Ni (X?=?Co, Pd, Pt) deposited on Si(100) substrates are studied using in-situ and ex-situ measurements by X-ray diffraction (XRD). The presence of Co, Pd or Pt thin films in between the Ni layers delays the formation of the metal rich phase compared to the pure Ni/Si system and thus these films act as diffusion barriers. A simultaneous silicide formation (δ-Ni₂Si and NiSi phases) different from the classic sequential formation is found during the consumption of the top Ni layer for which Ni has to diffuse through the barrier. A model for the simultaneous growth in the presence of a barrier is developed, and simulation of the kinetics measured by XRD is used to determine the permeability of the different barriers. Atom probe tomography (APT) of the Ni/Pd/Ni system shows that the Pd layer is located between the Ni top layer and δ-Ni₂Si during the silicide growth, in accordance with a silicide formation controlled by Ni diffusion through the Pd layer. The effect of the barrier on the silicide formation and properties is discussed.

     

Software HEVC video decoder: towards an energy saving for mobile applications

Multimedia Tools and Applications - With the explosive growth of mobile video consumption over the Internet, delivering video at high quality while controlling the energy consumption of embedded...     

Multivariate Analysis of Multiple Datasets: a Practical Guide for Chemical Ecology

Chemical ecology has strong links with metabolomics, the large-scale study of all metabolites detectable in a biological sample. Consequently, chemical ecologists are often challenged by the statistical analyses of such large datasets. This holds especially true when the purpose is to integrate multiple datasets to obtain a holistic view and a better understanding of a biological system under study. The present article provides a comprehensive resource to analyze such complex datasets using multivariate methods. It starts from the necessary pre-treatment of data including data transformations and distance calculations, to the application of both gold standard and novel multivariate methods for the integration of different omics data. We illustrate the process of analysis along with detailed results interpretations for six issues representative of the different types of biological questions encountered by chemical ecologists. We provide the necessary knowledge and tools with reproducible R codes and chemical-ecological datasets to practice and teach multivariate methods.     

Dynamic response of ferrofluidic deformable mirrors using elastomer membrane and overdrive techniques

The experimental results obtained with a ferrofluidic deformable mirror controlled by electro-magnet actuators are presented here. Using a step input through a single actuator, we obtained a steady-state settling time of 100?ms; however, different combinations of overdrive inputs can be used to decrease it to 25?ms. A new technique which consists of laying down an elastomer membrane, coated with an aluminum film, on the ferrofluid is also discussed. By adding the membrane on the ferrofluid, it further decreases the time response by a factor of 2. Furthermore, the thin aluminum layer improves the reflectivity of the mirror. Finally, using the membrane and the overdrive techniques combined, the time response is improved by a factor of 20. Numerical simulations show that ferrofluidic mirrors using membranes and improved electronics should reach settling times of the order of a millisecond. Presumably, even lower settling times could be possible.     

Substrate Flexibility of the Flavin-Dependent Dihydropyrrole Oxidases PigB and HapB Involved in Antibiotic Prodigiosin Biosynthesis

In the biosynthesis of the tripyrrolic pigment prodigiosin, PigB is a predicted flavin-dependent oxidase responsible for the formation of 2-methyl-3-amylpyrrole (MAP) from a dihydropyrrole. To prove which dihydropyrrole is the true intermediate, both possibilities, 5-methyl-4-pentyl-3,4-dihydro-2H-pyrrole ( 5 a , resulting from transamination of the aldehyde of 3-acetyloctanal) and 2-methyl-3-pentyl-3,4-dihydro-2H-pyrrole ( 6 , resulting from transamination of the ketone), were synthesised. Only 5 a restored pigment production in a strain of Serratia sp. ATCC 39006 blocked earlier in MAP biosynthesis. PigB is membrane-associated and inactive when its transmembrane domain was deleted, but HapB, its homologue in Hahella chejuensis, lacks the transmembrane domain and is active in solution. Two colourimetric assays for PigB and HapB were developed, and the HapB-catalysed reaction was kinetically characterised. Ten analogues of 5 a were synthesised, varying in the C2 and C3 side chains, and tested as substrates of HapB in vitro and for restoration of pigment production in Serratia ΔpigD in vivo. All lengths of side chain tested at C3 were accepted, but only short side chains at C2 were accepted. The knowledge that 5 a is an intermediate in prodigiosin biosynthesis and the ease of synthesis of analogues of 5 a makes a range of prodigiosin analogues readily available by mutasynthesis.     

An aggregation strategy of maximum size constraints in density-based topology optimization

Structural and Multidisciplinary Optimization - The maximum size constraint restricts the amount of material within a test region in each point of the design domain, leading to a highly constrained...