Microwave irradiated and thermally heated olive stone activated carbon for nickel adsorption from synthetic wastewater: A comparative study

In attempt to compare the removal efficiency and yield of the activated carbon prepared using the conventional and microwave‐assisted heating is the focus of this work. Toward this olive stone (a biomass precursor) is activated using the popular activating agent potassium hydroxide. The process optimization exercise is carried out by using the standard full factorial statistical design of experiments (response surface methodology). The activated carbons prepared under the optimized conditions are compared based on the adsorption capacity and yield. The adsorption capacity was found higher using microwave heating as compared with conventional heating. The microwave heating requires significantly lesser holding time as compared to conventional heating method to produce activated carbon of comparable quality, with higher yield. The BET surface area of carbon using microwave heating is significantly higher than the conventional heating. Although the mesopore surface area of carbon is not vary significantly, the activation time, power, and nitrogen gas consumption are significantly lower than the conventional heating rendering that the activation process via microwave is more economical than that via conventional heating. The adsorption isotherm data fitted the Langmuir isotherm well and the monolayer adsorption capacity was found to be 12.0 and 8.42 mg/g for microwave and thermally heated activated carbon, respectively. Regeneration studies showed that microwave‐irradiated and thermally heated olive stone could be used several times by desorption with an HCl reagent. Both carbons can be used for the efficient removal of Ni²⁺ (>99%) from contaminated wastewater. © 2013 American Institute of Chemical Engineers AIChE J, 60: 237–250, 2014     

Structural development and magnetic phenomenon in Zn–Cr–Fe multi oxide nano-crystals

The Cr³⁺ ions doped multi-oxide ZnFe_2−xCr_xO₄ ferrite nanoparticles have been synthesized by chemical co-precipitation method. Site occupancies of Zn²⁺, Cr³⁺ and Fe³⁺ ions were analyzed using X-ray diffraction data and Buerger's method. The effect of the constituent phase variation on the magnetic hysteresis behavior was examined by saturation magnetization which decreases with the increase in Cr³⁺ content in place of Fe³⁺ ions at octahedral B-site. Typical blocking temperature (T_B) around 90 K was observed by zero field cooling and field cooling magnetization study. Room temperature Mössbauer spectra show two paramagnetic doublets (tetrahedral and octahedral sites). The isomer shifts of both doublets decrease whereas quadrupole splitting and relative area of tetrahedral A-site increases with increasing Cr³⁺ substitution. The dielectric constant (measured on compositions x=0, 0.4, 0.8 and 1.0) increases when the temperature increases as in the semiconductor. This behavior is attributed to the hopping of electrons between Fe²⁺ and Fe³⁺ ions with a thermal activation.     

Performance analysis of three advanced controllers for polymerization batch reactor: An experimental investigation

The performances of three advanced non-linear controllers are analyzed for the optimal set point tracking of styrene free radical polymerization (FRP) in batch reactors. The three controllers are the artificial neural network-based MPC (NN-MPC), the artificial fuzzy logic controller (FLC) as well as the generic model controller (GMC). A recently developed hybrid model (Hosen et al., 2011a. Asia-Pac. J. Chem. Eng. 6(2), 274) is utilized in the control study to design and tune the proposed controllers. The optimal minimum temperature profiles are determined using the Hamiltonian maximum principle. Different types of disturbances are introduced and applied to examine the stability of controller performance. The experimental studies revealed that the performance of the NN-MPC is superior to that of FLC and GMC.     

Combined Treatment with Cryptocaryone and Ultraviolet C Promotes Antiproliferation and Apoptosis of Oral Cancer Cells

Cryptocaryone (CPC) was previously reported as preferential for killing natural products in oral cancer cells. However, its radiosensitizing potential combined with ultraviolet C (UVC) cell killing of oral cancer cells remains unclear. This study evaluates the combined anti-proliferation effect and clarifies the mechanism of combined UVC/CPC effects on oral cancer cells. UVC/CPC shows higher anti-proliferation than individual and control treatments in a low cytotoxic environment on normal oral cells. Mechanistically, combined UVC/CPC generates high levels of reactive oxygen species and induces mitochondrial dysfunction by generating mitochondrial superoxide, increasing mitochondrial mass and causing the potential destruction of the mitochondrial membrane compared to individual treatments. Moreover, combined UVC/CPC causes higher G2/M arrest and triggers apoptosis, with greater evidence of cell cycle disturbance, annexin V, pancaspase, caspases 3/7 expression or activity in oral cancer cells than individual treatments. Western blotting further indicates that UVC/CPC induces overexpression for cleaved types of poly (ADP-ribose) polymerase and caspase 3 more than individual treatments. Additionally, UVC/CPC highly induces γH2AX and 8-hydroxy-2’-deoxyguanosine adducts as DNA damage in oral cancer cells. Taken together, CPC shows a radiosensitizing anti-proliferation effect on UVC irradiated oral cancer cells with combined effects through oxidative stress, apoptosis and DNA damage.     

Effect of pH,Temperature and Reaction Time on Calcium Binding by Hydroxypropyl Rice Starches

Calcium binding by both native and hydroxypropyl starches was studied in aqueous media under different pH, temperature and reaction times at various calcium: starch ratios. Calcium binding was markedly influenced by pHs and temperatures of the reaction mixture. Reaction times did not show marked influence on calcium binding. Maximum calcium binding was observed in alkaline pH and at lower temperature. Most of the calcium bound within the first 20 minutes. Thus, alkaline pH and lower temperature is more favourable for calcium binding by both native and hydroxypropyl rice starches compared to acidic pH and higher temperatures.     

Distribution of Partial Digestion Products of Hydroxypropyl Derivatives of Maize (NM), Waxy Maize (WM) and High Amylose (HA) Maize Starches

Porcine pancreatic α-amylase digests of native and hydroxypropyl derivatives of maize, waxy maize and high amylose maize starches were subjected to ethanolic fractionation into oligosaccharide and polysaccharide fractions. Both fractions of the partial digests were analysed for blue values, reducing values, total carbohydrate, average degree of polymerisation and molar substitution (MS). Distribution of hydroxypropyl groups between the fractions varied depending on starch type and level of substitution with the polysaccharide fraction being higher in MS. Blue values (BV) and average degree of polymerisation (DP) tended to decrease with digestion while reducing (RV) increased.     

Structural Control of NiO–YSZ/LSCF–YSZ Dual‐Layer Hollow Fiber Membrane for Potential Syngas Production

The objective of this study was to fabricate dual‐layer hollow fiber as a microreactor for potential syngas production via phase inversion‐based co‐extrusion/cosintering process. As the main challenge of phase inversion is the difficulty to obtain defect‐free fiber, this work focuses on the effect of the fabrication parameters, that is, nonsolvent content, sintering temperature and outer‐layer extrusion rate, on the macrostructure of the produced hollow fiber. SEM images confirm that the addition of nonsolvent has successfully minimized the finger‐like formation. At high sintering temperature, more dense hollow fiber was formed while outer‐layer extrusion rate affects the outer layer thickness.     

Two-step purification strategy for enhanced recovery of recombinant hepatitis B surface antigen from Pichia pastoris

Univariate screening on factors affecting the purification performance of recombinant hepatitis B surface antigen (HBsAg) on ion exchange chromatography (IEC) and size exclusion chromatography (SEC) and the establishment of a two-step purification strategy were performed. Amongst four IEC adsorbents examined, the use of Q Sepharose XL IEC adsorbent under optimized conditions together with optimized SEC purification was able to efficiently purify HBsAg. An established purification strategy comprising the two techniques further demonstrated adaptability for scale-up operations with a final total purification factor (PF) of 94.82 ± 16.20, HBsAg purity of 95.48% and recovery yield of 78.07%.     

COSMO-RS:An ionic liquid prescreening tool for gas hydrate mitigation

Recently ionic liquids(ILs) are introduced as novel dual function gas hydrate inhibitors. However, no desired gas hydrate inhibition has been reported due to poor IL selection and/or tuning method. Trial error as well as selection based on existing literature are the methods currently employed for selecting and/or tuning ILs. These methods are probabilistic, time consuming, expensive and may not result in selecting high performance ILs for gas hydrate mitigation. In this work, COSMO-RS is considered as a prescreening tool of ILs for gas hydrate mitigation by predicting the hydrogen bonding energies(E_(HB)) of studied IL inhibitors and comparing the predicted E_(HB) to the depression temperature(?) and induction time. Results show that, predicted EHBand chain length of ILs strongly relate and significantly affect the gas hydrate inhibition depression temperature but correlate moderately(R = 0.70) with average induction time in literature. It is deduced from the results that, ? increases with increasing IL EHBand/or decreases with increasing chain length. However, the cation–anion pairing of ILs also affects IL gas hydrate inhibition performance. Furthermore, a visual and better understanding of IL/water behavior for gas hydrate inhibition in terms of hydrogen bond donor and acceptor interaction analysis is also presented by determining the sigma profile and sigma potential of studied IL cations and anions used for gas hydrate mitigation for easy IL selection.     

A Meta-frontier method of decomposing long-term construction productivity components and technological gaps at the firm level: evidence from Malaysia

There is a need for a better approach to measure construction productivity rigorously, multilaterally, longitudinally and decomposed into its components. In response, this paper offers a robust approach to analysing construction productivity at the firm level that has been lacking in the industry to date, by measuring the Total Factor Productivity (TFP) of 37 public-listed Malaysian construction firms over 14 years (2003–2016), based on the Färe-Primont index. In comparing different groups of building, civil and specialist construction firms, this is the first application of a meta-frontier framework to capture the technological gaps involved. Based on the construction firms’ financial data, it is found that TFP improvement generally occurs due to Technical Efficiency (TE) and Scale-Mix Efficiency (SME) (largely scope economies), and significant technological gaps exist among different groups. Moreover, the industry suffered a decline in technologically related production environment over the period – prompting the conclusion that long-term policy engagement should focus on technological improvements. The paper provides a robust approach to analysing construction productivity at the firm level that also can be used for accessing productivity components and technological gaps in construction and other industries.