Cold isostatic pressing technique for producing highly efficient flexible dye‐sensitised solar cells on plastic substrates

One of the biggest challenges for making dye‐sensitised solar cells (DSCs) on plastic substrates is the difficulty in making good quality nanoporous TiO₂ films with both good mechanical stability and high electrical conductivity. Cold isostatic pressing (CIP) is a powder compaction technique that applies an isostatic pressure to a powder sample in all directions. It is particularly suitable for making thin films on plastic substrates, including non‐flat surfaces. Cold isostatically pressed nanocrystalline TiO₂ electrodes with excellent mechanical robustness were prepared on indium tin oxide (ITO)‐coated polyethylene naphthalate (PEN) substrates in the absence of organic binders and without heat treatment. The morphology and the physical properties of the TiO₂ films prepared by the CIP method were found to be very compatible with requirements for flexible DSCs on plastics. This room‐temperature processing technique has led to an important technical breakthrough in producing high efficiency flexible DSCs. Devices fabricated on ITO/PEN films by this method using standard P‐25 TiO₂ films with a Ru‐complex sensitiser yielded a maximum incident photon‐to‐current conversion efficiency of 72% at the wavelength of 530 nm and showed high conversion efficiencies of 6.3% and 7.4% for incident light intensities of 100 and 15 mW cm⁻², respectively, which are the highest power conversion efficiencies achieved so far for any DSC on a polymer substrate using the widely used, commercially available P‐25 TiO₂ powder. Copyright © 2011 John Wiley & Sons, Ltd.     

Theoretical studies of CO hydrogenation to methanol over Cu, Pd, and Pt metals

Theoretical studies of CO hydrogenation to methanol over Cu, Pd, and Pt metals have been carried out using a quasi‐relativistic density‐functional method. The metal surface is simulated by a M₁₀ cluster model. Reaction energies for the elementary steps involved are determined. The activation energies are estimated by the analytic BOC‐MP formula. The results support that these metals are active in CO hydrogenation to methanol. The rate‐determining steps are shown to be different for the metals. The highest activation energies of reaction on the metals fall in the order Cu < Pd < Pt, which corresponds to the order of the catalytic activities of the metals in CO hydrogenation. This revised version was published online in July 2006 with corrections to the Cover Date.     

Photo‐induced Charge Transfer and Relaxation of Persistent Charge Carriers in Polymer/Nanocrystal Composites for Applications in Hybrid Solar Cells

The photo‐induced charge transfer and the dynamics of persistent charge carriers in blends of semiconducting polymers and nanocrystals are investigated. Regioregular poly(3‐hexylthiophene) (P3HT) is used as the electron donor material, while the acceptor moiety is established by CdSe nanocrystals (nc‐CdSe) prepared via colloidal synthesis. As a reference system, organic blends of P3HT and [6,6]‐phenyl C₆₁‐butyric acid methyl ester (PCBM) are studied as well. The light‐induced charge transfer between P3HT and the acceptor materials is studied by photoluminescence (PL), photo‐induced absorption (PIA) and light‐induced electron spin resonance spectroscopy (LESR). Compared to neat P3HT samples, both systems show an intensified formation of polarons in the polymer upon photo‐excitation, pointing out successful separation of photogenerated charge carriers. Additionally, relaxation of the persistent charge carriers is investigated, and significant differences are found between the hybrid composite and the purely organic system. While relaxation, reflected in the transient signal decay of the polaron signal, is fast in the organic system, the hybrid blends exhibit long‐term persistence. The appearance of a second, slow recombination channel indicates the existence of deep trap states in the hybrid system, which leads to the capture of a large fraction of charge carriers. A change of polymer conformation due to the presence of nc‐CdSe is revealed by low temperature LESR measurements and microwave saturation techniques. The impact of the different recombination behavior on the photovoltaic efficiency of both systems is discussed.     

Lipid oxidation products of heated soybeans as a possible cause of protection from ruminal biohydrogenation

Heating oilseeds has been shown to improve the milk fatty acid profile when given to dairy cows, compared to raw oilseeds. However, results from published studies are conflicting. The conditions of heating and storage of the oilseeds could be responsible for these differences, probably partly through their effects on lipid oxidation, the products of which could act on ruminal biohydrogenation (BH). Thus, 15 different treatments were applied to ground soybeans: three levels of heating (no heating, 30 min at 110 or 150°C) × 5 ambient storage durations (0, 1, 2, 4, or 6 months). Soybeans were incubated in vitro with ruminal fluid for 6 h. Triacylglycerol (TAG) polymers, hydroperoxides and hydroxyacids (HOA), aldehydes, and fatty acids were assayed in soybeans and ruminal culture. No TAG polymer was detected in any treatment. Soybeans stored for a long time had a high content of HOA, whereas those heated at 150°C, whatever the storage duration, had high aldehyde contents. The percentage disappearance of cis‐9,cis‐12 18:2 and cis‐9,cis‐12,cis‐15 18:3 in incubates decreased significantly in cultures with heated soybeans, especially at 150°C, suggesting that this partial protection of polyunsaturated fatty acids (PUFA) from BH was at least in part linked to the aldehyde content of the heated soybeans. Practical applications: Oilseeds given to ruminants are often heated, and heat treatment is known to generate oxidation products. Knowing what oxidation products influence ruminal biohydrogenation of unsaturated fatty acids could result in technological processes allowing a better transfer of unsaturated fatty acids from oilseeds to ruminant products.     

1‐Arylsulfonyl‐5‐(N‐hydroxyacrylamide)indolines Histone Deacetylase Inhibitors Are Potent Cytokine Release Suppressors

A series of 1‐arylsulfonyl‐5‐(N‐hydroxyacrylamide)indolines ( 7 – 15 ) has been developed; the compounds exhibited potent histone deacetylase (HDAC) inhibitory activities. Notably, almost all of this series exhibited better HDAC‐inhibitory and antiproliferative activities than 3‐(1‐benzenesulfonyl‐1H‐indol‐5‐yl)‐N‐hydroxyacrylamide ( 6 ), as reported in a previous study. Among these compounds, 3‐[1‐(4‐methoxybenzenesulfonyl)‐2,3‐dihydro‐1H‐indol‐5‐yl]‐N‐hydroxyacrylamide ( 9 ) showed a two‐ to tenfold increase in activity compared to SAHA ( 1 ) in the suppression of lipopolysaccharide‐induced cytokine production. Compound 9 also caused a marked reduction in carrageenan‐induced acute inflammation in a rat model. Taken together, these data indicated that 1‐arylsulfonyl‐5‐(N‐hydroxyacrylamide)indolines HDAC inhibitors exhibit potent anti‐inflammatory activity.