YAG：Ce Phosphors for WLED via Nano-Pesudoboehmite Sol-Gel Route

The sub-micron sized YAG ： Ce phosphors were synthesized via a modified sol-gel method by peptizing nano-pesudoboehmite particulate. It is found that YAG phase from the dried gel powders appears at 1000 ℃ then the pure YAG phase exists at a relatively lower sintering temperature of 1400 ℃. The smaller sizes of phosphors in the ranges of 1 - 3 μm are obtained due to the contribution of seeding effects of nano-sized alumina particles to strengthen each step of the processes. Both the excitation and emission spectra of photoluminescence of the phosphor obtained at 1400 ℃ meet well with the spectroscopic requirements of the WLED phosphors.     

3.5代通信中链路自适应技术的研究和仿真

3.5代移动通信中的链路自适应技术使用自适应调制编码和快速混合重传技术替代了3代中使用的功率控制技术。仿真结果比较了这两种新技术与功率控制技术的性能,证明了这两个新技术显著地提高了网络平均的吞吐量。     

盐家油田油水井结垢原因探讨

对地层温度65～75℃的盐家油田油水井近井地带、井底、井筒发生严重结垢的原因进行了分析探讨。7口油井采出的地层水均为NaCO3型水．矿化度6．4～10g／L，HCO3浓度高（1．6～3．7g／L），Ca^2＋＋Mg^2＋浓度较低；1口水源井水及1口水井注入水为CaCl2型水，矿化度32～33g／L，Ca^2＋＋Mg^2＋浓度高（3．1～3．8g／L）而HCO3浓度低；采用CaCO3饱和指数法和CaSO4热力学溶解度法预测，在70℃下所有水样均有CaCO3结垢趋势，除3口油井采出的地层水外，均有CaSO4结垢趋势。3口油井采出的地层水与水源水在25℃按不同比例混合后，悬浮物含量大幅度上升。在70℃放置7天后再次大幅度上升，烘干的悬浮物易溶于稀盐酸．其主要成分为碳酸盐．说明注入水、地层水不配伍。1口电泵采油井和1口注水井油管垢样含盐酸可溶物（碳酸盐）超过90％。讨论了碳酸盐、硫酸盐垢的生成条件：温度、压力及pH值。图1表4参3。     

ANALYSIS AND PROCESSING OF LMF－COSTAS STEPPED FREQUENCY RADAR SIGNAL

Linear Modulated Frequency (LMF) Costas Stepped Frequency Radar (SFR) signal is introduced. Its ambiguity function is derived and analyzed in detail and its feasibility is validated in theory. The scheme of the proposed signal processing is also presented. The results of theoretic analysis and simulation show that, by using the proposed signal and increasing the bandwidth of the total stepped frequency, the ambiguity sidelobe is well suppressed and the range-velocity coupling in the stepped frequency radar is also greatly weakened.     

提高供电质量减少高校供电能耗的措施

分析了高校现有供电网络存在的效率低、能耗大和供电质量不稳定的问题。提出了在增加投资不多的条件下，通过改变供电的运行方式既提高供电质量又减少能耗的一些方法。     

绞车电控自动送钻装置离合器形式的探讨

目前电控自动送钻装置与绞车之间采用的径向或推盘气囊式离合器存在安全隐患,若采用气控齿式离合器+锁挡机构+行程开关组合的离合器形式,通过PLC智能化控制,可消除安全隐患,确保离合器工作可靠。简述了智能化控制的气控齿式离合器在电、机械、液压等驱动形式钻机上的应用原理,并指出气控齿式离合器在应用中应注意的事项。分析认为,从控制及钻井安全可靠的角度看,应大力推广使用智能控制的气控齿式离合器。     

Low surface energy films based on partially fluorinated isocyanates: the effects of curing temperature

Self-stratification strategy can be used to prepare films in which both bulk and surface properties can be optimized. By using this approach, only a very small quantity of fluorinated species is needed to generate a surface with low surface energy. When cross-linking is involved during film formation, we are dealing with a competition behavior between the diffusion of fluorinated species and the formation of cross-linked network. In this study low surface energy polymeric films were prepared on the basis of partially fluorinated polyisocyanates, in combination with hydroxyl-end-capped three-armed solventless liquid oligoesters and modified hyperbranched polyesters. At a fluorine concentration of only 0.5 wt.%, contact angles of water and hexadecane can reach 120° and 80°, respectively. A surface energy as low as 10–15 mN/m can be obtained upon the addition of less than 1 wt.% of fluorine in the films. It was shown, from real time ATR-FTIR and contact angle measurements, that the curing temperatures demonstrated significant effects on the cross-linking rate as well as on the wettability of the films.     

长江口北支水道水沙特性分析

从实测资料出发,结合水流数值计算成果,对长江口北支水道的水流、泥沙和含盐度等资料进行分析,得出了北支水道的水沙特性,并分析了水沙变化与河床变化的相互关系.北支水道在1958年南通河段河势控制后,径流分流比逐年下降,并渐趋稳定于3%左右.北支水道受径流影响越来越小,主要受潮流作用.随着水沙特性的逐年变化,北支水道0 m以下槽蓄容量逐年减小,并渐趋稳定,北支上段为逐年淤积最快的区域.由此反过来影响了水沙条件的进一步变化,使北支上段平均潮差增加,北支的会潮点由崇头附近下移至青龙港附近.     

Bioprocess applications of model-based estimation techniques

The last decade has seen the development of a number of approaches for estimating those variables which are difficult to measure on-line in industrial process situations. Whilst a range of techniques is available, a common element is the use of process knowledge in the form of a system model. In the case of bioprocess systems, although a large range of models has been presented in the literature, their use in estimation schemes on an industrial scale has been limited. A number of reasons can be identified for their low level of utilisation. Of particular significance is the uncertainty which exists in quantifying system performance and the process-model mismatch which inevitably results. The level of ‘pre-defined model’ uncertainty, together with the knowledge gained during the course of the fermentation, serves to dictate estimator structure. The paper considers a range of estimation strategies and contrasts, through industrial applications, their performance characteristics and utility.     

模糊综合评价技术在住宅综合性能评估中的应用研究

依据《商品住宅性能评定方法和指标体系》正确地对商品住宅地性能进行评价 ,是评定商品住宅质量等级的重要依据。本文主要论述如何运用数学方法分析和处理住宅综合质量评定中大量存在的模糊问题以及如何建立相应的等级评价准则和进行等级评判