Fundamental Understanding of Fouling Mechanisms During Microfiltration of Bitter Gourd (<Emphasis Type="Italic">Momordica charantia</Emphasis>) Extract and Their Dependence on Operating Conditions

Microfiltration of bitter gourd (Momordica charantia) extract using hollow fiber membrane module was carried out in the present study. To identify the dominant fouling mechanism, flux decline behavior was examined using Field model. At lower transmembrane pressure, pore blocking mechanism was found to be more important, while cake filtration was dominant at higher pressure. Higher cross flow rate reduced filtration constant indicating slower rate of membrane fouling. Additionally, surface and particle size analyses were undertaken to validate the findings of modeling. Scanning electron microscope analysis clearly showed prevalence of pore blocking mechanism at lower transmembrane pressure drop, whereas cake filtration was dominant fouling mechanism at higher pressure. Fourier transform infrared spectroscopy analysis supported the role of cake layer as a secondary membrane retaining some amount of polyphenols. Analysis of flux decline ratio also confirmed that for transmembrane pressure of 104 kPa and beyond, cake layer became compact, and hence, increase in cross flow rate was unable to influence the improvement of permeate flux. The current study provides an insight into the fouling mechanism involved in scaling up of clarification of bitter gourd extract for successful processing of this medicinal herb.     

Identification of ultraviolet radiation induced gallic acid and caffeic acid formation in palm juice (Borassus flabellifer) by HPLC & mass spectra technique

Palm juice, a common-cheap-antioxidants rich natural plant juice has been investigated for optimizing the effect of UV-radiation on the antioxidant activity using a DPPH free radical scavenging activity method. In this study separate set of samples of raw palm juice has been treated with 365 and 254 nm UV-lights (UVL) respectively for different exposure time. When exposed for 15 min with 365 nm UVL induces concentration factor of caffeic acid, whereas, 254 nm UVL induces gallic acid accumulation, but overall antioxidant activity was higher for 365 nm UV-radiation. Caffeic acid and other polyphenol compounds are increased by 5.5 ± 0.5 % than normal palm juice, observed after irradiation with 365 nm UVL. Even after the exposure of UV irradiation for 15 min, did not affect on peptide bond modification of protein molecules present in palm juice, therefore a green effect of UVL is explored for the effective increase of antioxidant activity.     

Aptamers Act as Activators for the Thrombin Mediated‐Hydrolysis of Peptide Substrates

Thrombin is the typical target in anticlotting therapy for many serious diseases such as heart attack and stroke. DNA aptamers are well‐known thrombin inhibitors that prevent fibrinogen hydrolysis. We have discovered that exosite‐targeting antithrombin aptamers enhance the activity of thrombin toward a small peptide substrate, Sar(N‐methylglycine)‐Pro‐Arg‐paranitroanilide, and that the activation of the enzyme by these aptamers is strongly inhibited by their complementary DNAs. Our study reveals that treatment with mixed aptamers or with a dual‐aptamer construct led to an 8.6‐ or 7.8‐fold enhancement in peptide hydrolysis relative to thrombin alone, a synergistic effect much higher than the activation observed with a monofunctional aptamer (1.5‐fold for Apt27 or 2.7‐fold for Apt15). In addition, we discovered that Apt27 is a biofunctional molecule for thrombin because of its activation effect. An enzyme kinetic study indicates that the binding of aptamers to exosites I and II significantly activates thrombin towards the peptide substrate, thus illustrating that binding of aptamers to exosites can allosterically regulate the active site of thrombin. Our study suggests the necessity of considering possible side effects when DNA aptamers are used for clinical applications involving the inhibition of thrombin‐mediated clotting.     

A compact interband tunneling current model for Gate-on-Source/Channel SOI-TFETs

A tunneling probability-based drain current model for tunnel field-effect transistors (FETs) is presented. First, an analytical model for the surface potential and the potential at the channel–buried oxide interface is derived for a Gate-on-Source/Channel silicon on insulator (SOI)-tunnel FET (TFET), considering the effect of the back-gate voltage. Next, a drain current model is derived for the same device by using the tunneling probability at the source–channel junction. The proposed model includes physical parameters such as the gate oxide thickness, buried oxide thickness, channel thickness, and front-gate oxide dielectric constant. The proposed model is used to investigate the effects of variation of the front-gate voltage, drain voltage, back-gate voltage, and front-gate dielectric thickness. Moreover, a threshold voltage model is developed and the drain-induced barrier lowering (DIBL) is calculated for the proposed device. The effect of bandgap narrowing is considered in the model. The model is validated by comparison with Technology Computer-Aided Design (TCAD) simulation results.     

Aperiodic multilayers with enhanced reflectivity for extreme ultraviolet lithography

We have developed novel aperiodic multilayers, covered by capping layers resistant to environmental attack, that offer superior performance for extreme ultraviolet lithography. We have designed these coatings using an optimization procedure based on an algorithm able to acquire domain knowledge inside the space of possible solutions. An integrated intensity increase of up to 2.18 times that obtained using standard periodic multilayers has been estimated. The aperiodic structures have minimal absorption in the topmost layers, which makes them especially insensitive to both the choice of capping layer material and any subsequent capping layer degradation due to oxidation or contamination. This property allows for the use of the most resilient capping layer materials available, thereby leading to a significantly improved lifetime. We have produced prototype capped aperiodic coatings and have measured their performance.     

Robust Stationkeeping Control for Libration Point Quasi-Periodic Orbits

Libration orbit stationkeeping controls are designed based on selected reference quasi-periodic orbit trajectories. The baseline trajectory is designed to meet science requirements and in the same time achieve minimum fuel consumptions. The success of finding libration point reference orbits is based on accurate numerical computation, dynamics, and space environment modeling. The linear quadratic regulator controller has been developed widely for maintaining a spacecraft in such libration orbit reference trajectories as close as possible. However, any dynamics models, including the circular restricted three-body dynamics, space environment, sensor, and actuator, are only approximations of real physical systems. Any noise and uncertainties can cause spacecraft’ motion to diverge due to the high instability region around libration points. This study investigates the modeling and designing of a passive robust μ controller and an active adaptive linear quadratic regulator in libration point stationkeeping controls around L1. The adaptive law in the linear quadratic regulator is used to estimate unknown gains of spacecraft’ subsystems. The results are compared for a family of libration orbits with reasonable ΔV yearly budgets under the influence of perturbations, noise, and unmodeled dynamics. The comparison with a publicly accessible work indicates that the controller developed in this work can provide comparable annual cost by nearly even including the worst case of perturbations.     

Improving beef color stability: Practical strategies and underlying mechanisms

This paper overviewed the current literature on strategies to improve beef color and attempted to logically explain the fundamental mechanisms involved. Surface color and its stability are critical traits governing the marketability of fresh beef when sold, whereas internal cooked color is utilized as an indicator for doneness at the point of consumption. A multitude of exogenous and endogenous factors interact with the redox biochemistry of myoglobin in post-mortem skeletal muscles. The scientific principles of these biomolecular interactions are applied by the meat industry as interventions for pre-harvest (i.e. diet, animal management) and post-harvest (i.e. packaging, aging, antioxidants) strategies to improve color stability in fresh and cooked beef. Current research suggests that the effects of several of these strategies are specific to type of animal, feeding regimen, packaging system, and muscle source. Meat scientists should explore novel ways to manipulate these factors using a biosystems approach to achieve improved beef color stability, satisfy consumer perception, and increase market profitability.     

Primary structure of turkey myoglobin

Our objective was to determine the amino acid sequence of turkey myoglobin. Turkey myoglobin was isolated from cardiac muscles via ammonium sulphate precipitation and gel-filtration chromatography. Purified turkey myoglobin, separated as a 17 kDa band in SDS–PAGE, was subjected to digestion with trypsin or aspartic acid endopeptidase. The resulting peptides were separated by reverse-phase HPLC, and then subjected to Edman degradation to obtain the amino acid sequence. The complete amino acid sequence of turkey myoglobin was determined and compared with that of poultry and red meat myoglobins. Turkey myoglobin has 153 amino acids and nine histidine residues. Proximal (position 93) and distal (position 64) histidine residues, responsible for maintaining the stability of haeme, are conserved in turkey myoglobin. Turkey myoglobin shares 100% sequence similarity with chicken myoglobin, whereas it shares 92.5% homology with ostrich, 76.5% with pig, and less than 73% with ruminant myoglobins.     

Modeling of cross flow ultrafiltration of stevia extract in a rectangular cell

Prediction of ultrafiltration performance during clarification of pre-treated stevia extract by cross flow ultrafiltration in a rectangular cell is presented in this work. The steady state performance is modeled by using classical film theory. The transient state behaviour is quantified by using a model available in literature. In the model, higher molecular weight solutes are clubbed in one gel-forming component and Stevioside is assumed to be other component. In the process of modeling, the gel characteristics are estimated. Both total recycle and batch concentration mode of operations are modeled. The model results are in good agreement with the experimental data.     

Fluorescence Polarization Immunoassay for Rapid, Accurate and Sensitive Determination of Ochratoxin A in Wheat

A sensitive and accurate fluorescence polarization (FP) immunoassay has been developed for the determination of ochratoxin A (OTA) in naturally contaminated wheat samples. A fluorescein-labeled OTA tracer was synthesized, and its binding response with three monoclonal antibodies was tested. The most sensitive competitive FP immunoassay showed an IC₅₀ value of 0.48 ng/mL with a negligible cross-reactivity for ochratoxin B (1.7 %) and no cross-reactivity with other mycotoxins commonly occurring in wheat. The wheat sample was extracted with acetonitrile/water (60:40, v/v) and purified by a rapid solid-phase extraction procedure using an aminopropyl column prior to the FP immunoassay. The overall time of analysis was less than 20 min. The average recovery from spiked wheat samples (3 to 10 μg/kg) was 87 %, with relative standard deviations generally lower than 6 %. Limits of detection and quantification were 0.8 and 2.0 μg/kg, respectively. The trueness of the method was assessed by using two reference materials for OTA showing good accuracy and precision. A good correlation (r?=?0.995) was observed between OTA contamination of 19 naturally contaminated wheat samples analyzed by both FP immunoassay and high-performance liquid chromatography/immunoaffinity clean-up used as reference method. These results show that the developed FP method is suitable for high-throughput screening, as well as for reliable quantitative determination of OTA in wheat at level far below the EU regulatory limits.