Practical Equivalent Continuum Model for Simulation of Jointed Rock Mass Using FLAC3D

A simple practical equivalent continuum numerical model for simulating the behavior of jointed rock mass has been extended to three-dimensional using FLAC3D. This model estimates the properties of jointed rock mass from the properties of intact rock and a joint factor (Jf), which is the integration of the properties of joints to take care of the effects of frequency, orientation, and strength of joint. A new FISH function has been written in FLAC3D specifically for modeling jointed rocks using the Duncan and Chang hyperbolic model. This model has been validated first with simple element tests at different confining pressures for different rocks with different joint configurations. Explicit modeling of the joints has also been done in element tests and results obtained compare well with the results of equivalent continuum model and also with experimental results. Further, this has been applied for a case study of a large underground power house cavern in the Himalayas. The analysis has been done under various stages of excavation, assigning a null model available in FLAC3D for simulating the excavation.     

Progress in deep-UV photoresists

Higher resolution can be achieved in lithography by decreasing the wavelength of the exposure source. However, resist material and their processing are also important when we move to a shorter wavelength lithography technology. This paper reviews the recent development and challenges of deep-UV photoresists and their processing technology.     

Overlay techniques for scratchpad memories in low power embedded processors

Energy consumption is one of the important parameters to be optimized during the design of portable embedded systems. Thus, most of the contemporary portable devices feature low-power processors coupled with on-chip memories (e.g., caches, scratchpads). Scratchpads are better than traditional caches in terms of power, performance, area, and predictability. However, unlike caches they depend upon software allocation techniques for their utilization. In this paper, we present scratchpad overlay techniques which analyze the application and insert instructions to dynamically copy both variables and code segments onto the scratchpad at runtime. We demonstrate that the problem of overlaying scratchpad is an extension of the Global Register Allocation problem. We present optimal and near-optimal approaches for solving the scratchpad overlay problem. The near-optimal scratchpad overlay approach achieves close to the optimal results and is significantly faster than the optimal approach. Our approaches improve upon the previously known static allocation technique for assigning both variables and code segments onto the scratchpad. The evaluation of the approaches for ARM7 processor reports, average energy, and execution time reductions of 26% and 14% over the static approach, respectively. Additional experiments comparing the overlayed scratchpads against unified caches of the same size, report average energy, and execution time savings of 20% and 10%, respectively. We also report data memory energy reductions of 45%-57% due to the insertion of a 1024-bytes scratchpad memory in the memory hierarchy of a digital signal processor (DSP).     

Surface Hardening of High-Strength Low Alloy Steels (HSLA) Dual-Phase Steels by Ball Burnishing Using Factorial Design

Burnishing is used increasingly as a finishing operation which gives additional advantages such as increased hardness, fatigue strength, and wear resistance. Experimental work based on 3⁴ factorial design was carried out to establish the effects of ball burnishing parameters on the surface hardness of high-strength low alloy steels (HSLA) dual-phase (DP) steel specimens. Statistical analysis of the results shows that the speed, feed, lubricant and ball diameter have significant effect on surface hardness.     

Two residues that may ligate Ca2+ in transmembrane domain six of the plasma membrane Ca(2+)-ATPase

In order to identify Ca2+ ligands in the putative transmembrane domain 6 of the plasma membrane Ca2+ pump, amino acids Asn879, Met882, Asp883, and Ser887 were singly altered. Asn879, Met882, and Asp883 were chosen because the corresponding amino acids have been proposed as Ca2+ ligands in the sarcoplasmic reticulum Ca2+ pump (Clarke, D. M., Loo, T. W., and MacLennan, D. H. (1990) J. Biol. Chem. 265, 6262-6267). For the alterations, a fully active truncated version of the pump was used, because the interaction of Ca2+ with the pump could be studied without interference from calmodulin binding. The mutants at Asn and Asp did not carry out ATP-supported Ca2+ uptake and formed no acylphosphate from [gamma-32P]ATP, suggesting that, like the corresponding amino acids in the sarcoplasmic reticulum Ca2+ pump, these two are Ca2+ ligands. However, all the mutants at the position of Met882 showed some activity. Indeed, the Met882--> Ile mutant was fully active at a saturating Ca2+ concentration and only the K1/2 for Ca2+ activation was shifted slightly upward. Converting the Met to Thr (which is the corresponding residue in the sarcoplasmic reticulum Ca2+ pump) reduced the activity to 20% of the wild type, further emphasizing the differences between the two Ca2+ pumps. The mutant Ser887--> Ala was expressed in greater amounts than, and had a specific activity about 50% higher than, the wild type, indicating that this serine also could not be a Ca2+ ligand and could not replace the missing Thr at position Met882.     

"Significance of serum gamma glutamyl transpeptidase in cholestatic jaundice"

In conclusion, our study showed that serum G.G.T rises in cholestasis, and the rise is significantly higher in extraphepatic cholestasis as compared to intrahepatic cholestasis. Serum G.G.T has not shown any superiority over alkaline phosphatase in the evaluation of cholestatic liver disease. However, two considerations must caution against the use of serum G.G.T. alone for evaluation of hepatobiliary disease. The first of these is the lack of specificity for hepatobiliary disease. Serum G.G.T. activity can be elevated in some non-hepatic disorders such as acute pancreatitis, congestive cardiac failure, myocardial infarction, diabetes mellitus and alcoholism. Determination of serum G.G.T. in these patients is of no value. Second, the possibility that changes in serum G.G.T. activity results from drug administration in man.     

Raman studies of structural rearrangements induced in human plasma lipoprotein carotenoids by malondialdehyde

Raman and resonance Raman spectra of plasma lipoproteins ± malondialdehyde were studied at concentrations which block the normal receptor-mediated uptake by cells. The strong resonance Raman bands at about 1010, 1162 and 1530 cm⁻¹, due to the presence of carotenoids in the lipoproteins, are envisaged as structural probes. High resolution resonance Raman spectra of the 1500–1600 cm⁻¹ region reveal multiple features suggesting the coexistence of several structural populations of β-carotene whose precise assignment is complex. When plasma lipoproteins are reacted with malondialdehyde, a complex change occurs in the resonance Raman banding of β-carotene in the 1500–1600 cm⁻¹ region. Malonaldehyde (MDA) also modifies the acoustical region (70–200 cm⁻¹ of low density lipoprotein (LDL) lipids. We suggest that malondialdehyde association with plasma lipoproteins alters the lipid structure via apoprotein or apoprotein/lipid associations.     

Development of nano indium tin oxide (ITO) grains by alkaline hydrolysis of In(III) and Sn(IV) salts

Indium tin oxide (ITO) nano powders of different compositions (In: Sn = 90: 10, 70: 30 and 50: 50) were prepared by heat treatment (300-450°C) of mixed hydroxides of In(III) and Sn(IV). The hydroxides were obtained by the reaction of aq. NH₃ with mixed aq. solutions of In(NO₃)₃ and SnCl₄. FTIR and TG/DTA studies revealed that powders existed as In(OH)₃H₂O—SnO₃H₂H₂O in the solid state and then they transformed to In₂O₃—SnO₂ via some metastable intermediates after 300°C. Cubic phase of In₂O₃ was identified by XRD for the oxides up to 30% of Sn. Particle size measurements of the solid dispersed in acetone and SEM study for microstructure showed that the oxides were in the nano range (55-75 nm) whereas the size range determined from Debye-Scherrer equation were 11–24 nm.     

Wavelet based Denial-of-Service detection

Network Denial-of-Service (DoS) attacks that disable network services by flooding them with spurious packets are on the rise. Criminals with large networks (botnets) of compromised nodes (zombies) use the threat of DoS attacks to extort legitimate companies. To fight these threats and ensure network reliability, early detection of these attacks is critical. Many methods have been developed with limited success to date. This paper presents an approach that identifies change points in the time series of network packet arrival rates. The proposed process has two stages: (i) statistical analysis that finds the rate of increase of network traffic, and (ii) wavelet analysis of the network statistics that quickly detects the sudden increases in packet arrival rates characteristic of botnet attacks.Most intrusion detections are tested using data sets from special security testing configurations, which leads to unacceptable false positive rates being found when they are used in the real world. We test our approach using data from both network simulations and a large operational network. The true and false positive detection rates are determined for both data sets, and receiver operating curves use these rates to find optimal parameters for our approach. Evaluation using operational data proves the effectiveness of our approach.