Radiation tolerance of type IIa synthetic diamond detector for 14 MeV neutrons

Radiation tolerance of a type IIa synthetic diamond detector was examined from irradiation of mono-energetic 14 MeV neutrons. Measurements of I–V (current–voltage) characteristics and energy spectrum for 5.486 MeV alpha particles were performed after neutron irradiation. In the I–V characteristics measurement, enhancement of rectification was observed after neutron irradiation of up to 2.0 × 10¹² n/cm². Concurrently with the enhancement of rectification, significant decrease in signal amplitude was observed in energy spectrum measurement for alpha particles. It is considered that these changes were due to increase in the concentration of defects acting as shallow energy levels in the forbidden band. For neutron irradiation of higher than 1.6 × 10¹³ n/cm², weakening of the rectification characteristics and recovery of the signal amplitude were observed. These changes imply that deep energy levels, which were also considered to be introduced by defects, were dominant and weakened the effects of the shallow energy levels. Increase in the concentration of the deep trapping levels resulted in gradual decrease of the signal amplitude and degradation in the energy resolution. The peak for the alpha particles was obtained up to 5.5 × 10¹³ n/cm².     

Athermal silica-based arrayed-waveguide grating multiplexer

A temperature dependent channel wavelength shift in a silica-based arrayed-waveguide grating multiplexer is successfully suppressed from 0.95 to 0.05 nm in the 0-85°C temperature range, which means that it can be used in practical WDM systems without the need for temperature control     

IRISTER - magneto-optical disk for magnetically inducedSuperResolution

IRISTER (IRIS Thermal Eclipse Reading) is a remarkable technique for achieving superresolution in optical disks. Two applications of IRISTER are Magnetically induced SuperResolution (MSR) and Premastered optical disk by SuperResolution (PSR). Magnetically induced SuperResolution (MSR) has been realized in magneto-optical disks using exchange-coupled magnetic multilayer films. Two new detection methods have been developed. In the front aperture detection (FAD) method, the heated area in the light spot works as an optical mask so that the signal is read out only from the remaining crescent-shaped area in the spot. In the rear aperture detection (RAD) method, the signal is read out only from the heated area. The cutoff spatial frequency for both types of detection is more than two times higher than that in conventional detection. A high C/N of 42 dB is obtained in the MSR disks by both methods for a mark length of 0.3 μm, which is much shorter than the optical limit. Premastered optical disk by SuperResolution (PSR) has been realized in read-only optical disks using phase-change materials. In the front aperture detection (FAD) method for PSR, the prerecorded signal is read out only from the high reflective crescent-shaped area in the light spot, because the reflectance of the heated area is too low. A C/N of 51 dB for a mark length of 0.3 μm has been obtained for the PSR disk     

Aprotinin reduces homologous blood transfusions when pediatric cardiac surgery must be redone

The hemostatic effect of aprotinin in pediatric cardiac surgery is controversial. This study demonstrated the usefulness of aprotinin in cases undergoing additional surgery. In a retrospective study, three groups of children were investigated. In group I (n = 10), no aprotinin or Cell saver was used (control). In group II (n = 12), Cell saver was used intraoperatively. In group III (n = 14), aprotinin 30,000 KIU/kg was added to the prime of cardiopulmonary bypass, and another 10,000 KIU/kg was given every hour during extracorporeal circulation. Both blood loss and use of homologous blood during operation were significantly (p < 0.01) reduced in group III compared to those in the other two groups. In group III, blood loss both 12 and 48 hours postoperatively were one-third less than those in group I (no significant difference). The use of homologous blood 48 hours postoperatively was significantly reduced in group III compared to that in group I (p < 0.01) or group II (p < 0.05). We conclude that aprotinin administration during cardiopulmonary bypass reduced blood loss and homologous blood requirements both operatively and postoperatively when pediatric cardiac surgery must be redone.     

Possibility of superconductivity with highT c in La-Sr-Nb-O system

We prepared La-Sr-Nb-O system samples both in bulk form and as a film, with sharp resistive transitions at temperatures of 228–323 K, depending on the annealing conditions. The sharp resistive transitions might be attributable to superconductivity. Magnetic ordering was observed over a narrow temperature range around 40 K for some of the samples.     

The Effect of Small Additions of Fe and Heavy Deformation on the Precipitation in an Al–1.1Mg–0.5Cu–0.3Si At. Pct Alloy

Metallurgical and Materials Transactions A - The effect of 0.03 and 0.08 at. pct Fe additions on the formation of secondary phases in an Al–1.1Mg–0.5Cu–0.3Si at. pct alloy was...     

New ring-opening polymerization via a π-allylpalladium complex

Summary A binary system of a palladium complex as catalyst and zinc alkoxide as initiator conducted a novel ring-opening polymerization of cyclic carbonate, i. e., 5,5-dimethyl-4-ethenyl-1,3-dioxan-2-one. The polymerization proceeded along with releasing carbon dioxide to produce the corresponding polyether. The -allylpalladium complex generated from the monomer with the catalyst is the key intermediate for this new polymerization. The propagating end is zinc alkoxide, which nucleophilically attacks the monomer activated as the -allylpalladium complex in the propagation.     

Phase structure in the blend of atactic poly(vinyl alcohol) with atactic poly(vinyl alcohol‐block‐vinyl acetate)

An almost fully saponified atactic poly(vinyl alcohol) and an atactic poly(vinyl alcohol‐block‐vinyl acetate) of which degree of saponification is 89 mol % were blended by a solution casting method. The phase structure of the blend film was analyzed by optical microscopy, ¹³C‐NMR, and differential scanning calorimetry. The most remarkable structure of the blend was composed of cylindrical domains penetrating the film. The swelling behavior of the blend films was also investigated in the dimethylsulfoxide and water mixed solvents to find differences in solubility and diffusion behavior between the matrix and the domain. The cylindrical domains could be selectively dissolved away in water and the film became porous. We tried to change the size of the cylindrical domain with various film preparation conditions. This aimed to turn the film into the useful filter membrane. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 1807–1815, 2002     

Gelation of poly(vinyl alcohol) solutions at low temperatures (20 to −78°C) and properties of gels

The flow points of atactic poly(vinyl alcohol) (a-PVA) gels with H₂O/dimethyl sulfoxide (DMSO) = 90/10 (v/v) chilled at 20 to ?78°C for 24 h depended on the chilling temperature and were 0–30°C for gels with the initial polymer concentrations (C_i) of 2–5 g/dL, whereas those for H₂O/DMSO = 50/50 chilled at 0 to ?78°C were independent of the chilling temperature and were 70–75°C. Syneresis occurred after eight cycles of freezing (?24°C) and thawing (20°C) for a-PVA hydrogels at concentrations above C_i = 4 g/dL and two such cycles for syndiotacticity-rich PVA (s-PVA) hydrogels at concentrations above C_i = 1 g/dL. The extent of syneresis per one cycle for s-PVA hydrogels was higher than that for a-PVA hydrogels at the initial cycles. In the a-PVA hydrogels with an initial polymer concentration of ca. 30 g/dL, syneresis was expected not to occur even after 20 cycles. If all the free water in the gels is assumed to have transuded by syneresis after 20 cycles, the residual water is bound water and is estimated to be six water molecules per one vinyl alcohol monomer unit. © 1994 John Wiley & Sons, Inc.     

A PRACTICAL METHOD FOR RECTIFYING INTERFACIAL TENSION DATA TO PREDICT THE SHAPE OF INTERFACES IN AN IMMISCIBLE LIQUID/LIQUID/GAS SYSTEM

The shape of interfaces formed by the contact of two liquid phases, immiscible with each other, and a gaseous phase can be predicted on the condition that the tension to work at each interface is known with a sufficient accuracy. In general, interfacial tension data available are not so accurate, however, as to be useful as they are in predicting the shape of interfaces, particularly when the spreading coefficient of either liquid (liquid 1) on the other (liquid 2) has a negative value of a small magnitude. Presented in this note is a simple method to rectify the interfacial tension data, with the aid of a measurement of the radius of a lens of liquid 1 of a known volume placed on the horizontal surface of liquid 2, and thereby make them usable for predicting interfacial geometries. The method is tested by applying it to benzene/water and n-pentane/water systems.