Properties of indium oxide/tin oxide multilayered films prepared by ion-beam sputtering

The preparation and characterization of indium oxide (InO _x )/tin oxide (SnO _y ) multilayered films deposited by ion-beam sputtering are described and compared with indium tin oxide (ITO) films. The structure and the optoelectrical properties of the films are studied in relation to the layered structures and the post-deposition annealing. Low-angle X-ray diffraction analysis showed that most films retained the regular layered structures even after annealing at 500° C for 16 h. As an example, we obtained a resistivity of 6×10^–4 cm and a transparency of about 85% in the visible range at a thickness of 110 nm in a multilayered film of InO _x (2.0 nm)/SnO _y (0.2 nm)×50 pairs when annealed at 300° C for 0.5 h in air. Hall coefficient measurements showed that this film had a mobility of 17 cm² V^–1 sec^–1 and a carrier concentration (electron density) of 5×10²⁰ cm^–3.     

Deformation of NiO single crystals below room temperature: dislocation configurations

NiO single crystals prepared by two crystal growth techniques (zone melting in an arc-image furnace and Verneuil crystallization have been deformed by compression along 001 at temperatures as low as 4.2 K, and the dislocation substructure observed by transmission electron microscopy. The Peierls mechanism has been suggested as the mechanism controlling the mechanical behaviour at the lower temperatures. The dislocations generated at cavities found in the zone-melted crystals may be responsible for the increase of the flow stress of these crystals compared with the Verneuil ones.     

Surface tension of liquid3He and4He near the liquid-gas critical point

The surface tension of liquid³He and⁴He was measured near the gas-liquid critical points in the reduced temperature range 3×10^–4–1, where t (T _c –T)/T _c . The critical exponents were found to be ₃=1.289±0.015 for³He and ₄=1.306±0.017 for⁴He. These values are very close to those for classical liquids, and are consistent with the value of 1.28 predicted by Widom, but are apparently different from the exponents previously obtained for liquid helium isotopes, which are near unity. The critical coefficients show good agreement with the quantum-corrected corresponding states theory for the Lennard-Jones 6–12 potential discussed by Young. The interface thickness is deduced from Widom's theory to bed=d ₀t^–v withd ₃₀=0.14±0.03nm and v₃=0.57±0.04 for³He, andd ₄₀=0.37±0.07 nm and v₄=0.58±0.01 for⁴He.     

NANO-MULTILAYERS WITH HIGH PERPENDICULAR ANISOTROPY FOR MAGNETIC RECORDING

(FePt/Ag)n nano-multilayers were deposited on MgO (100) single crystal with laser ablation and then subjected to annealing. FePt L1o grains with (001) texture and thus a large perpendicular magnetic anisotropy constant Ku of the order of 106 J/m3 were formed. A thick Ag layer is found to be favorable for decreasing the dispersion of the easy axis for magnetization. The measurement of time decay of magnetization gave rise to a small activation volume of the order of 10-25m3, showing the promising of being the recording medium for future high density perpendicular recording.     

Age-related accumulation of phosphatidylcholine hydroperoxide in cultured human diploid cells and its prevention by α-tocopherol

The levels of phosphatidylcholine hydroperoxide in serially cultured human fetal diploid fibroblasts at various population doubling levels were determined by high-performance liquid chromatography combined with chemiluminescence detections. This methodology utilizes a mixture of cytochromec and luminol as post-column hydroperoxide group specific luminescent reagents. The cellular hydroperoxide content increased with age from 0.34 to 27.72 pmol/10⁶ cells. At the end of the cells'in vitro lifespan (51st population doubling level), the hydroperoxide content per 10⁶ cells reached about 80 times the level found in cells of the 20th population doubling level. Supplementation of exogenous α-tocopherol to the culture medium prevented hydroperoxide accumulation, but did not extent the lifespanin vitro. The results indicate that substantial intracellular phospholipid hydroperoxide accumulation occurred in the course of aging of human fetal liploid fibroblasts.     

New ring-opening polymerization via a π-allylpalladium complex

Summary A binary system of a palladium complex as catalyst and zinc alkoxide as initiator conducted a novel ring-opening polymerization of cyclic carbonate, i. e., 5,5-dimethyl-4-ethenyl-1,3-dioxan-2-one. The polymerization proceeded along with releasing carbon dioxide to produce the corresponding polyether. The -allylpalladium complex generated from the monomer with the catalyst is the key intermediate for this new polymerization. The propagating end is zinc alkoxide, which nucleophilically attacks the monomer activated as the -allylpalladium complex in the propagation.     

Examination of acetolysis products of phosphatidylcholine by gas chromatography-mass spectrometry

A comparison of monoacetyldiglycerides obtained from authentic phosphatidylcholines by acetolysis with those obtained by phospholipase C-acetylation was made to examine the intermolecular acyl migration, the intramolecular acyl migration between C-1 and C-2, and the formation of 1,3-isomer in the acetolysis reaction. Egg yolk phosphatidylcholine also was used. It was revealed that is acetolysis, the intermolecular acyl migration and selective degradation of polyunsaturated fatty acids did not take place at all. The intramolecular acyl migration, including the formation of 1,3-isomer, occurred to a small extent. Appreciable difference was not found in comparison of molecular species compositions of monoacetyldiglycerides derived by both methods from egg yolk phosphatidylcholine, except small differences found in the contents of two kinds of molecular species.     

Polymerization of epoxide with aluminum complex/silanol catalyst. VII. Thermal and electrical properties of epoxy resin cured with the new catalyst

Curing catalyst for epoxy resins was newly found. The catalyst consists of aluminum complex and silanol. Lack of one component of the pair does not cure epoxy resins. The epoxy resins cured with the catalyst are characterized by excellent electrical properties, especially at high temperature, due to the absence of strong acid species in the cured epoxy resin matrix. Heat-resistant property of the resin was also excellent. These properties were compared with those of epoxy resin cured with commonly used BF₃ complex.