Multielemental analysis of purpleback flying squad using high resolution inductively coupled plasma-mass spectrometry (HR ICP-MS)

Forty-four elements were analyzed in 21 tissues of purpleback flying squid, Sthenoteuthis oualaniensis, by high resolution inductively coupled plasma-mass spectrometry (HR ICP-MS) and inductively coupled plasma atomic emission spectrophotometry (ICP-AES). Greater concentrations of V, Fe, Co, Ni, Cu, Ag, Cd, Pb, and Bi were found in liver, pancreas, and ink sac than in other tissues. Ink sac concentrated remarkable levels of Ca and Sr in addition to the above-mentioned elements. Several alkalis, alkaline earth, and rare earth elements preferentially accumulated in muscle. Among the hard tissues, accumulation of V and U in beak, Ni, Zn, and Cd in gladius and Cr in skin was prominent. K, Rb, Cs, Pb, Bi and some transition elements (V, Co, Cu, Zn, Ag, Cd) were significantly (p < 0.05) higher in the livers of adult than in juvenile squids. Sodium, alkaline earth, and rare earth elements were higher in the livers of juveniles than in adult squids.     

Ketones from carboxylic acids over supported magnesium oxide and related catalysts

Silica-supported alkaline earth oxides revealed excellent activity to convert acetic acid selectively into acetone in a vapor-phase fixed-bed flow system. Acetone was obtained through the cyclic formation of alkaline earth acetate followed by decomposition. Magnesium oxide should be supported on the silica surface without formation of magnesium silicate, which was inactive for the present reaction. Attempted syntheses of benzophenone and acetophenone are also described.     

An outbreak of food-borne listeriosis due to cheese in Japan, during 2001

Food-borne outbreaks caused by Listeria monocytogenes have been recognized in US and European countries. Only sporadic cases, of neonatal listeriosis, have been reported in Japan. Since L. monocytogenes has been often isolated from foods in Japan, food-borne outbreaks potentially could have occurred. In February 2001, L. monocytogenes serotype 1/2b was isolated from a washed-type cheese during routine Listeria monitoring of 123 domestic cheeses. Further samples from products and the environments at the plant that produced the contaminated cheese were examined for L. monocytogenes. L. monocytogenes serotype 1/2b was detected in 15 cheese samples, at most probable number that ranged from <30 to 4.6 x 10(9)/100 g, and in environmental samples. Studies with people who had consumed cheese from the plant revealed 86 persons who had been infected with L. monocytogenes. Thirty-eight of those people had developed clinical symptoms of gastroenteritis or the common cold type after the consumption of cheese. Isolates from those patients exhibited the same serotype, pathogenicity for mice and HeLa cells, DNA fingerprinting patterns and PCR amplification patterns. From the epidemiological and genetic evidence, it appeared that the outbreak was caused by cheese. This is the first documented incidence of food-borne listeriosis in Japan.     

Current dependence of performance of TES microcalorimeters and characteristics of excess noise

We are developing transition edge sensor (TES) microcalorimeter arrays for future Japanese astronomy missions. Although 6.6 eV energy resolution for 5.9 keV and 74 μs decay time are achieved, our energy resolution was limited by the excess noise of unknown origin. The dominant noise showed 1/R dependence and it only appeared when the current through the TES, I, is larger than 10 μA. This is explained if we assume a constant voltage noise source with a level of 2(4kT_CR_n)^1/2. We also investigated the influence of I on the TES performance and found the TES sensitivity is reduced when the ratio of current to the critical current I/I_C is large. It can explain the reduction of observed when operated without a magnetic shield. We also found a strong correlation between I_C and or the baseline width. Thus, we conclude that I_C is an essential parameter for the TES performance.     

Improvement and induction property of radiation-responsive promoter through DNA shuffling of 5′-flanking regions of the human p21 gene

A promoter that augments gene expression in response to stimulation of ionizing radiation would be a desired tool for radiogenetic therapy, a combination of radiotherapy and gene therapy. Although various promoters occurring naturally or artificially have been used for researches, one showing higher reactivity to ionizing radiation is desirable. In the present study, we attempted to improve a radiation-responsive promoter of the p21 through a technique called DNA shuffling. A library of DNA fragments was constructed by re-ligation of randomly digested promoter fragments and improved promoters were chosen out of the library. We repeated this process twice to obtain a promoter showing 2.6-fold better reactivity to ionizing radiation compared with its parent, p21 promoter after 10 Gy γ-ray irradiation. Nucleotide sequence analyses revealed that the obtained promoter was densely packed with some of the cis-acting elements including binding sites for p53, NF-κB, NRF-2, AP-1 and NF-Y more than p21 promoter. In addition, it was shown that its induction by ionizing radiation was dependent upon p53 status of a cell line, suggesting that the promoter retained properties of the p21 promoter. This technique is simple and efficient to improve a promoter responsive to other stimulus of interest besides IR.     

Thermodynamic Properties of Ionic Semiclathrate Hydrate Formed with Tetrabutylammonium Propionate

The phase equilibrium temperature and dissociation heat of tetrabutylammonium propionate (TBAPr) hydrate are reported. TBAPr hydrate is a type of ionic semiclathrate hydrates and also could potentially be used as thermal energy storage material. The temperature‐composition phase diagram of the TBAPr hydrate was determined in a defined range of mass fractions. Considering the dissociation heat of differential scanning calorimetry (DSC) measurements, multiple peaks of heat flow were observed in the TBAPr‐water system at the TBAPr mass fraction lower than 0.35, and there was a single peak at the mass fraction higher than 0.37.     

Mean molal activity coefficients of aqueous scandium chloride, nitrate, bromide and perchlorate solutions at 25.0°

The mean molal activity coefficients of aqueous scandium chloride, nitrate, bromide and perchlorate solutions were determined at 25.0° for dilute to saturated concentrations, together with the activities of water. In the dilute solutions of scandium halides, the activity coefficients were obtained from electromotive force measurements on galvanic cells, and the osmotic coefficients of all four solutions above 0.1 mol kg⁻¹ were determined from the isopiestic measurements. Least-squares equations were fitted to these coefficients, which were then used to calculate the mean molal activity coefficients and water activities. The relationships between these results and the corresponding activity data for other rare earth salts, and to the cation hydration and ionic interactions, are discussed. The results on scandium perchlorate solutions suggested that the inner-sphere hydration number of tervalent scandium ion may be seven.     

Effect of applying voltage on photocatalytic destruction of 1,4-dioxane in aqueous system

In the current work, we prepared a TiO₂ coating on stainless mesh using electrophoretic deposition (EPD), and applied voltage to a stainless mesh to examine the synergy effect on photocatalysis of both 1,4-dioxane and ethylene glycol diformate (EGDF), a main intermediate of the photocatalysis of 1,4-dioxane. The photocatalytic decomposition rate of 1,4-dioxane depends on applying voltage under diffusion-limited reaction conditions. Ethylene glycol diformate and 1,4-dioxane exhibited inverse voltage dependence. Voltage swing provides high-efficiency photocatalysis of 1,4-dioxane while suppressing EGDF formation. This method will be effective for a photocatalysis system containing several chemicals, each with different voltage dependence.     

Shear properties of metal-free wooden load-bearing walls using plywood jointed with a combination of adhesive tape and wood dowels

In this study, the potential of wood-only (metal-free) load-bearing walls was proposed and tested based on the idea of using the same type of material throughout wherever possible while improving basic properties such as strength, sound insulation, and heat insulation. Specifically, a technique was tested of combining pressure sensitive adhesive tape and wood dowels in place of nails for load-bearing structures with panel reinforcement represented by wood-frame construction. For this paper, its strength was evaluated by conducting in-plane shear tests, which revealed that the initial rigidity and maximum load of the proposed test specimens were greater than that of specimens using nails for jointing. However, the shear load factor, which is calculated based on some strength parameters and which forms the foundation of housing strength design, was slightly lower than that of the nail-jointed specimen. This was because there was a large decline in post-collapse resistance and a lower calculated absorbed energy caused by brittleness. The early detachment of panels was also revealed as a problem in the tests.     

Effect of Zn, Ni and Fe Impurities on Bi2Sr1.6La0.4CuO6+��

We measured the change of T _c with the doping of the magnetic and nonmagnetic impurity in Bi₂Sr_1.6La_0.4CuO_6+?? (Bi2201). The reduction of T _c is about 20% in samples with Zn (1.1%), Ni (1.0%), and Fe (1.2%), and a slight difference was observed among these samples. We also observed the resonance peak at the Zn-impurity site by scanning tunneling spectroscopy at 4.2 K. The observed resonance peak showed the four-fold symmetry, and appeared at approximately ?1.5 meV.