复杂背景下设备防篡改技术的研究

当今社会,科学技术飞速发展,传统的设备防篡改技术面临巨大挑战。为此,本文提出一种复杂背景下基于图像分割和识别的设备防篡改方法。利用涂有红外涂料的标识条,以检测设备是否被篡改。在MATLAB下进行仿真分析,通过图像预处理、图像分割、图像数学形态学处理等一系列操作,最终得到正确标识条的图像,证明本文方法的可行性,并对基于图像分割和识别的防篡改技术前景进行了展望。     

带激光反射镜重要设备轴线方位角测量方法的探讨

随着我国国民经济的快速发展,各项重大工程项目不断开展,测量在工程项目建设的地位重要性越来越强,经常会遇到很多涉及到重要工程的高精度测量,特别是受工程与项目环境的约束,采用常规的作业方法受到局限,如何采用最优最可靠的方法是测绘服务国民经济需要研究的问题,在可重复验证满足测量精度的同时,需要对独立的工程项目进行专项测量技术设计,以此来满足工程独特的技术与精度要求;本文探讨对某重要激光反射设备进行激光反射镜反射的不可见短轴轴线方位进行测量,由于受设备环境影响,激光镜面可见,垂直镜面反射的激光轴线在设备内不可见也不可延长,如何高精度的测量激光轴线方位是设备安装后调试的关键。     

软上地基上加筋碎石垫层工作性状试验研究

通过模型试验研究了加筋和不加筋碎石垫层在软土地基上的承载特性,分析了垫层厚度、加筋材料、加筋层数、筋体布置位置等因素对垫层承载特性的影响。结果表明：垫层厚度对地基沉降影响明显,合理的垫层厚度能有效地降低地基的沉降;加筋后的碎石垫层对降低地基沉降的效果更明显,同等条件下,土工格室的加筋效果优于土工格栅;加筋层数及筋体布置位置对加垫碎石垫层承载特性有一定影响,层数越多加筋效果越好,将筋体布置在垫层下部时效果最好;加垫层能在一定程度上提高地基基床系数,其中土工格室加筋碎石垫层对提高地基基床系数效果最好。     

Progress and challenges in sustainability,compatibility, and production of eco-composites: A state-of-art review

Owing to economic and environmental benefits, new generations of materials/commodities follow “from waste to wealth” strategy. Recently, there has been a huge upsurge in research on the development of eco-composites using recycled plastic polymers and agro-residues because the eco-composites satisfy the stringent environment regulations and are cost-effective. Herein, we present a detailed review on the potential use of several types of natural fillers as an efficient reinforcement for recycled plastic polymers. In particular, the characterization of different categories of eco-composites according to their morphological, physical, thermal, and mechanical properties is extensively reviewed and their results are analyzed, compared, and highlighted. Furthermore, a framework to produce functional eco-composites, which includes functionalization of ingredients, critical issues on microstructural parameters, processing, and fabrication methods, is outlined and supported with sufficient data from the literature. Finally, the review outlines the emerging challenges and future prospects of eco-composites to be addressed by interested researchers to bridge the gap between research and commercialization of such a class of material. Overall, the acquired knowledge will guide researchers, scientists, and manufacturers to plan, select, and develop various forms of eco-composites with enhanced properties and optimized production processes.     

Fourier transform infrared (FTIR) authentication and batch-to-batch consistency for different types of paints using benchtop and handheld FTIR spectrophotometers for oil and gas industry

Standardization of Fourier transform infrared (FTIR) fingerprint region for paints and assessment on the reproducibility using different spectrophotometers were investigated. While selective fingerprint regions may be confusing for technicians/analysts who are non-chemists, we attempt to generalize these regions (e.g., 1300–1000 cm⁻¹ for Epoxy part A and 1400–1000 cm⁻¹ for Epoxy part B) by choosing a universal region (2000–900 cm⁻¹) that works for different paints. Comparison result using a paired student t-test shows that the degree of similarity (r) values from the studied regions are not statistically different. The paint fails the screening analysis occasionally on-site when analyzed using handheld FTIR due to the higher level of noise that gives low r values (r < 0.900 ± 0.002). The same samples were analyzed using a benchtop FTIR and the r values are above 0.900 ± 0.002. While the screening may lead to a false rejection of the sample on-site, there could be occurrence of false acceptance. The on-site screening of EPZ part A with different formulations, for instance, shows that the r values over the entire IR spectrum are above 0.900 ± 0.002 when analyzed using handheld FTIR. After the samples were analyzed using the benchtop, the r values fall below 0.900 ± 0.002.     

家用冰箱储藏室内挥发性有机物检测及分析

为研究家用冰箱储藏室中挥发性有机化合物(VOCs)的释放量及主要来源,采用气相色谱–质谱法对工作状态下冰箱储藏室的VOCs含量进行检测;利用傅里叶变换红外光谱仪对冷藏室的物料进行成分分析,同时用密封舱法探究冷藏室不同物料对VOCs含量贡献。结果表明,冰箱冷藏室物料中发泡聚苯乙烯风道泡沫释放的总挥发性有机化合物(TVOC)、正戊烷及异戊烷最多,是造成异味的关键性物料,而正戊烷、异戊烷是冰箱异味的主要成分。聚氯乙烯门封条对异味的贡献也较大,通用聚苯乙烯抽屉体贡献的VOCs种类最多;在工作状态下,随着密闭时间的增加,冰箱储藏室的VOCs的种类及含量增加,但苯、甲苯、二甲苯、TVOC及戊烷类的含量均未超过国家标准。储藏室异戊烷含量较高,是冰箱的异味的主要来源。     

Kinetics of the oxidation of ilmenite

The oxidation of ilmenite (FeTiO₃) in air and dry oxygen was investigated over the temperature interval 600 to 970°C. Dense platelets of ilmenite crystals as well as powder samples of ilmenite were oxidized. The weight data were recorded employing a thermobalance. The oxidation kinetics of ilmenite platelets were parabolic except for the initial stages during which logarithmic kinetics were observed. For powder samples the logarithmic rate law was followed primarily. The logarithmic rate law was attributed to free penetration of oxygen through cracks and short-circuit paths. The activation energies associated with the logarithmic rate law were nearly one-half of those obtained from parabolic oxidation. The growth morphology of the products of oxidation of ilmenite was observed with a scanning electron microscope. The effect of growth morphology on the kinetics is discussed, and a probable reaction mechanism is suggested for the oxidation of ilmenite.     

一个高速开关阀控液压系统的模糊控制研究

本文设计了一个采用高速开关阀控制的液压缸位置控制系统，该系统便于和微机接口实现数字控制。本系统运用PWM技术和模糊控制技术，实现了系统的精确控制。仿真结果表明，该控制器具有快速响应性和好的稳定性。同时也表明了采用模糊控制方法可以有效的解决一类非线性系统的控制。     

基于PAGM模型的浇注系统对螺旋桨铸件夹渣率的影响

基于分散相粒子运动模型,考虑夹渣在随流运动过程中动态聚合长大现象,构建了夹渣聚合长大模型(PAGM,Particles Aggregation Growth Model)。采用PAGM对铝合金螺旋桨铸件浇注过程中夹渣的运动轨迹、聚合长大行为及最终位置进行了模拟计算和试验验证。在此基础上研究了浇注系统对铸件夹渣分布及夹渣率的影响。结果表明,浇注系统设计对夹渣运动行为及分布有较大影响,PAGM可有效提升对铸件夹渣分布预测的准确性,为铸件优化设计及失效分析提供参考。     

Crystal and magnetic structures of Laves phase compound NdCo2 in the temperature range between 9 and 300 K

The crystal and magnetic structures of the Laves phase compound NdCo₂ in the temperature range from 9 to 300 K are determined by Rietveld refinement technique, using high-resolution neutron powder diffraction data. The compound crystallizes in space group above the magnetic ordering temperature T_C (≈100 K), in space group I4₁/amd below T_C and in space group Imma below the tetragonal–orthorhombic structural/magnetic transitions at T_M ≈ 42 K. The assignment of the space groups to the crystal structures of NdCo₂ in different temperature ranges complies with the reported Mössbauer studies. Detailed information of the crystal and magnetic structures of NdCo₂ at different temperatures are reported.