Assessing task understanding in remote ultrasound diagnosis via gesture analysis

Pattern Analysis and Applications - This work presents a gesture-based approach to estimate task understanding and performance during remote ultrasound tasks. Our approach is comprised of...     

Model-based intelligent user interface adaptation: challenges and future directions

Software and Systems Modeling - Adapting the user interface of a software system to the requirements of the context of use continues to be a major challenge, particularly when users become more...     

Development and implementation of a hybrid scale up model for a batch high shear wet granulation operation

The high shear wet granulation (HSWG) operation consists of several rate processes influenced by the raw material properties, process operational parameters, and equipment design. Their combined effect determines the granule attributes. In literature, these rate processes have been modeled using different dimensionless numbers and their correlations. Each of these dimensionless numbers represent only certain rate processes. Since many of these rate processes occur at the same time, it is necessary to simultaneously model them to account for all the important degrees of freedom. Most of the HSWG scale up approaches in literature calculate scale up conditions based on a single rate process or operating parameter of interest that can lead to sub-optimal process design. We present the development of a hybrid HSWG scale up model accounting simultaneously for all the rate processes. The approach was successfully implemented to scale up the HSWG operation across laboratory, pilot, and commercial scales.     

Analytic expressions for the isosteric heat of adsorption from adsorption isotherm models and two-dimensional SAFT-VR equation of state

The isosteric heat of adsorption is an important thermodynamic property used to characterize and optimize adsorption processes. In this work, analytic expressions for isosteric heats of adsorption are derived for a collection of commonly used isotherm models and a two-dimensional molecular equation of state based on the SAFT-VR approach. The use of these expressions is presented with an example of adsorption of nitrous oxide, N₂O, on biochar, which is a waste biomass charcoal that exhibits high adsorption potential. The results show that accurate fitting of the adsorption isotherms leads to consistent results obtained with different approaches; however, the predicted isosteric heat of adsorption exhibits strong variations in the regions where experimental data is insufficient such in the region of low pressure/low coverage. Convergence on the prediction of the isosteric heat of adsorption by the different models is only observed in the region where no extrapolation of experimental data is needed.     

Extension-dominated improved dispersive mixing in single-screw extrusion. Part 2: Comparative analysis with twin-screw extruder

In Part 1 of this work, the possibility of improving single-screw extruders (SSE) better dispersive mixer was explored by harnessing extensional flows provided by the hyperbolic contracting–diverging channels of extensional mixing elements (EME). Addition of the EME to the pin screw generated enhanced breakup for polymer blends and nanocomposite systems without significant penalty in flow rate. In Part 2, experiments are performed on immiscible polymer blends (low-viscosity ratio and high-viscosity ratio) and nanocomposites on both SSE and twin-screw extruder (TSE) with the same rotation speed and throughput. Morphological results show tremendous improvement in dispersive mixing capability of SSE when equipped with EME that are mainly comparable to conventional TSE that is, with kneading blocks as mixing sections, although not as good as TSEs equipped with EMEs. Mechanical results also show enhanced modulus when EME is used in SSE operations.     

Bi-layer gelatin active films with “Pitanga” leaf hydroethanolic extract and/or natamycin in the second layer

Research on biopolymers-based active films produced with natural antioxidants and/or antimicrobials has gained attention over the last few years; however, anti-mold activity has been less studied than those of anti-bacteria. The aim of this work was the development and characterization of bi-layer films based on gelatin with natamycin and/or “Pitanga” leaf hydroethanolic extract in the second thin layer in order to determine the effects of these bioactive compounds on bi-layered film properties. The films were characterized regarding their moisture content and solubility in water, optical properties, microstructure, mechanical and thermal properties, water contact angle, water vapor permeability, UV/visible light transmission, X-ray diffraction, Fourier transform infrared (FTIR) spectroscopy, and antioxidant and anti-mold activities. Active films presented activity against Penicillium spp and Aspergillus niger and demonstrated antioxidant activity, as measured by ABTS ^•+ and DPPH ^• methods. Neither additive used in the films' second layer significantly affected the films' moisture content, thermal properties or the molecular interactions of the polymer matrix, assessed by FTIR, although some mechanical properties were affected, and the water contact angle. In conclusion, bi-layer films have reduced the quantity of additives required to maintain the antioxidant and anti-mold activities, as compared to similar monolayer films of the same thickness.     

Influence of deposited amine-functionalized Si-MCM-41 in polyacrylonitrile electrospun membranes applied for separation of water in oil emulsions

Among several oil/water emulsion separation technologies, the utilization of nanoparticle-decorated membranes with diverse functionalities has received considerable attention in recent years, particularly if the antifouling capacity can be improved. In this article, we propose a new membrane based on surface-hydrolyzed polyacrylonitrile electrospun membranes and/or decorated with amine-functionalized Si-MCM-41 nanoparticles to be used as oil/water emulsion separation treatment and to determine their antifouling ability. X-Ray photoelectron spectrometry, attenuated total reflectance Fourier transform infrared spectroscopy, and toluidine blue O assay, scanning electron microscopy, contact angle measurements for oil under water and thermogravimetry were used for characterizing the membranes and an assay of permeability was developed to quantify the diffusion of oil molecules across the electrospun membrane. The electrospun and/or decorated membranes showed an underwater oleophobic wettability, which can separate oil-in-water emulsions with 87% separation efficiency, results of fouling experiments, evaluated in terms of rejection and flux recovery ratio, exhibited good antifouling ability, but the membrane decoration process did not lead to superior outcomes compared with undecorated membranes.     

Biofilm Responses to Flow Regulation by Dams in Mediterranean Rivers

Dams regulate downstream hydrology and modify water quality, which in turn can impinge on the biota, especially in rivers naturally subject to large hydrological variability, such as those under Mediterranean climate. The effect of dams on biofilms was analysed in three tributaries (Cinca, Siurana and Montsant) of the Ebro River (NE Spain). We hypothesized that flow regulation would lead to lower spatial variability of biofilms on the streambed and to a decrease in their metabolic rate per unit biomass, especially during low flow periods. Biofilm characteristics were studied in five transects evenly spaced along river reaches upstream (control) and downstream (impact) of dams in each river, along with riverbed granulometry, hydraulics and water chemistry. Chlorophyll‐a, respiratory activity, photosynthetic capacity and efficiency, and extracellular enzymatic activities (β‐d ‐glucosidase, alkaline phosphatase and leucine‐amino‐peptidase) of epilithic biofilms were measured in different seasons. Spatial variability of chemical and biological variables was reduced downstream of the dams. Chlorophyll‐a concentration, photosynthetic efficiency and respiration capacity were higher in impact than in control reaches, but generally, low inorganic phosphorus concentrations resulted in comparable phosphatase activities downstream and upstream of dams. On the other hand, β‐d ‐glucosidase and leucine‐amino‐peptidase activities were higher at impact reaches. Biofilms were thicker and metabolically more active at the impact reaches, with higher ability to transform dissolved organic matter. Overall, results from this study provide evidence that dams can largely affect the structure and activity of river biofilms, with foreseeable important consequences for river ecosystem functioning. Copyright © 2014 John Wiley & Sons, Ltd.     

A finite volume–finite difference method with a stiff ordinary differential equation solver for advection–diffusion–reaction equation

A model for atmospheric pollutant transport is proposed considering an advection–diffusion–reaction equation. A splitting method is used to decouple the advection, diffusion and reaction parts. A scheme based on finite volume, finite difference and backward differentiation formula is used for solving an atmospheric transport-chemistry problem.     

Global Atmospheric Profiles from Reanalysis Information (GAPRI): a new database for earth surface temperature retrieval

This paper presents the Global Atmospheric Profiles derived from Reanalysis Information (GAPRI) database, which was designed for earth surface temperature retrieval. GAPRI is a comprehensive compilation of selected atmospheric vertical profiles at global scale which can be used for radiative transfer simulation in order to obtain generalized algorithms to estimate land surface temperature (LST). GAPRI includes information on geopotential height, atmospheric pressure, air temperature, and relative humidity derived from the European Centre for Medium-Range Weather Forecasts Re-Analysis data from year 2011. The atmospheric profiles are structured for 29 vertical levels and extracted from a global spatial grid of about 0.75° × 0.75° latitude–longitude with a temporal resolution of 6 hours. The selection method is based in the extraction of clear sky profiles over different atmospheric weather conditions such as tropical, mid-latitude summer, subarctic, and arctic, while also considering sea and land areas and day- and night-time conditions. The GAPRI database was validated by comparing land and sea surface temperature values derived from it to those obtained using other existing atmospheric profile databases and in situ measurements. Moreover, GAPRI was also compared to previous radiosonde atmospheric profiles using simulated split-window algorithms. Results show good agreement between GAPRI and previous atmospheric databases, thus demonstrating the potential of GAPRI for studies related to forward simulations in the thermal infrared range. GAPRI is a freely available database that can be modified according to the user’s needs and local atmospheric conditions.