无粘结预应力卵形消化池的受力分析及设计

本文采用有限元计算分析软件ANSYS对近年来出现的卵形消化池进行计算分析,着重对卵形消化池在多种荷载下的内力与变形进行分析,并采用二次曲线模拟沿高度均匀变化的壁厚。提出适合卵形消化池结构预应力钢筋等效为均布荷载的计算与配筋方法,取得较好的结果。     

吡啶型铝酸盐离子液体催化β-甲基萘歧化反应

研究了三氯化铝-氯化丁基吡啶(n-BPC-AlCl3)离子液体催化β-甲基萘歧化合成2，6-二甲基萘(2，6-DMN)反应。通过正交试验，考察了反应温度、时间、BPC—AlCl3离子液体酸强度及催化剂用量对β-甲基萘歧化反应的影响。实验结果表明，BPC—AlCl3酸性离子液体对β-甲基萘歧化反应具有良好的催化活性和较好的2，6-二甲基萘选择性。在120℃，AlCl3／BPC的摩尔比为4：1，催化剂质量分数12％，反应时间为3．5h的条件下，反应转化率为29．0％，2，6-DMN的选择性为32．5％。     

水工监测传感器指标使用误区的探讨

本文旨在讨论目前岩土工程中使用的传感器技术指标及其含义，希望通过探讨以弄清楚这些指标的含义及指标对评价传感器的意义。由于传感器是用于测量工程物理量的，因此，引人目前在国际上通用的测量与误差的概念，以国家现有的测量术语的定义为准来描述传感器的指标。     

宣钢烧结生产配加钢渣的工业试验

总结了宣钢烧结配配加钢渣生产不同碱度烧结矿的工业生产试验，提出了配加钢渣可强化全精粉烧结。     

MX345芯片及单片机控制

MX345芯片用于产生模拟信令—CTCSS单音.本文在介绍MX345编码/解码器工作原理的基础上,设计出MX345芯片与单片机的接口电路.最后给出控制软件.     

油田热采注汽管道在线检测技术现状

稠油热采注汽管道由于长期在高温、高压下运行,极易发生各种损伤,如腐蚀、裂纹、材料退化等,极易造成管道承压能力降低,发生失效事故。如何检测出潜在危险性缺陷,判断注汽管道能否继续使用,是保证注汽管道安全运行的关键问题。探讨了高温压力管道在线检测技术发展现状及其应用范围。     

撬装式油井热洗装置研制及应用效果评价

油井热洗是油田最常用的一种清蜡方法。靖安长6油藏是采油三厂的主力油藏,截至2004年底建成油井1064口,由于长6层原油含蜡量高,油井结蜡严重,通常采用常规热洗方法进行油井清蜡。存在以下两方面问题：一是常规油井热洗方法操作比较复杂,运行动力设施多,热洗费用较高；二是常规洗井油源均来自联合站或接转站,为不同层所采的混合原油,进入地层后,会对地层造成一定程度的伤害。为此,我们认真分析了现有油井热洗工艺的不足,查找了油井热洗费用高的影响因素,结合靖安油田长6油藏丰富的伴生气资源,自主研发了撬装式油井热洗装置,经过现场应用取得了较好的效果。     

汽车排放控制系统中的氧传感器现状及展望

介绍了浓差型(Nernst型)、极限电流型和半导体电阻型等汽车排放控制系统中的氧传感器原理及结构。在综合该领域国内外研究现状的基础上,对氧传感器的发展进行了展望。     

Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

Synthesis,characterization, and redox and electrochromic behaviors of poly(3-n-octyloxythiophene)

Poly(3-n-octyloxythiophene), a conjugated polymer, which possessed solubility in common organic solvents, was synthesized by electrochemical polymerization in the presence of lithium perchlorate as the supporting electrolyte and sodium dodecyl sulfate as the surfactant in an aqueous medium. Characterizations of the intermediate, monomer, and polymer were performed by NMR spectroscopy, Fourier transform infrared spectroscopy, ultraviolet–visible spectroscopy, and gel permeation chromatography. The process of electrochemical polymerization and the electrochemical redox behaviors were investigated by cyclic voltammetry and the potentiostatic method. A poly(3-n-octyloxythiophene) film that was deposited on a platinum electrode was found to exhibit electrochromic behaviors, and it switched electrochemically between blue–green oxidized and dark red reduced states. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008