High-gain pseudomorphic InGaAs base ballistic hot-electron device

A high-gain ballistic hot-electron device is described. The GaAs-AlGaAs heterostructure device, with a 21-mm-thick pseudomorphic In _0.12Ga_0.88As base, had a current gain of 27 at 77 K and 41 at 4.2 K. As characteristically seen in ballistic devices, transfer into the L valley limited the maximum gain. The Γ-L valley separation in the strained In_0.12Ga_0.88As was estimated to be about 380 meV     

Simulation of the initial stages of nucleation and growth of Au/NaCl(100)

The results of a computer simulation of the initial stages of the nucleation and growth of gold on NaCl(100) are presented. A potential energy scaling Monte Carlo model employing a 50 × 50 array, mobile monomers, dimers and trimers, and gold atom vertical “roll up” was used. The parameters in the model were obtained from the work of Robinson and Robins, other published sources and/or found by calculation. Simulations of the migration of single gold adatoms over the surface permitted the determination of the diffusion coefficient as a function of the reciprocal temperature which returned the same activation energy given by the potential field, thus indicating the consistency of the model. Initial cluster densities were determined using deposition rates of R_d = 10¹⁵cm^-2s^-1 and R_d = 10¹⁴cm^-2s^-1 over the temperature range T=200–425 K. Initial cluster growth was found to occur primarily by surface phase transport and resulted in clusters that were shaped like very thin disks. Using the equations from the work of Velfe and coworkers, calculations were made to extrapolate the computer simulation data in order to permit an indirect comparison with the data of Robinson and Robins. Good agreement was achieved. Initial condensation coefficients determined over a 250 ms interval showed that α ≈ 0 at T > 425 K and α ≈ 1 at T < 325 K for a deposition rate of R_d=10¹⁵ cm^-2 s^-1.     

Effects of flux enhancing polymer on the characteristics of sludge in membrane bioreactor process.

A newly developed membrane performance enhancer (MPE) was used to prevent membrane fouling in a membrane bioreactor (MBR) process. It transpired that 1,000 mg/l of MPE reduced polysaccharide levels from 41 mg/I to 21 mg/I on average under the experimental condition. Repeated experiments also confirmed that 50-1,000 mg/l of MPE could reduce membrane fouling significantly and increase the intervals between membrane cleanings. Depending on MPE dosages and experimental conditions, trans-membrane pressure (TMP) increase was suppressed for 20-30 days, while baseline TMP surged within a few days. In addition, MPE allowed MBR operation even at 50,000 mg/l of total solid and reduced permeate COD. However, no evidence of toxicity for sludge was found from respiratory works.     

An integrated system to remote monitor and control anaerobic wastewater treatment plants through the internet.

The TELEMAC project brings new methodologies from the Information and Science Technologies field to the world of water treatment. TELEMAC offers an advanced remote management system which adapts to most of the anaerobic wastewater treatment plants that do not benefit from a local expert in wastewater treatment. The TELEMAC system takes advantage of new sensors to better monitor the process dynamics and to run automatic controllers that stabilise the treatment plant, meet the depollution requirements and provide a biogas quality suitable for cogeneration. If the automatic system detects a failure which cannot be solved automatically or locally by a technician, then an expert from the TELEMAC Control Centre is contacted via the internet and manages the problem.     

Financial Analysis and Marketing Strategy

A combination of concept (the product portfolio and the product life cycle) and empirical research (the PIMS study) can aid in clarifying the key issues involved in the selection of a firm's core strategies. Strategy control is multistage: periodic re-evaluation of strategy alternatives by use of the marketing audit; an analytical framework for control of chosen strategies by breaking down components and reporting their performance variances; and 'marketing segment' analysis for control of the detailed marketing plan.?     

Sensory analysis of polystyrene packaging material taint in cocoa powder for drinks and chocolate flakes

Polystyrene packaging material taint was sensorily evaluated in cocoa powder for drinks and chocolate flakes using short-cut signal detection measures on differences between control and test samples and on recognition of styrene. No differences were observed in cocoa powder for drinks and plain chocolate flakes treated with 0.5 dm2 polystyrene of 1 mm thickness. However, differences were detected in milk chocolate flakes and plain chocolate flakes, which were in contact with a larger area or thicker polystyrene packaging material. The latter results were confirmed by the styrene recognition test, so polystyrene is a potential source of off-flavour for chocolate products. The amount of residual styrene in the polystyrene used was about 320 ppm, while the amounts of styrene ranged from 7 to 132 ppb in cocoa drinks and from 414 to 1447 ppb in chocolate flakes.     

Solution of Helmholtz equation by Trefftz method

The application of the Trefftz method for calculating wave forces on offshore structures is presented. Indirect and direct formulations using complete and non-singular systems of Trefftz functions for the Helmholtz equation are posed in this paper. An effective technique using different interpolation functions for the velocity potential and wave force are suggested to improve the computational accuracy of the wave force. The numerical examples show that the present method is highly efficient and accurate.     

Axial-Field Electrical Machines - Design and Applications

Axial-field electrical machines offer an alternative to the conventional machines. In the axial-field machine, the airgap flux is axial in direction and the active current carrying conductors are radially positioned. This paper presents the design characteristics, special features, manufacturing aspects and potential applications for axial-field electrical machines. The experimental results from several prototypes, including d.c. machines, synchronous machines and single-phase machines are given. The special features of the axial-field machine, such as its planar and adjustable airgap, flat shape, ease of diversification, etc., enable axial-field machines to have distinct advantages over conventional machines in certain applications, especially in special-purpose applications.     

An Analysis of Scheduling Policies In Multiechelon Production Systems

Results of a simulation study of the economics of frequency of rescheduling Material Requirements Planning (MRP) systems are presented for a single-product, two-stage system in which demand is uncertain. The results indicate that for systems with moderate demand uncertainty, frequent rescheduling to maintain customer service may be uneconomical when compared with the alternative of more stable schedules in conjunction with safety stock. This result arises primarily because the cost of “emergency” production setups which occur when rescheduling is frequent exceeds the cost of safety stock required to “protect” stable schedules.     

Implementation of adaptive critic-based neurocontrollers for turbogenerators in a multimachine power system

This paper presents the design and practical hardware implementation of optimal neurocontrollers that replace the conventional automatic voltage regulator (AVR) and the turbine governor of turbogenerators on multimachine power systems. The neurocontroller design uses a powerful technique of the adaptive critic design (ACD) family called dual heuristic programming (DHP). The DHP neurocontrollers' training and testing are implemented on the Innovative Integration M67 card consisting of the TMS320C6701 processor. The measured results show that the DHP neurocontrollers are robust and their performance does not degrade unlike the conventional controllers even when a power system stabilizer (PSS) is included, for changes in system operating conditions and configurations. This paper also shows that it is possible to design and implement optimal neurocontrollers for multiple turbogenerators in real time, without having to do continually online training of the neural networks, thus avoiding risks of instability.