电石冷却车间厂房通风模型的研究及应用

介绍了厂房通风模型在电石冷却车间改造中的应用,对比分析了改造前后冷却车间内的通风状态.模拟结果表明,冷却车间厂房内的总通风量增加了99.4％,通风温度降低了20.5 ℃,厂房结构和设备表面温度降低了50℃,能有效解决冷却车间内通风温度偏高的问题,提高电石转运率.根据通风模型进行改造后,电石冷却时间缩短25％,证明厂房通风模型准确可靠.     

电喷雾质谱法示踪钨回收过程离子的转化路径

将环隙式离心萃取器(ACCs)与电喷雾飞行时间质谱(ESI-TOF-MS)相结合，在线监测了回收过程中的钨萃取行为(宏观)和钨形态的转化路径(微观)，发现宏观萃取反应和微观离子形态转化同时发生并相互补充。伯胺N1923萃取钨在144 s内即可达到萃取平衡，萃取率高达98%以上，同时，酸钨比n(H)/n(W)是一个关键变量，当酸钨比n(H)/n(W)=2.4时，全流程钨回收率超过93%。最后，得到了基于钨形态监测的萃取机理，同时，减少原料液中W1含量，增加W10含量，可有效提高钨回收效率。     

Data sharing mechanism of various mineral resources based on blockchain

Basins with various mineral resources coexisting and enriching often occupy an important strategic position. The exploration of various mineral resources is repetitive at present due to unshared data and imperfect management mechanism. This situation greatly increases the cost of energy exploitation in the country. Traditional data-sharing mode has several disadvantages, such as high cost, difficulty in confirming the right of data, and lack of incentive mechanism, which make achieving real data sharing difficult. In this paper, we propose a data-sharing mechanism based on blockchain and provide implementation suggestions and technical key points. Compared with traditional data-sharing methods, the proposed data-sharing mechanism can realize data sharing, ensure data quality, and protect intellectual property. Moreover, key points in the construction are stated in the case study section to verify the feasibility of the data-sharing system based on blockchain proposed in this paper.     

两阶段领域自适应学习

针对领域自适应问题中源域和目标域的联合分布差异最小化问题,提出两阶段领域自适应学习方法.在第一阶段考虑样本标签和数据结构的判别信息,通过学习一个共享投影变换,使投影后的共享空间中边缘分布的差异最小.第二阶段利用源域标记数据和目标域非标记数据学习一个带结构风险的自适应分类器,不仅能最小化源域和目标域条件分布差异,还能进一步保持源域和目标域边缘分布的流形一致性.在3个基准数据集上的实验表明,文中方法在平均分类准确率和Kappa系数两项评价指标上均表现较优.     

Se doped nickel-molybdenum bimetal sulfide with enhanced electrochemical activity for hydrogen evolution reaction

In this work, we synthesized Se doped MoS₂@Ni₃S₂ with nanosheets coated nanorods structure supported on Ni foam (MoNiSeS). Firstly, MoS₂@Ni₃S₂ (MoNiS) nanorods was synthesized by hydrothermal method. After selenization treatment, MoSe₂ successfully formed on the edge of MoS₂ nanosheets and particle Ni₃S₂ transformed into NiSe, in which MoSe₂ and NiSe acted as new phase in MoNiSeS. The obtained MoNiSeS only needs a low overpotential of 68 mV to reach the current density of 10 mA cm^?2, and has a low Tafel plots of 72.77 mV dec^?1 and good electrochemical durability, whose electrochemical activity is much better than that of MoNiS and NiSeS, implying the introduction of Mo and Se is beneficial to improve the electrocatalytic performance of NiS for HER. In addition, the proper amount of Mo source, which has an effect on the morphology of product, has also been investigated. For MoNiSeS, the typical nanosheets coated nanarods expose more active sites and the synergic effects is good to the improvement of the catalytic activity. Meanwhile, WNiSeS has also been prepared using the same method and the corresponding results show that the electrochemical activity of WNiSeS is much better than that of NiSeS, proving the universality of this strategy.     

基于状态空间法的电动机故障诊断和识别

电动机的初期故障信号一般较弱,不易辨别,而状态空间法在小信号的处理中灵敏度很高。为达到对电动机故障的诊断和识别,试图把状态空间法应用到对电动机的故障诊断中,先通过推导,从数学理论层面分析了状态空间法对于电动机故障信号的可辨别性,再使用Matlab软件搭建状态空间的辨别模型,把实验台测试的三组数据导入到模型中进行测试。测试的结果有力地证明了此方法的可行性,并能克服快速傅里叶变换(FFT)中数据采集量较大、分辨率不高的缺点。     

信永中和"登云股份IPO审计失败"探究

本文以证监会发布的针对信永中和及两名签字注册会计师的行政处罚决定书为切入点,结合深圳证券交易所、天眼查、巨潮资讯等网站公布的相关信息,从信永中和的具体审计过程,分析登云股份IPO审计失败的原因,原因主要在于基于业务需要未充分了解公司及其经营环境,贸然接受委托,缺乏应有的执业审慎,缺少了必要的审计程序,复核制度流于形式丧失了发现错误的最后机会。