The effect of field drying on the non-structural carbohydrate composition in vetch hay

Common vetch (Vicia sativa L) was harvested and allowed to dry in the open air. The composition of fresh forage in non-structural carbohydrates varied markedly between years, the contents of sugars and starch in both leaves and stems being much higher in 1990-91 than 1991-92. Field drying produced a significant decrease in the amounts of these carbohydrates. The total losses of sugars and starch in hay, expressed as losses of dry matter, ranged from 28 to 15 g kg^-1, depending on the year.     

Effects of storage time and chemical preservatives on the total volatile basic nitrogen content in chilean mackerel (Trachurus murphy) prior to fish meal production

Total volatile basic nitrogen (TVB-N) as a measure of protein degradation and total microbial counts or stored raw mackerel (Trachurus murphy), which had been treated with chemical preservatives, were compared with the TVB-N and microbial counts of untreated fish. In unpreserved fish, decomposition of fish protein was rapid. Treatment of mackerel with acetic (1000-5000 μg kg^?1), which was the most effective of the parameters studied, approximately halved the rate of increase in TVB-N compared with the untreated samples. Changes in the total microbial counts presented a similar trend.     

Silicon‐Modified Rare‐Earth Transitions—A New Route to Near‐ and Mid‐IR Photonics

Silicon underpins microelectronics but lacks the photonic capability needed for next‐generation systems and currently relies on a highly undesirable hybridization of separate discrete devices using direct band gap semiconductors. Rare‐earth (RE) implantation is a promising approach to bestow photonic capability to silicon but is limited to internal RE transition wavelengths. Reported here is the first observation of direct optical transitions from the silicon band edge to internal f‐levels of implanted REs (Ce, Eu, and Yb); this overturns previously held assumptions about the alignment of RE levels to the silicon band gap. The photoluminescence lines are massively redshifted to several technologically useful wavelengths and modeling of their splitting indicates that they must originate from the REs. Eu‐implanted silicon devices display a greatly enhanced electroluminescence efficiency of 8%. Also observed is the first crystal field splitting in Ce luminescence. Mid‐IR silicon photodetectors with specific detectivities comparable to existing state‐of‐the‐art mid‐IR detectors are demonstrated.     

Information and Telecommunications Project for a Digital City: A Brazilian case study

Making information and telecommunications available is a permanent challenge for cities concerned to their social, urban and local planning and development, focused on life quality of their citizens and on the effectiveness of public management. Such a challenge requires the involvement of everyone in the city. The objective is to describe the information and telecommunications project from the planning of a digital city carried out in Vinhedo-SP, Brazil. It was built as a telecommunications infrastructure of the kind of “open access metropolitan area networks” which enables the integration of citizens in a single telecommunications environment. The research methodology was emphasized by a case study which turned to be a research-action, comprising the municipal administration and its local units. The results achieved describe, by means of a methodology, the phases, sub-phases, activities, approval points and resulting products, and formalize their respective challenges and difficulties. The contributions have to do with the practical feasibility of the project and execution of its methodology. The conclusion reiterates the importance of the project, collectively implemented and accepted, as a tool to help the management of cities, in the implementation of Strategic Digital City Projects, in the decisions of public administration managers, and in the quality of life of their citizens.     

Controlled-resistance loads for induction heating applications using thin non-magnetic metallic layers

The design of controlled-resistance loads for domestic induction heating applications using thin non-magnetic conductive layers is described. Thin metallic layers are fabricated using the phase vapour deposition technique. Such layers would enable vessels, the inductive behaviour of which was similar to those fabricated with conventional ferromagnetic bulk materials, to be manufactured. Optimum layer thickness is investigated using an analytical impedance model of the complete induction system     

Application of the LP-DP approach to Andong and Imha parallel reservoirs,Korea

This paper presents an application of a previously developed linear programming-dynamic programming (LP-DP) methodology to the operation of Andong and Imha parallel reservoirs in South Korea. The model allows for multioptimization of power generation and municipal, industrial, and irrigation water use. It is shown that the annual average energy and the annual average water supply generated from the joint operation of the two parallel reservoirs by the LD-DP approach is 15.2 and 1.7% more than the contracted power production and water supply respectively.     

A dual-affinity gene fusion system to express small recombinant proteins in a soluble form: expression and characterization of protein A deletion mutants

A novel gene fusion system to express and purify small recombinantproteins in Escherichia coli has been constructed. The conceptallows for affinity purification of soluble gene products bysequential albumin- and Zn²+-affinity chromatography. The dual-affinitysystem is well suited for expression of unstable proteins asonly full-length protein is obtained after purification andproteins gain proteolytic stability in the fusion protein. Herewe show that the dual-affinity approach can be used for theexpression of various unstable derivatives of a single IgG-bindingdomain based on staphylococcal protein A. Analysis of the proteolyticstabilities and the IgG-binding properties of the differentmutant proteins suggest that the model for the structure ofan IgG-binding domain must be re-evaluated.     

Molds and Resists Studies for Nanoimprint Lithography of Electrodes in Low-Voltage Polymer Thin-Film Transistors

A low-cost patterning of electrodes was investigated looking forward to replacing conventional photolithography for the processing of low-operating voltage polymeric thin-film transistors. Hard silicon, etched by sulfur hexafluoride and oxygen gas mixture, and flexible polydimethylsiloxane imprinting molds were studied through atomic force microscopy (AFM) and field emission gun scanning electron microscopy. The higher the concentration of oxygen in reactive ion etching, the lower the etch rate, sidewall angle, and surface roughness. A concentration around 30 % at 100 mTorr, 65 W and 70 sccm was demonstrated as adequate for submicrometric channels, presenting a reduced etch rate of 176 nm/min. Imprinting with positive photoresist AZ1518 was compared to negative SU-8 2002 by optical microscopy and AFM. Conformal results were obtained only with the last resist by hot embossing at 120 °C and 1 kgf/cm² for 2 min, followed by a 10 min post-baking at 100 °C. The patterning procedure was applied to define gold source and drain electrodes on oxide-covered substrates to produce bottom-gate bottom-contact transistors. Poly(3-hexylthiophene) (P3HT) devices were processed on high-κ titanium oxynitride (TiO _x N _y ) deposited by radiofrequency magnetron sputtering over indium tin oxide-covered glass to achieve low-voltage operation. Hole mobility on micrometric imprinted channels may approach amorphous silicon (～0.01 cm²/V s) and, since these devices operated at less than 5 V, they are not only suitable for electronic applications but also as sensors in aqueous media.     

Epitope-Imprinted Nanoparticles as Transforming Growth Factor-β3 Sequestering Ligands to Modulate Stem Cell Fate

Growth factors (GFs) are biomolecules with potent biological effects but inherent limitations hinder their potential as therapeutic agents and cell culture supplements in tissue engineering and regenerative medicine (TERM). Biomaterials that sequester endogenous GFs by affinity binding might circumvent such limitations and thus are being increasingly investigated. Here, molecularly imprinted nanoparticles (MINPs) are proposed as specific abiotic ligands for GFs. As a proof of concept, a conformational epitope of transforming growth factor-β3 (TGF-β3) is designed and surface imprinted onto polyacrylamide-based nanoparticles by inverse microemulsion polymerization. It is found that, depending on the polymerization mixture composition, MINPs can recognize and preferentially bind TGF-β3, either in noncompetitive assays or from a complex human fluid (platelet lysate). Substrates functionalized with MINPs are then used for 2D culture of adipose-derived stem cells. Remarkably, gene and protein expression profiles show a marked upregulation of SOX-9, suggesting activation of TGF-β3 signaling pathways without requiring supplementation with exogenous GF. Likewise, culturing these cells in pellets incorporating MINPs previously incubated with platelet lysate results in higher collagen II-rich matrix deposition, compared to pellets incorporating non-imprinted nanoparticles. In summary, results suggest MINPs can be used as cost-effective, stable, and scalable alternative abiotic GF ligands to guide cell fate in TERM applications.