Polymorphism of bacteriophage T7

For viruses made of nucleic acid and protein, the structure of the protein outer shell has, in the past, been found to be uniquely determined by the viral genome. However, here, non-denaturing agarose gel electrophoresis of bacteriophage T7 reveals two states of the mature T7 capsid; the conditions of growth are found to alter the population by T7 of these two electrophoretically defined states. Both states have been previously observed for a genetically altered T7 and they are observed here for wild-type T7. The average electrical surface charge density of a bacteriophage particle (delta) determines its state; the delta of particles in both states is negative. For a given condition of growth, the population of these two states is influenced by the extent to which the major T7 outer shell protein, p10A, is accompanied by its minor readthrough variant, p10B. Comparison of the two electrophoretic states reveals the following. (1) No difference in radius is present in the outer shell (+/-2%). (2) As the pH of electrophoresis is either increased or decreased from neutrality, the state becomes more highly populated for which delta is greater in magnitude (state 1). By changing the pH, some T7 particles are made to change state. (3) Particles in state 1 adsorb less quickly to host cells than do the particles in the alternative state (state 2). This latter observation suggests the hypothesis that state 1 evolved to reduce the probability of re-initiating an infection when conditions are not favorable for growth. This hypothesis is supported by the observation that, as conditions of growth become apparently more unfavorable, progeny increasingly populate state 1.     

Maternal and neonatal outcomes after prolonged latent phase

Glycol ethers such as 2-ethoxyethanol (EE) are widely used as solvents because they are miscible in aqueous and organic solutions. Toxic effects of EE in rodents include teratogenicity, fetotoxicity, hematotoxicity, and testicular atrophy. The purpose of this study was to determine the effect of dose on the absorption, metabolism, and excretion of 2-ethoxy [U-14C]ethanol by F344/N rats after inhalation exposure. Rats were exposed to either 5 ppm EE for 5 hr 40 min or 46 ppm EE for 6 hr. The uptake and metabolism of EE were linear in the concentration range studied. Significant percentages of the retained doses were exhaled during (22%) and after exposure (16%) as 14CO2. Forty-six percent of the retained dose was excreted in the urine. Approximately 10% of the retained dose was detected in the carcass 66 hr after exposure. The major urinary metabolite was ethoxyacetic acid (EAA), the toxic metabolite of EE. The amount of EAA excreted was linearly related to exposure concentration. Ethylene glycol and N-ethoxyacetyl glycinate were identified as minor metabolites excreted in the urine. The results of this study suggest that the toxicity of inhaled EE should be directly proportional to the exposure concentration up to 46 ppm if the toxicity of EE is due to EAA.     

Role of conserved Asn-Tyr-Asp-Tyr sequence in bacterial copper/2,4, 5-trihydroxyphenylalanyl quinone-containing histamine oxidase

Copper amine oxidase contains a covalently bound quinonoid cofactor, 2,4,5-trihydroxyphenylalanyl quinone (TPQ), which is synthesized by post-translational modification of a specific tyrosyl residue occurring in the highly conserved sequence, Asn-Tyr-(Asp/Glu)-Tyr. To elucidate the role(s) of the conserved sequence in the biogenesis of TPQ, each of the corresponding residues at positions 401-404 in the recombinant histamine oxidase from Arthrobacter globiformis has been replaced with other amino acids by site-directed mutagenesis. When Asn-401 was changed to Asp or Gln, the rate of TPQ formation by copper-dependent self-processing was 10(3)- to 10(4)-fold slower than in the wild-type enzyme. When Tyr-402 was replaced by Phe, TPQ was not formed at all, showing that Tyr-402 is essential as the precursor to TPQ. In contrast, Asp-403 could be replaced by Glu without changes in the rate of TPQ formation, whereas its replacement by Asn led to a marked decrease. Furthermore, when Tyr-404 was changed to Phe, TPQ was formed swiftly on incubation with copper ions, but the TPQ enzyme exhibited very low activity with altered substrate specificity. These results collectively indicate that a very rigorous structural motif is required for efficient formation of TPQ and for the catalytic activity in the active site of copper amine oxidases.     

Reduction of loading effect by tungsten etchback in a magneticallyenhanced reactive ion etcher

The plug loading effect occurring during the etchback of tungsten was investigated in a magnetically enhanced reactive ion etcher using SF ₆/Ar mixtures. It was found that while the plug loading effect is independent of varying SF₆/Ar flow rate ratio and magnetic field intensity, it is reduced under the condition of high selectivity of tungsten relative to TiN which was achieved at high chamber pressure and low RF power. It is proposed that when TiN is used as a glue layer, the W etch rate enhancement in the plug is mainly controlled by a local loading effect. Under the optimized etchback conditions the plug loss was successfully controlled without the tungsten residue left on severe topology     

Prevention of bleeding after cardiopulmonary bypass with high-dose tranexamic acid. Double-blind, randomized clinical trial

This prospective, double-blind, randomized trial assessed the effectiveness of high-dose tranexamic acid given in the preoperative period on blood loss in patients undergoing cardiopulmonary bypass. One hundred fifty patients scheduled to undergo cardiac operations with cardiopulmonary bypass were randomized into three groups of equal size. The first group received 10 gm of tranexamic acid intravenously over 20 minutes before sternotomy and a placebo infusion over 5 hours. The second group received 10 gm of tranexamic acid over 20 minutes and then another 10 gm infused intravenously over 5 hours. The control group received a placebo bolus and a placebo infusion over 5 hours (0.9% normal saline solution). The blood loss after the operation was measured at 6 hours and 24 hours. The homologous blood and blood products given during and up to 48 hours after operation were recorded. Eighteen percent of the control group patients shed more than 750 ml blood in 6 hours compared with only 2% in both tranexamic acid groups. Patients who shed more than 750 ml blood required 93% more red blood cell transfusions than patients without excessive bleeding. Tranexamic acid (10 gm) given intravenously in the period before cardiopulmonary bypass reduced blood loss over 6 hours by 50% and over 24 hours by 35%. Continued tranexamic acid infusion (10 gm over 5 hours) did not reduce bleeding further. There was no difference in the coagulation profile before operation between patients with and without excessive bleeding. However, coagulation tests done in the postoperative period indicated ongoing fibrinolysis and platelet dysfunction in patients with excessive bleeding.     

Multiresolution segmentation of respiratory electromyographicsignals

Analysis of respiratory electromyographic (EMG) signals in the study of respiratory control requires the detection of burst activity from background (signal segmentation), and focuses upon the determination of onset and cessation points of the burst activity (boundary estimation). The authors describe a new automated multiresolution technique for signal segmentation and boundary estimation. During signal segmentation, a new transitional segment is defined which contains the boundary between background a burst activity. Boundary estimation is then performed within this transitional segment. Boundary candidates are selected and a probability is attributed to each candidate, using an artificial neural network. The final boundary for a given transitional segment is the boundary estimate with the maximum a posteriori probability. This new method has proved accurate when compared to boundaries chosen by two investigators     

Strength,toughness and R-curve behaviour of SiC whisker-reinforced composite Si3N4 with reference to monolithic Si3N4

The flexural strength and fracture toughness of 30 vol% SiC whisker-reinforced Si₃N₄ material were determined as a function of temperature from 25 to 1400°C in an air environment. It was found that both strength and toughness of the composite material were almost the same as those of the monolithic counterpart. The room-temperature strength was retained up to 1100°C; however, appreciable strength degradation started at 1200°C and reached a maximum at 1400°C due to stable crack growth. In contrast, the fracture toughness of the two materials was independent of temperature with an average value of 5.66 MPam^1/2. It was also observed that the composite material exhibited no rising R-curve behaviour at room temperature, as was the case for the monolithic material. These results indicate that SiC whisker addition to the Si₃N₄ matrix did not provide any favourable effects on strength, toughness and R-curve behaviour.     

Non-linear properties of polymer cellular materials with a negative Poisson's ratio

Negative Poisson's ratio polymeric cellular solids (re-entrant foams) were studied to ascertain the optimal processing procedures which give rise to the smallest value of Poisson's ratio. The non-linear stress-strain relationship was determined for both conventional and re-entrant foams; it depended upon the permanent volumetric compression achieved during the processing procedure. Poisson's ratio of re-entrant foam measured as a function of strain was found to have a relative minimum at small strains. The toughness of re-entrant foam increased with permanent volumetric compression, and hence with density.     

Control of circulating current in two parallel three-phase boost rectifiers

One unique feature in parallel three-phase converters is a potential zero-sequence circulating current. To avoid the circulating current, most present technology uses an isolation approach, such as transformers or separate power supplies. This paper proposes a parallel system where individual converters connect both AC and DC sides directly without additional passive components to reduce size and cost of the overall parallel system. In this case, the control of the circulating current becomes an important objective in the converter design. This paper: (1) develops an averaged model of the parallel converters based on a phase-leg averaging technique; (2) a zero-sequence model is then developed to predict the dynamics of the zero-sequence current; (3) based on the zero-sequence model, this paper introduces a new control variable, which is associated with space-vector modulation; (4) a strong zero-sequence current control loop is designed to suppress the circulating current; and (5) simulation and experimental results validate the developed model and the proposed control scheme.     

Strategy for olive mill wastewater treatment and reuse with a sewage plant in an arid region.

This study was conducted to evaluate the treatability of OMW (olive mill wastewater) with sewage and sewage sludge, which could supplement nutrients and microbes required for OMW treatment and reduce its possible toxicity. The amount of OMW added to an aeration tank was based on the loading difference between the designed and actual COD loads, while the amount added to anaerobic digestion for energy recovery was determined by CH4 production. The COD removal efficiencies were 70-85% for both systems. Compost of OMW with dried sewage sludge also showed a similar temperature profile without OMW addition. This strongly suggested that OMW can be treated at a sewage plant without pretreatment and the treated effluent can be reused in irrigation for an arid region.