Investigation of doped-gadolinium zirconate nanomaterials for high-temperature hydrogen sensor applications

The incorporation of selective nanomaterials, such as common metal oxide semiconductor compositions, into resistive-type gas sensors has been shown by many researchers to lead to very high sensitivities and response rates, especially for micro-sized chemical sensors for room-temperature applications. The same strategy utilizing sensing nanomaterials has not been demonstrated for high-temperature sensors due to the intrinsic instability of typical metal oxide semiconductor nanomaterials at temperatures >500 °C. Within this work, doped Gd₂Zr₂O₇ (GZO) nanomaterial compositions were investigated for H₂ resistive-type sensors for applications between 600 and 1000 °C. This paper investigates the mechanism of H₂ sensing for doped GZO nanomaterials and SnO₂/GZO nanocomposites at the elevated temperatures. By integrating 10 vol.% nano-SnO₂ into yttrium-doped GZO nanomaterials, a sensitivity of 4.15 % was retained for 4000 ppm H₂ levels with a low signal drift of 0.42 %/h at 1000 °C in a 20 % O₂/N₂ gas stream. The signal drift was reduced by more than half of that compared to pure nano-SnO₂ at the same conditions. The nano-GZO limited the grain growth of the nano-SnO₂ particles and also prevented the nano-SnO₂ from fully reducing to Sn at high temperatures in a low oxygen atmosphere. It is among the first resistive-type sensors operating at 1000 °C with sensing times of <5 min. This demonstration provided an example of a strategy of combining traditional metal oxide semiconductor and refractory nanomaterial compositions to form sensing nanocomposites with new sensing mechanisms, as well as, enhanced chemical and microstructural stabilities in high-temperature environments.     

Bicycle messengers: energy expenditure and exposure to air pollution

The purpose of the study was to determine the level of energy expenditure and exposure to air pollution for bicycle messengers. Relationships between heart rate (HR) and oxygen uptake, and between HR and pulmonary ventilation (VE) for each participant were established in laboratory tests. Air pollution and HR were measured during one working day. The total oxygen uptake was then described as the total energy expenditure in Joule (J) and in multiples of the energy expenditure at rest (MET). The mean energy expenditure during a working day (8 h) was 12 MJ, (4.8 MET). The level of air pollution exposure when cycling seemed to be comparable with the levels of exposure when sitting inside a vehicle. The VE during cycling was four times higher than resting value. Increased VE led to increased exposure to air pollution.     

Socio-technical IS design science research: developing design theory for IS integration management

Design science research is an essential part of IS research since the field should not only try to understand how the world is, but also how to change it. We argue that the aim of IS design science research should be to develop practical knowledge not only for the design of novel information technology (IT), but also for IS governance and management. Whereas at least some methodological support exists for researchers engaged in IT-centric design science research, limited support is available for researchers who want to develop design knowledge and theory for IS governance and management. To overcome this shortcoming, we suggest a socio-technical IS design science research approach. The approach has four main activities: (1) identifying problem situations and desired outcomes, (2) reviewing extant theories, knowledge and data, (3) proposing/refining design theory and knowledge, and (4) testing design theory and knowledge. The applicability and usefulness of the proposed approach is shown by means of a design science research project concerning IS integration management in the context of mergers and acquisitions.     

Profile Prediction and Fabrication of Wet-Etched Gold Nanostructures for Localized Surface Plasmon Resonance

Dispersed nanosphere lithography can be employed to fabricate gold nanostructures for localized surface plasmon resonance, in which the gold film evaporated on the nanospheres is anisotropically dry etched to obtain gold nanostructures. This paper reports that by wet etching of the gold film, various kinds of gold nanostructures can be fabricated in a cost-effective way. The shape of the nanostructures is predicted by profile simulation, and the localized surface plasmon resonance spectrum is observed to be shifting its extinction peak with the etching time.     

BDD anodic oxidation as tertiary wastewater treatment for the removal of emerging micro‐pollutants,pathogens and organic matter

This work reports for the first time the removal of 17α‐ethynylestradiol (EE2), a synthetic estrogen hormone, from secondary treated effluents by electrochemical oxidation. Experiments were conducted in a single compartment reactor comprising a boron‐doped diamond (BDD) anode and a zirconium cathode. EE2, in the range 100–800 µg L^?1, was spiked in the post‐chlorination effluent of a municipal treatment plant and oxidized at 0.9–2.6 mA cm^?2 current density. Complete degradation of 100 µg L^?1 EE2 was achieved in 7 min at 2.1 mA cm^?2 and inherent conditions, while the addition of 0.1 mol L^?1 NaCl achieved removal in just a few seconds. The process was then tested in the pre‐chlorination effluent at 2.1 mA cm^?2 and inherent conditions; complete E. coli killing and EE2 removal occurred in just 1.5 and 3.5 min, respectively, while overall estrogenicity (assessed by the YES assay) and residual organic matter (in terms of chemical oxygen demand (COD)) decreased by 50% and 85% after 30 min, respectively. These results clearly show the potential of BBD electrochemical oxidation to serve as an efficient tertiary wastewater treatment. Copyright © 2011 Society of Chemical Industry     

Thin-Layer Drying Characteristics and Quality Evaluation of Air-Dried Ganoderma Tsugae Murrill

Ganoderma is normally dried to extend its shelf life without using chemical preservative and to concentrate the medicinal value in the fruiting body. Convective hot air drying characteristics of Ganoderma tsugae Murrill were evaluated in hot air circulated oven at different drying temperatures, sizes, and air flow rates. The drying kinetics of Ganoderma tsugae in kidney shape and slices were investigated and compared at different drying conditions. The variation of effective moisture diffusivity values at decreasing moisture contents during drying was determined from the drying data. Four well-known thin-layer drying models were fitted to the experimental data and the Midilli model was found to satisfactory describe the drying characteristics of kidney-shaped Ganoderma tsugae. Ganoderma tsugae dried at 50°C with air velocity of 1.401 ms^?1 showed the highest retention of crude ganoderic acid content compared to other drying conditions.     

Linear and networked polymers formed by the near simultaneous occurrence of etherification and esterification under mild reaction conditions

Despite the large difference in their nucleophilicity, phenoxide and carboxylate anions take part nearly simultaneously in the aliphatic nucleophilic substitution reaction with 1,4‐dibromo‐2‐butene. This leads to the formation of ether (? O? ) and ester (? COO? ) linkages simultaneously under mild reaction conditions when hydroxyl benzoic acids are employed as nucleophiles. The process yields a new class of polymer broadly classified as unsaturated poly(ether ester) which are potentially functionalizable. This methodology has also been extended for preparing networked polymers by making use of 3,5‐dihydroxybenzoic acid as A₃ type monomer. Copyright © 2011 Society of Chemical Industry     

Nicotinic Acid Increases Adiponectin Secretion from Differentiated Bovine Preadipocytes through G-Protein Coupled Receptor Signaling

The transition period in dairy cows (3 weeks prepartum until 3 weeks postpartum) is associated with substantial mobilization of energy stores, which is often associated with metabolic diseases. Nicotinic acid (NA) is an antilipolytic and lipid-lowering compound used to treat dyslipidaemia in humans, and it also reduces non-esterified fatty acids in cattle. In mice the G-protein coupled receptor 109A (GPR109A) ligand NA positively affects the secretion of adiponectin, an important modulator of glucose and fat metabolism. In cattle, the corresponding data linking NA to adiponectin are missing. Our objective was to examine the effects of NA on adiponectin and AMPK protein abundance and the expression of mRNAs of related genes such as chemerin, an adipokine that enhances adiponectin secretion in vitro. Differentiated bovine adipocytes were incubated with pertussis toxin (PTX) to verify the involvement of GPR signaling, and treated with 10 or 15 µM NA for 12 or 24 h. NA increased adiponectin concentrations (p ≤ 0.001) and the mRNA abundances of GPR109A (p ≤ 0.05) and chemerin (p ≤ 0.01). Pre-incubation with PTX reduced the adiponectin response to NA (p ≤ 0.001). The NA-stimulated secretion of adiponectin and the mRNA expression of chemerin in the bovine adipocytes were suggestive of GPR signaling-dependent improved insulin sensitivity and/or adipocyte metabolism in dairy cows.     

Synthesis of Long-Chain β-Lactones and Their Antibacterial Activities against Pathogenic Mycobacteria

In the quest for new antibacterial agents, a series of novel long- and medium-chain mono- and disubstituted β-lactones was developed. Their activity against three pathogenic mycobacteria—M. abscessus, M. marinum, and M. tuberculosis—was assessed by the resazurin microtiter assay (REMA). Among the 16 β-lactones synthesized, only 3-hexadecyloxetan-2-one (VM005) exhibited promising activity against M. abscessus, whereas most of the β-lactones showed interesting activities against M. marinum, similar to that of the classical antibiotic, isoniazid. Regarding M. tuberculosis, six compounds were found to be active against this mycobacterium, with β-lactone VM008 [trans-(Z)-3-(hexadec-7-en-1-yl)-4-propyloxetan-2-one] being the best growth inhibitor. The promising antibacterial activities of the best compounds in this series suggest that these molecules may serve as leads for the development of much more efficient antimycobacterial agents.