Preparation of BaMgAl10O17∶Eu2+ and Its Phase Behavior in Microemulsion System

BaMgAl10O17∶Eu2 (BAM) was prepared in the microemulsion system and its phase behavior was studied. There exists a small region in the reverse microemulsion system where the dispersed particles are of spherical form. In this way, BAM blue phosphor with good dispersion can be synthesized. The microemulsion phase diagrams of the pseudo-ternary system (Triton X-100/cosurfactant-oil-BAM brine) were first established intuitively by the dilution method. The microstructure of microemulsions was determined through eyeballing, conductance technique, and polar optical microscopy. Its phase behavior is affected by various factors, such as temperature (room temperature, 30, 40 ℃), oil, surfactants, and cosurfactants in microemulsions. According to the phase diagrams, the microemulsion system of Triton X-100/1-hexanol-hexane-BAM brine was chosen to prepare the precursor. The BAM phosphor can be obtained via sintering the precursor at a comparatively low temperature. The phosphors were characterized by XRD and vacuum ultraviolet (VUV) spectra.     

3Cr-3Mo二次硬化钢的回火组织和力学性能

研究了3cr—3Mo二次硬化钢淬火回火后的组织和力学性能。结果表明：随回火温度的升高，试验钢中先后析出M3c、M2c和M7C3等碳化物，在575℃回火时硬度达到峰值；400一575℃回火后试验钢的抗拉强度约为l600MPa，冲击韧性为30J／cm^2；回火温度高于600℃时，强度和硬度迅速下降，冲击韧性增加；640℃回火时，以M2C型碳化物为主，抗拉强度为1100MPa，冲击韧性增加至55J／cm^2。     

Studies on the microstructure of the black-glazed bowl sherds excavated from the Jian kiln site of ancient China

The Jian kiln, located in present-day Jianyang county of Fujian province, mainly produced black-glazed tea bowls. Jian tea bowl was used as a utensil for tea tasting and was greatly appreciated by emperor Huizong of the Northern Song dynasty. The black glaze of Jian bowl was sometimes marked with streaks or spots, usually called “hare's fur” or “oil spot”, which are the crystalline markings of iron oxide precipitated during firing in the dragon kiln. In this study, black-glazed Jian bowl sherds excavated from the late Northern Song strata of Luhuaping and Daluhoumen Jian kiln sites were adopted as test samples. Based on the physico-chemical foundation for the formation of glaze microstructure, the correlation among composition, microstructure, and visual appearance has been investigated by means of energy-dispersive X-ray fluorescence, X-ray diffraction, and field emission electron microscopy. For the first time, the study provides realizing proofs for two kinds of microstructural forming mechanics.     

INDIRECT ACCELERATED ADAPTIVE FUZZY CONTROLLER

According to a type of normal nonlinear system, an indirect adaptive fuzzy （IAF） controller has been applied to those systems where no accurate mathematical models of the systems under control are available. To satisfy with system performance, an indirect accelerated adaptive fuzzy （IAAF） controller is proposed, and its general form is presented. The general form IAAF controller ensures necessary control criteria and system＇s global stability using Lyapunov Theorem. It has been proved that the close-loop system error converges to a small neighborhood of equilibrium point. The optimal IAAF controller is derived to guarantee the process＇s shortest settling time. Simulation results indicate the IAAF controller make the system more stable, accurate, and fast.     

引线框架材料QFe2.5加工工艺研究

本文介绍引线框架材料的发展现状，讨论引线框架用铜合金的强化机理，童点阐述引线框架用QFe2．5铜合金带材的性能及主要生产工艺（铸锭加热、热轧、时效退火等）。     

一种基于EJTAG快速在线烧写Flash的设计

介绍了MIPS的KITAG片上调试体系结构、调试流程，分析了当前在线烧写Flash的各种方法。并提出了一种新型的利用片上调试系统快速在线烧写Flash的设计。实验结果表明，该方案比现有方法的效率提高了88％。该方法已经成功运用在基于MIPSCPU的聚芯SoC的FPGA和ASIC版本中。     

静态EPS及其在建筑工程中的应用

一级负荷中特别重要的负荷，除由两个电源供电外，尚应增设应急电源。在供电条件比较差的地区，取得第二个电源供给一级负荷有困难时，也需要增设应急备用电源。以往经常用自备柴油发电机组、蓄电池、干电池和镍锦电池应急灯作为应急备用电源。本文通过对目前常用的各种应急电源的分析比较，推荐一种新颖的、静态、无公害、免维护无人值守的、供电质量好、安全可靠的集中供电式EPS装置。     

IF板与08Al板的成形性能研究

通过模拟成形性试验，对新型超深冲用IF钢板和传统冲压用08Al钢板的冲压成形性能进行了研究．结果表明：IF板的拉深性能、扩孔性能、胀形性能以及“拉深-胀形”复合性能等均优于08Al板，其中，扩孔性能和平面各向异性的改善最为显著；各项试验中，IF板的成形力普遍小于08Al板。     

智能磁流变(RM)阻尼器的实验研究

磁流变 (MR)液是一种新型的智能材料 ,而MR阻尼器具有在外加电流作用下快速可逆地改变阻尼特性的特点。本文针对所作的MR阻尼器实验研究 ,介绍了实验过程及相关数据 ,并对其进行了分析。实验表明 :MR阻尼器具有良好的阻尼可控制特性 ,是结构消能减振控制的理想元件。