Creep and Creep Fracture in Hot-Pressed Alumina

The creep and creep fracture behavior of two hot-pressed aluminas are presented, for both flexural and tensile testing. Steady-state power-law creep is observed with a stress exponent of about 2 for each material. Three distinct fracture regimes are found. At high stress in flexure, fracture occurs by slow crack growth with a high stress dependence of the failure time. At intermediate stresses, in both flexure and tension, creep fracture occurs by multiple microcracking after modest strains. Failure times exhibit a modest stress dependence (stress exponent of 2.5 in tension and 3 in flexure), with a constant failure strain equal to 0.09. The failure times are considerably longer in flexure than in tension, because of the constraint imposed on crack growth by the bending geometry. We conclude that flexure cannot be used for creep lifetime assessment, even in simple, single-phase materials such as Al₂O₃. At low stresses, in tension, failure also exhibits a modest stress dependence but with a much higher failure strain. The material shows the onset of super-plastic behavior.     

Fiber,hypercholesteremia, and atherosclerosis

Epidemiological data suggest that populations subsisting on high fiber diets are free of a number of the diseases of Western civilization, among them coronary heart disease. Studies in animals and man show that each type of fiber exerts it own specific influence. Thus, in man bran has no effect on serum lipids, but pectin lowers cholesterol levels. In animals fed atherogenic diets, alfalfa and pectin exert some measure of protection, but cellulose does not. To fully understand the mode of action of dietary fiber, it is necessary to ascertain the mechanism(s) of action of each chemical component of that fiber.     

Commodity prices as related to vegetable oil marketing,prices and utilization

Journal of the American Oil Chemists' Society -     

Comments on the characterisation of oxidation catalysts using TPR/TPO

Temperature programmed reduction (TPR) and oxidation (TPO) are used extensively in catalyst characterisation. In this paper, we examine the use of TPR/TPO cycles for the characterisation of a range of molybdates and single oxides. In particular we observe that the first cycle differs from that of subsequent analyses, even when the maximum temperature is limited to that used in the catalytic reaction. The effect is independent of heating rates and cooling atmospheres and has been demonstrated using different bed configurations. This observation has significance when these oxides are used in periodic flow reactors that involve many cyclical reduction/oxidation.     

Calories,fat and cancer

The experiments reported are part of our effort to dissociate the tumor-enhancing effects of dietary fat and high caloric intake. Rats either were fed ad libitum diets containing 4% corn oil or their calories were restricted by 40% and their diets contained 13.1% corn oil. Incidence of 7,12-dimethylbenz(a)anthracene (DMBA)-induced mammary tumors was 80% in rats fed ad libitum and 20% in those fed the calorie-restricted diets. Incidence of 1,2-dimethylhydrazine (DMH)-induced colon tumors was 100% in rats fed ad libitum and 53% in those whose caloric intake was restricted by 40%. The tumor yield (tumors per tumor-bearing rat) was significantly lower in rats on caloric restriction. In another series, rats were fed diets containing 5, 15 or 20% corn oil ad libitum or were fed calorie-restricted (by 25%) diets which provided 20 or 26.6% corn oil (therefore, the same absolute amount of fat was consumed in each of the pair-fed groups). Tumor incidence and tumor yield in the two calorie-restricted groups were similar to those seen in the rats fed 5% fat ad lititum; tumor burden (total g of tumor) was 45–65% lower in the calorie-restricted rats. The data suggest that caloric intake is a more stringent determinant of tumor growth than fat intake.     

Aqueous gel permeation chromatography: The effect of solvent ionic strength

Porous glass packing materials have been used for gel permeation chromatography using an aqueous phosphate buffer. Elution volumes were determined for polystyrene sulfonates, dextrans, and small neutral and charged molecules at three different ionic strengths, viz., 0.01M, 0.1M, and 1.0M phosphate, pH 7.0. The pore diameters of the glasses studied were 75, 240, 700, and 2000 Å. Elution volumes of nonionic species were unaffected by changing the solvent ionic strength. Elution volumes of charged species were markedly affected by the ionic strength of the solvent. This was attributed to a combination of decreased polymer dimensions and decreased ionic exclusion with increasing buffer concentration. The use of low ionic strength solvents may be exploited to tailor the separating range for polyelectrolytes with porous glass packings. This is particularly useful in the low molecular weight range where the lowest pore size available is 75 Å.     

Direct Measurement of Transformation Zone Strains in Toughened Zirconia

Residual strains responsible for crack tip shielding have been measured within transformation zones surrounding cracks in Mg-PSZ. Two techniques were used for strain measurement: moiré interferometry and high-resolution image matching. Both methods provide maps of differential in-plane displacements within the specimen surface intersected by the crack, the latter method with the higher resolution. The results are compared with finite-element analysis to assess surface relaxation effects, and the measured strains are used to evaluate the crack tip shielding stress intensity factor. Calculations based on the assumption that the unconstrained transformation strain is hydrostatic dilatation yielded results that were significantly smaller than the measured toughness increases.     

Free fatty acids in cultured cells

A method for isolation and quantitation of cellular free fatty acid has been developed. When this method was used to quantitate the free fatty acid content of various cells and tissues, their levels of free fatty acids were found to vary over a wide range. In comparing tissue culture cells having different levels of free fatty acid, it was demonstrated that the conditions of culture and the type of serum in the medium are not responsible for the difference in levels. Isotopic studies have shown that the cellular free fatty acid is not biosynthesized, but is derived from the free fatty acid of the medium. Preliminary studies on the fate of the intracellular free fatty acid and a discussion of possible factors controlling the level of this compound in cells are presented.     

Deformation Bands in Ceria-Stabilized Tetragonal Zirconia/Alumina : II, Stress-Induced Aging at Room Temperature

A stress-induced aging phenomenon is observed to occur at room temperature in deformation bands introduced into a 8.5 mol% ceria-stabilized tetragonal zirconia/alumina (CeTZP/A1₂O₃) composite by flexural loading. The aging occurs with time after unloading and in laboratory air. Over a period of 100 days, the concentration of monoclinic zirconia within a deformation band increases and, in addition, the wedge-shaped deformation band grows with time. Accompanying these two changes are an increase in the tensile stress in the remaining tetragonal zirconia within the deformation band and a consequential increase in the overall compressive stress within the band. The average value of the monoclinic concentration within the deformation band is found to increase parabolically with time, suggesting the mechanism responsible for the observed aging is diffusion limited. Away from the deformation bands, no aging is observed to occur, suggesting aging is stress dependent. Although a water-vapor-mediated mechanism cannot be ruled out, it is proposed that the observed aging is in fact due to a tensile stress assisted chemical reduction of Ce⁴⁺ to Ce³⁺ whose rate is controlled by the indiffusion of oxygen vacancies driven by the tensile stress gradient. It is further proposed that the deformation band grows with time, since the region ahead of the band is under tension and hence subject to an enhanced rate of reduction