Evaluation of Qbd for electrons tunneling fromthe Si/SiO2 interface compared to electron tunneling from thepoly-Si/SiO2 interface

Electrical time-to-breakdown (TTB) measurements have shown the charge to breakdown Q_bd of gate oxide capacitors fabricated on n-type well (n-well) substrates always to be higher than that of capacitors on p-type well (p-well) substrates on the same wafer when both are biased into accumulation under normal test conditions. Here the authors correlate the higher n-well Q_bd to smooth capacitor oxide/substrate interfaces and minimized grain boundary cusps at the poly-Si gate/oxide interfaces, confirming that Fowler-Nordheim tunneling is the dominant current conduction mechanisms through the oxide. They correlate higher Q_bd to higher barrier height for a given substrate type and observe that the slope of the barrier height versus temperature plot is lower for both p-well and n-well cases with electrons tunneling from the silicon substrate. This is attributed to surface roughness at the poly-Si gate/SiO₂ interface. A poly-Si gate deposition and annealing process with clean, smooth oxide/substrate interfaces will improve the p-well breakdown characteristics and allow higher Q_bd to be achieved     

Study of Desorption and Adsorption During Grain Aeration

One requirement in designing and operating and operating system is to minimize the moisture change in stored grain. Moisture transfer during the aeration process is generally believed to be caused by the partial pressure difference between water in grain and water in air (P₃-P₄). A mathematical model was developed for rough rice, which predicts the partial pressure difference under various grain and ambient conditions. Observations of moisture change over 10 aeration tests confirmed the good correlation between sorption phenomena and partial pressure differences. Studies indicated that air relative humidity, air temperature, grain temperature and grain moisture are significant factors influencing the partial pressure differences and, thus, affecting     

Aromatic nitrations by mixed acid. Slow liquid-liquid reaction regime

Aromatic nitrations by mixed acid have been selected as a specific case of a heterogeneous liquid-liquid reaction. An extensive experimental programme has been followed using adiabatic and heat-flow calorimetry and pilot reactor experiments, supported by chemical analysis. A series of nitration experiments has been carried out to study the influences of different initial and operating conditions such as temperature, stirring speed and sulphuric acid concentration. In parallel, a mathematical model to predict the overall conversion rate has been developed. In this paper the mathematical modelling and the implementation and experimental validation for benzene, toluene and chlorobenzene mononitration in the kinetic control regime (slow liquid-liquid reaction) are presented and discussed.     

Measurements of Stress Intensity Factors of an Interface Crack Under Mixed Mode Loading

The optical method of caustics has been utilised to measure both the stress intensity factor for a crack lying along the interface of an aluminium/epoxy bimaterial specimen, and the mode mixity arising from the difference in the elastic properties across the interface. Measurements were carried out by using a novel modification to the method whereby caustics are produced and measured from both sides of the specimen, so compensating automatically for the distortion induced in the specimen due to misaligned loading fixtures. A flat reflective surface across the interface was obtained by adhering a reflective coating to the specimen. Verification that this coating does not affect measurement accuracy was obtained by comparing stress intensity factors measured from coated and uncoated monolithic aluminium specimens where good agreement was found to exist between both measurements.     

Performance evaluation of air-conditioning units

A limited selection of samples of small and medium size air-conditioning equipment being marketed or manufactured in Kuwait was tested in an internationally reputed laboratory. The actual performance results obtained from laboratory tests were analyzed and compared with the commercially available information from the manufacturers for the same selected units. The analysis indicated the quality of air-conditioning equipment available to the Kuwaiti user.     

Variable-bit-rate speech transmission using punctured convolutionalcodes

Rate (n-1)/n punctured convolutional codes are very effective in conjunction with embedded differential pulse code modulation (EDPCM) in variable-bit-rate speech transmission. The authors investigate the performance of this variable-bit-rate EDPCM system in terms of probability of bit error and audio signal-to-noise ratio (SNR) versus channel SNR in an additive white Gaussian noise and Rayleigh fading channel using soft-decision decoding for specific sets of code generators of punctured convolutional codes. The results show that different sets of code generators affect the performance in terms of both the probability of bit error and the audio SNR. Improvements were obtained in the cases of Gaussian nonfading and Rayleigh fading channels using soft-decision decoding