The influence of processing on the microstructure and the microwave properties of Co-F-codoped barium strontium titanate thick-films

The influence of processing on the microstructure and the dielectric properties of Co-F-codoped Ba_0.6Sr_0.4TiO₃ (BST) thick-films has been investigated. BST powders with different particle sizes were prepared and applied on alumina substrates by screen-printing. The resulting thick-films were sintered at different holding times and characterized with respect to their microstructure and microwave properties. The microstructure of the thick-films shows a clear dependency on sintering time and initial particle size. In addition to grain growth, the formation of a secondary phase is observed at the interface between substrate and BST with increasing sintering time. The dielectric characterization at microwave frequencies shows an increase of tunability with larger grain size while the dielectric loss is even lowered. This shows the strong influence of the microstructure on the material properties and the possibility of tailoring the material through specific processing.     

Lignin from Annual Plants as Raw Material Source for Flavors and Basic Chemicals

The enzymatic conversion of lignins, possibly in combination with electrochemical oxidation, makes aromatics such as syringol, guaiacol, vanillin and catechol available in the qualities required by the fragrance industry. The lignins were obtained by soda digestion from wheat straw and Miscanthus, characterized and then converted with laccases. The overall yield amounted up to 9 wt % with a product spectrum confined to four substances. Catechol was the major product, with a fraction of ≈75 %. It can easily be isolated by extraction with acetone.     

High-Throughput Experimentation in Oxidation Catalysis

High-throughput experimentation in catalysis comprises the following components: (i) automated high-throughput synthesis, (ii) testing in Stage I and Stage II, for which to some extent novel assays are necessary, (iii) data handling and experimental design tools, and (iv) robotics. This contribution covers these topics, using examples from the research of the authors, but also from the literature, in order to illustrate the problems and opportunities associated with high-throughput experimentation in catalysis, focusing particularly on heterogeneous catalysis.     

Silphinene Sesquiterpenes as Model Insect Antifeedants

Silphinene sesquiterpenes are established chrysomelid antifeedants. In this work, nine silphinene analogs, 11-acetoxy-5-angeloyloxysilphinen-3-one (1), 11-acetoxy-5-tigloyloxysilphinen-3-one (2), 11-acetoxy-5-iso- butyryloxysilphinen-3-one (3), 11-hydroxy-5-angeloyloxysilphinen-3-one (4), 11,5-dihydroxysilphinen-3-one (5), 11,5-diacetoxysilphinen-3-one (6), 5,11-diisobutyryloxysilphinen-3-one (7), silphinen-3,5,11-trione (8), and O-methyl-5-epicantabrenolic acid methyl ester (10), and a presilphiperfolane sesquiterpene (9) were tested against several divergent insect species, including the lepidopteran Spodoptera littoralis, the chrysomelid Leptinotarsa decemlineata, and five aphid species, and their antifeedant effects were compared with those of picrotoxinin, a GABA-antagonist, and thymol, an allosteric modulator for insect GABA receptors. All insects tested responded to at least one silphinene analog and/or GABA antagonist. Compound 3 and thymol were effective antifeedants against all species tested except S. littoralis, with varying potencies according to their feeding ecologies. The toxicity of these compounds was species-dependent and did not correlate with their antifeedant effect.     

DEPOSITION OF A FINE POWDER IN HORIZONTAL PIPELINES AND BENDS

The deposition of a very fine powder in a horizontal, lean-phase pneumatic conveying conduit containing a 90° bend has been studied experimentally. The total deposition and the deposition pattern were studied as a function of superficial gas velocity, solids loading and bend geometry: one sharp and three smooth bends of different radii of curvature were used. Most deposition was seen in the sharp bend, while in the smooth bends the deposition did not vary much with radius of curvature. The deposition decreased significantly with increasing superficial gas velocity. The experimental results were compared with CFD simulations of the flow field. The observations are consistent with the notion of deposition in regions with low near-wall gas velocity, indicating that models for deposition should be sought in considerations of the deposit stability for this type of system.     

Solubility of Si3N4 in Liquid SiO2

The nitrogen solubility in the SiO₂-rich liquid in the metastable binary SiO₂-Si₃N₄ system has been determined by analytical TEM to be 1%–4% of N/(O + N) at 1973–2223 K. Analysis of the near edge structure of the electron energy loss peak indicates that nitrogen is incorporated into the silicate network rather than being present as molecular N₂. A regular solution model with a positive enthalpy of mixing for the liquid was used to match the data for the metastable solubility of N in the presence of crystalline Si₃N₄ and to adjust the computed phase diagram. The solubility of Si₃N₄ in fused SiO₂ is far less than reported in liquid silicates also containing Al, Mg, and/or Y. Apparently, these cations act as modifiers that break anion bridges in the silicate network and, thereby, allow further incorporation of Si₃N₄ without prohibitive amounts of network cross-linking. Finally, indications emerged regarding the diffuse nature of the Si₃N₄-SiO₂ interface that leads to amorphous regions of higher N content.     

A conversation on VB vs MO theory: a never-ending rivalry?

Quantum mechanics has provided chemistry with two general theories, valence bond (VB) theory and molecular orbital (MO) theory. The two theories were developed at about the same time, but quickly diverged into rival schools that have competed, sometimes fervently, on charting the mental map and epistemology of chemistry. Three practitioners of MO and VB theory talk - fighting a little, trying to understand - of the past and present of these two approaches to describing bonding in molecules.     

Combined TPS, XPS, EXAFS, and NO-TPD study of the sulfiding of Mo/Al2O3

The sulfiding of Mo/Al₂O₃ in H₂S/Ar versus in H₂S/H₂ has been studied by temperature-programmed sulfiding (TPS), X-ray photon electron spectroscopy (XPS), extended X-ray absorption fine structure (EXAFS), and temperature-programmed desorption of NO (NO-TPD). All the applied techniques agree on the sulfur content in the sulfided catalysts and the findings are in accord with a model for the H₂S production reaction. The nucleation and growth of well-ordered MoS₂ clusters are probed by XPS during sulfiding with and without the presence of hydrogen. The resulting dispersion of the MoS₂ phase is evaluated on the basis of XPS, EXAFS, and NO-TPD, and is found to be highest when the sulfiding occurs in the presence of hydrogen.     

Oxidative catabolism of α-tocopherol in rat liver microsomes

The goal of this study was to clarify the mechanism responsible for the catabolism of α-tocopherol. The vitamin, bound to albumin, was incubated with rat liver microsomes and appeared to be broken down. Optimal production of the metabolite was obtained when 1 mg of microsomal protein was incubated with 36 μM of α-tocopherol in the presence of 1.5 mM of NADPH. Chromatographic and mass spectrometric analyses of the metabolite led to the conclusion that it consists of an ω-acid with an opened chroman ring, although we could not perform nuclear magnetic resonance analysis to confirm this. Our data show that α-tocopherol is ω-oxidized to a carboxylic acid and that this process can occur in rat liver microsomes in the presence of NADPH and O₂. The oxidation to the quinone structure appears to be a subsequent event that may be artifactual and/or catalyzed by a microsomal enzyme(s).