Clinical assessment research with older adults.

Methodological issues in geropsychological assessment research are discussed and exemplified with recent investigations. Increased use of short-term longitudinal designs, more diverse and representative sampling, and routine inclusion of measures of health are among the recommendations made for future studies. Caution is urged in the application of new tests or screening batteries until sufficient independent validation studies are completed. Research contrasting neuropsychological performance of older persons from different racial and ethnic groups is briefly reviewed, and applications of geropsychological assessment to practical arenas such as competency determination are critiqued. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Performance Evaluation of Packet Mobile Communications through Level Crossing Analysis

In this paper the performance of a packet mobile radio network is studied inthe presence of shadow fading outage intervals.Under quite general assumptions for the medium access protocol,the probability mass function of the sequence of packets that may be lostdue to an outage interval is derived. It is seen that long sequences of lostpackets are likely to occur for typical values of the mobile speed andshadowing correlation parameters.For delay constrained sources, e.g., voice, the analysis is mainly focused atderiving the probability function of the sequence of dropped packetsand the probability of dropping. For data sources, the delay statistic isalso derived. In the latter case, the effect of finite buffer length isaddressed. Simulation is used to verify the accuracy of approximations introduced in the analysis.     

A VSWR-protected silicon bipolar RF power amplifier with soft-slope power control

This paper presents the design and measured performance of a 1.8-GHz power amplifier featuring load mismatch protection and soft-slope power control. Load-mismatch-induced breakdown can be avoided by attenuating the RF power to the final stage during overvoltage conditions. This was accomplished by means of a feedback control system, which detects the peak voltage at the output collector node and clamps its value to a given threshold by varying the circuit gain. The issue of output power control has been addressed as well. To this end, a temperature-compensated bias network is proposed, which allows a moderate power control slope (dB/V) to be achieved by varying the circuit quiescent current according to an exponential law. The nonlinear power amplifier was fabricated using a low-cost silicon bipolar process with a 6.4-V breakdown voltage. It delivers a 33.5-dBm saturated output power with 46% maximum power-added efficiency and 36-dB gain at a nominal 3.5-V supply voltage. The device is able to tolerate a 10:1 load standing-wave ratio up to a 5.1-V supply voltage. Power control slope is lower than 80 dB/V between -15 dBm and the saturated output power level.     

异步电机性能微机测试系统设计

结合工程实际介绍了异步电机计算机辅助测试（CAT）系统的硬件、软件组成、技术方案确定以及设计原则。现场运行表明，该系统稳定可靠，且具有较高的性能价格比。     

Toward automatic phenotyping of developing embryos from videos.

We describe a trainable system for analyzing videos of developing C. elegans embryos. The system automatically detects, segments, and locates cells and nuclei in microscopic images. The system was designed as the central component of a fully automated phenotyping system. The system contains three modules 1) a convolutional network trained to classify each pixel into five categories: cell wall, cytoplasm, nucleus membrane, nucleus, outside medium; 2) an energy-based model, which cleans up the output of the convolutional network by learning local consistency constraints that must be satisfied by label images; 3) a set of elastic models of the embryo at various stages of development that are matched to the label images.     

Development of calibration models for quality control in the production of ethylene/propylene copolymers by FTIR spectroscopy,multivariate statistical tools,and artificial neural networks

Principal component regression (PCR), partial least squares (PLS), StepWise ordinary least squares regression (OLS), and back‐propagation artificial neural network (BP‐ANN) are applied here for the determination of the propylene concentration of a set of 83 production samples of ethylene–propylene copolymers from their infrared spectra. The set of available samples was split into (a) a training set, for models calculation; (b) a test set, for selecting the correct number of latent variables in PCR and PLS and the end point of the training phase of BP‐ANN; (c) a production set, for evaluating the predictive ability of the models. The predictive ability of the models is thus evaluated by genuine predictions. The model obtained by StepWise OLS turned out to be the best one, both in fitting and prediction. The study of the breakdown number of samples to be included in the training set showed that at least 52 experiments are necessary to build a reliable and predictive calibration model. It can be concluded that FTIR spectroscopy and OLS can be properly employed for monitoring the synthesis or the final product of ethylene–propylene copolymers, by predicting the concentration of propylene directly along the process line. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Surface adsorption of comb polymers by Monte Carlo simulations

This paper reports off-lattice Monte Carlo simulations of highly-branched comb homopolymers weakly adsorbed on a flat, featureless surface showing only covolume and dispersion interactions with the adsorbate. A minimal coarse-grained model, described by hard spheres connected by harmonic springs, was employed. The interaction energy of the adsorbed combs and linear chains is first discussed as a function of the molecular mass and of the number of beads in contact with the surface. The molecular size is then investigated as a function of backbone length and branching density at a fixed arm size. The apparent swelling exponents of the adsorbed combs are larger than those of the corresponding linear chains, and much larger than that of the free molecules. This result indicates a surface-induced stiffening of the comb backbone, further studied through the persistence length l_pers. It is found that l_pers increases upon adsorption over the free-molecule value, more so the larger is the branching density. Finally, the thickness of the adsorbed layer, the surface-induced molecular anisotropy and the molecular aspect ratio are investigated as a function of branching density and molecular mass.