声波测井换能器激发响应实验研究

声波测井换能器的激发响应由换能器振动时所表现出来的动态阻抗和激发电路参数决定。而换能器的动态（阻抗）参数随压电晶体及其装配方式（力学边界条件）改变。为了测量换能器动态参数的影响，采用声波测井仪器常用的压电晶体和升压变压器，通过改变激发脉冲宽度和直流电压进行了实验，结果发现：在换能器两端的瞬态响应中，一共有三个二阶网络响应，分别对应于不同的频率。最低的一个影响声波测井波形的基线、与换能器主频接近的一个决定激发效率以及电路与压电晶体之间的匹配关系，是激发电路设计中比较关键的，其参数可以通过导纳圆测量仪器得到。     

我国建筑石油沥青标准的沿革及现状

论述了我国建筑沥青标准的变化历程及现状,对我国建筑沥青的生产、产品质量情况及现行国家标准GB/T 494-1998《建筑石油沥青》的不足之处进行了分析。提出了今后应生产的建筑沥青品种及应参照美国材料与试验协会标准ASTM D312《屋顶用沥青的标准规格》、我国石化行业标准SH/T0002-1990(1998)《防水防潮石油沥青》,修订GB/T494- 1998的建议。以进一步达到增加建筑沥青牌号,提高建筑沥青质量和使用性能的目的,满足建筑工业的发展对沥青多牌号、高质量、使用性能好的要求。     

三重介质油藏干扰试井压力动态特征

在建立三重介质油藏试井解释模型的基础上，对该类油藏的干扰试井压力动态变化进行了研究；分析了井筒储存、表皮系数、窜流系数以及弹性储容比对观测井井底压力的影响。结果表明，表皮系数对观测井的井底压力没有影响，而井筒储存是否会对观测井井底压力造成影响取决于井筒储存系数的大小以及激动井和观测井之间的距离，窜流系数和弹性储容比对观测井井底压力的影响与单井试井的结果相类似。     

我国道路石油沥青标准变更及产品生产应用的回顾

回顾我国50 a来道路石油沥青标准的变更及产品生产应用情况。随着我国炼制原油品种的增加和原油性质的改变及道路建设对沥青性能不断提高的要求,我国道路沥青标准也在不断的提高,目前的道路沥青标准已达到或接近国际先进水平。标准的提高,推动了沥青生产技术水平的提高,生产技术水平的提高满足了使用要求。     

新设备技术在催化裂化装置上的应用

文章介绍了近年来在催化裂化装置上应用的新设备、新技术,如BY型旋风分离器、BSX型旋分式三级旋风分离器、上下拱型三级旋风分离器、下拱型三级旋风分离器、SHS“自蔓延”技术、SWY外取热器、BWJ型喷嘴、自流浇注料、Actehem高耐磨衬里、弓形钢丝纤维、侧拉环锚固钉、分体可拆人孔等的结构特点及实际应用情况。     

含沙探测系统在海洋石油平台上的应用

在海上石油平台CFD11项目中，首次使用了含沙探测系统，对平台上工艺流程中沙子的含量做出检测。含沙探测系统由探头、计算单元和数据处理单元／操作系统组成，安装非常方便，操作也很简单，探测结果非常有利于海洋石油平台的设备保护。     

Cu基络合物催化甲醇液相氧化羰化反应

针对甲醇液相氧化羰基化法合成碳酸二甲酯(DMC)工艺,开发了新型Cu基络合催化剂(CuB rnLm)。对CuB rnLm催化剂的活性及其稳定性进行了研究。实验结果表明,采用该催化剂,甲醇转化率和DMC选择性较高;元素价态和物质结构分析表明,CuB rnLm催化剂循环使用5次后仍保持较好的稳定性。采用正交设计和中心响应曲面法设计实验,并使用S tatistica软件进行统计分析,寻求出反应的主要影响因素,并得到优化的工艺条件:反应温度100~110℃、反应压力3.0~3.5M Pa、反应时间4~6h、CuB rnLm催化剂质量浓度(以甲醇的体积计)0.15~0.20g/mL。在此工艺条件下,甲醇转化率可达23%以上,DMC的选择性为96%~98%。     

On the Feasibility of Growing Pb[(Zn1/3Nb2/3)0.91Ti0.09]O3 Single Crystals

Pb[(Zn_1/3Nb_2/3)_0.91Ti_0.09]O₃ (PZNT91/9) single crystals were grown by two methods: from solution using PbO as a self‐fluxing agent (SC method) and directly from the melt without fluxing (MC method). In both growth methods, an allomeric Pb[(Mg_1/3‐Nb_2/3)_0.69Ti_0.31]O₃ (PMNT69/31) single crystal was used as a seed. X‐ray diffraction patterns of ground crystals showed that phase‐pure perovskite PZNT91/9 single crystals were successfully fabricated by the above two methods. The composition of the crystals obtained by both the SC and MC methods was analyzed using X‐ray fluorescence, which confirmed that the crystal composition is close to the nominal value, although volatilization of PbO and segregation during crystal growth are inevitable. The MC PZNT91/9 crystals exhibit excellent piezoelectric properties, with the piezoelectric constant, d₃₃, in the range of 1800–2200 pC N^–1. This value is comparable to that of the SC crystals. However, the MC crystals show an abnormal dielectric behavior. In contrast with the SC crystals, in the MC crystals a much broader dielectric peak appears in the dielectric response curves, accompanied by a much lower peak temperature of around 105 °C. Furthermore, frequency dispersion is apparent over a much wider temperature range (even more apparent than in pure relaxors), where a large, i.e., about 70 °C, full width at half maximum (FWHM) for the dielectric peaks is observed in the dielectric response. It is speculated that such an unusual phenomenon correlates with defects, microinhomogeneities, and polar regions in the as‐grown MC crystals. The origins of this abnormality have not been interpreted in detail until now. However, optical observation of the domain structure confirms that both the SC and MC crystals possess complex structural states.     

A decision support system for interactive decision making - Part II: analysis and output interpretation

For pt.I see ibid., p.42-55 (2003). The development of a comprehensive decision support system, GMCR II, for the systematic study of real-world interactive decision problems is presented. The companion paper (Part I), discusses how GMCR II elicits, stores, and manages conflict models; here (Part II), the focus is on GMCR IIs analysis and output interpretation subsystems. Specifically, this paper describes the powerful and efficient analysis engine contained in GMCR II, its informative output presentation and interpretation facilities, and a number of follow-up analyses. Furthermore, an illustrative case study is used to demonstrate how GMCR II can be conveniently applied in practice.     

琼东南盆地深水区储层分布规律

琼东南盆地深水区经历了断陷、断拗和拗陷3大构造演化和沉积充填阶段,主要发育4种沉积体系,相应地形成了4类主要储层:1)陵三段扇三角洲或滨海相砂岩储层;2)三亚、梅山组滨浅海相砂岩储层;3)三亚—莺黄组低位体储层;4)梅山组台地边缘礁滩灰岩储层。平面上,储层发育具有明显的分带性,可划分为:北部浅水陆架滨岸砂岩、三角洲砂岩储层发育带;中央坳陷低位体储层发育带;南部永乐隆起区碳酸盐岩储层发育带。深水区主要位于后2个带,每个带储层发育的控制因素不同,可以进一步划分为多个储层发育区。每个储层发育区存在多套储盖组合,每套储盖组合在多个储层区中发育。其中台地灰岩储层可能成为南部隆起区具有重要意义的勘探层系。