Isoenzymes of wheat o-diphenolase revealed by column isoelectric focusing

Summary Common wheat o-diphenolase at different purification steps has been submitted to column isoelectric focusing electrophoresis. The fraction purified with calcium phosphate gel shows multiple forms focused at pI 3.60, 4.95, 6.80, and 9.60. The enzyme activity and the purification degree of the four enzymatic components obtained have been calculated. The major fraction recovered after purification by chromatography on DEAE-cellulose does not display other multiple forms; however, it has some enzymatically inactive proteins well separated in the pH-gradient. The enzymatic protein, focused at pI 9.60, thus achieves a 1753-fold purification over the crude extract. The application of the technique allows a characterization of the wheat o-diphenolase and its recovery in highly purified form.

---

Isoenzyme von o-Diphenoloxydase aus Weichweizen, identifiziert durch isoelektrisches Fokussieren über Säule

Zusammenfassung Weichweizen-o-Diphenoloxydasen verschiedener Reinigungsstufen wurden über eine Säule isoelektrisch focussiert. Das durch Calciumphosphatgel gereinigte Enzym (Fraktion C) zeigt 4 multiple Formen, focussiert bei pI 3,60; 4,65; 6,80 und 9,60. Die Aktivität und der Reinheitszustand von diesen vier Formen wurden berechnet. Die Fraktion C wurde durch Chromatographie über Cellulose weiter gereinigt. Die in größeren Mengen gewonnene Fraktion zeigte beim isoelektrischen Focussieren keine multiple Formen mehr, nur eine Trennung von enzymatisch inaktiven Proteinen beim pH-Gradienten. Das enzymatisch aktive Protein, focussiert bei pI 9,60, zeigte einen 1753 mal besseren Reinheitszustand als das Rohenzym. Die Anwendung dieser Technik erlaubt die Charakterisierung der Weichweizen-o-Diphenoloxydasen und ihre Gewinnung in einem hochgereinigten Zustand.

     

Carbon nanotubes/polydimethylsiloxanes systems for thermal management of miniaturized electronic components

The thermal performances of nanocomposite layers formed by Single-walled Carbon Nanotubes (SWCNT) dispersed in 2 different kind of polydimethyl-siloxane (PDMSO) matrices has been investigated by measuring the thermal resistance under conditions similar to the ones used for thermal management in microelectronics. A series of nanocomposite samples with thickness in the range 25 microm(-1) cm have been tested. The nanocomposites were prepared varying the amounts of nanotubes embedded in the matrix (from 0.1 to 5%w). In some cases also microsized graphites were mixed to the nanotube's fillers. For 25 micron thick layers, the thermal resistance of the neat silicone specimen can be reduced of 54% with the addition of 2%w carbon nanotubes. The variation of thermal conductivity as a function of the SWCNT's loading is reported and discussed. Furthermore the dispersion's effects of the nanotubes in the layers and the effects on the realization of a net-like system have been investigated.     

Computational fluid dynamic simulations of image-based stented coronary bifurcation models

One of the relevant phenomenon associated with in-stent restenosis in coronary arteries is an altered haemodynamics in the stented region. Computational fluid dynamics (CFD) offers the possibility to investigate the haemodynamics at a level of detail not always accessible within experimental techniques. CFD can quantify and correlate the local haemodynamics structures which might lead to in-stent restenosis. The aim of this work is to study the fluid dynamics of realistic stented coronary artery models which replicate the complete clinical procedure of stent implantation. Two cases of pathologic left anterior descending coronary arteries with their bifurcations are reconstructed from computed tomography angiography and conventional coronary angiography images. Results of wall shear stress and relative residence time show that the wall regions more prone to the risk of restenosis are located next to stent struts, to the bifurcations and to the stent overlapping zone for both investigated cases. Considering a bulk flow analysis, helical flow structures are generated by the curvature of the zone upstream from the stent and by the bifurcation regions. Helical recirculating microstructures are also visible downstream from the stent struts. This study demonstrates the feasibility to virtually investigate the haemodynamics of patient-specific coronary bifurcation geometries.     

Profiling selected phytochemicals and nutrients in different tissues of the multipurpose tree Moringa oleifera L., grown in Ghana

The purpose of this new study was to determine the types and levels of major phytochemicals (non-nutrients) and nutrients in the different tissues from vegetative and flowering Moringa oleifera L. an important multipurpose crop. Rhamnose and acetyl-rhamnose-substituted glucosinolates were found in all of the M. oleifera tissues with different profiles depending on the tissue. In addition the tissues of M. oleifera had a relatively complex flavonoid profile consisting of glucosides, rutinosides, malonylglucosides and traces of acetylglucosides of kaempferol, quercetin and isorhamnetin. Fatty acid profiling of the different tissues showed that leaves were rich in palmitic (16:0) and linolenic (18:3) acid whereas seeds were predominated by oleic acid (18:1). Roots were rich in palmitic and oleic acid, whereas stems and twigs predominately contained palmitic acid. Potassium, magnesium and calcium were the predominant minerals in all of the tissues. Low levels of selenium were detected only in whole seeds.     

Highly efficient preparation of free all-trans-astaxanthin from Haematococcus pluvialis extract by a rapid biocatalytic method based on crude extracellular enzyme extract

A highly efficient, rapid, green and safe procedure for the preparation of free all-trans-astaxanthin from Haematococcus pluvialis algal extract, by a crude extracellular enzyme extract, was reported. The free all-trans-astaxanthin obtained by the biocatalysed method had fewer side products compared to the saponification procedure. Through single-factor experiments and a Box–Behnken design, it was possible to find the optimal biocatalytic conditions for the hydrolysis of 2 mg of H. pluvialis oil with 14.7 mg (protein content) of lyophilised crude extracellular enzyme extract obtained from Pseudomonas aeruginosa. The reaction was carried out in 30 min at pH 9.16 and 36 °C, in 5.5 mL total reaction volume, under nitrogen atmosphere and dark conditions. The hydrolysis ratio of the astaxanthin esters was 98.72%, and the production of free all-trans-astaxanthin was 82.83 μg per mg of H. pluvialis oil. The method herein reported was simpler than other enzymatic methods previously described and allowed saving of time and costs.     

Dehydroacetic acid in cheese and cheese coating,results of official control in Italy

This paper reports the occurrence of dehydroacetic acid in cheese and cheese coatings collected in Italy during Agricultural Ministry Official control. Dehydroacetic acid is an antimicrobial substance not allowed to be used in EU countries as a food additive, with unknown effects on human health. Dehydroacetic acid was measured by a validated HPLC method according to Commission Decision 2002/657/EC criteria in terms of specificity, linearity, precision and accuracy, limit of detection, and limit of quantification. The method was successfully applied to 129 samples of commercial cheese coatings and related treated cheeses collected in Italy during 2017. The overall results demonstrated that about 40% of the investigated cheese coatings contained dehydroacetic acid, ranging from 0.010% to 2.5% w/w, evidencing illicit employment of this substance. Moreover, about 25% of treated cheeses contained dehydroacetic acid, from 5 to 250 mg/Kg, proving transfer of this substance from crust to cheese.     

Steering nitrogen fertilisation by means of portable chlorophyll meter reduces nitrogen input and improves quality of fertigated cantaloupe (Cucumis melo L. var. cantalupensis Naud.)

BACKGROUND: Farming is considered one of the main causes of land degradation and underground water pollution. The increased availability of agricultural inputs has led to a dramatic rise in yields, which has resulted in soil fertility spoilage and overuse of fertilisers. Therefore horticultural practice improvement must consider appropriate nitrogen (N) management. This paper reports results on the application of an optical diagnostic system (N‐tester) to guide N fertilisation in muskmelon (Cucumis melo L.) over a 3 year trial. Results on fresh and postharvest quality are also presented. RESULTS: Fertilisation events mirrored increases in N‐tester values during the season, and a significant linear relationship (R² = 0.628) was observed between N‐tester readings and leaf chlorophyll content. The N‐tester‐guided fertilisation treatments were characterised by yields comparable to the control, but with significantly lower applications of N (down to 17–66% of the N distributed in the control). Moreover, the N‐tester treatments yielded fruits with higher sugar content. This was also true after storage, when N‐tester fruits also showed reduced weight loss associated with lower transpiration and ethylene emission rates. CONCLUSION: Through the use of ‘spy plots’ kept at optimal nutritional status and the adoption of a threshold for N application throughout the growing cycle of muskmelon, the N supply was significantly reduced. Therefore a correct application of N‐tester allowed the plant N requirement to be reduced and the fruit sugar content and storability to be increased without adversely affecting the yield. Copyright © 2009 Society of Chemical Industry