Study of impurity induced modifications in amorphous N-type (GeSe3·5)100−x Bi x using high pressure technique

The technique of high pressure is utilized to study the carrier transport behaviour in doped and undoped bulk amorphous (GeSe_3·5)_100−x Bi _x (x=0, 2, 4, 10) down to liquid nitrogen temperature to observe impurity induced modifications in amorphous semiconductors. It is observed that pressure induced effects in lightly doped (2 at % Bi) and heavily doped (x=4, 10) semiconductors are markedly different. Results are discussed in view of the incorporation behaviour of the bismuth impurity.     

Response to comments on upgrading of middle distillate fractions of a syncrude from Athabasca oil sands

In response to an interpretation made by Moore and Akgerman of data taken from a recent publication, previously unexplainable phenomena are accounted for, based on new experimental results. These relate to a thermodynamic equilibrium reaction involving saturation of aromatic hydrocarbons in synthetic crude middle distillates.     

H2S optimization for lignite liquefaction

Two lignite samples, Beulah No. 3 and Big Brown No. 1, were liquefied at 420 °C using H₂ and synthesis gas to determine the optimum beneficial amount of H₂S in the batch autoclave reactor. Under the conditions employed, 50–100 psi partial pressure of H₂S, nominally 4–10 wt% of daf lignite, was optimum for both samples. Synthesis gas outperformed H₂ with and without H₂S for the liquefaction of the two coals.     

The growth of ambient aerosols in the conditions of the respiratory system

The effect on ambient aerosols of exposure to the conditions of the respiratory system was determined by sampling simultaneously through two dichotomous samplers in parallel. In one of the samplers the aerosol was brought to 37°C and near 100% relative humidity before passing through the virtual impactor. The results show that, as a result of humidification, about 10–15% by mass of the aerosol which would normally been collected in the fine (less than 2.5 μm aerodynamic diameter) fraction of the sample grows sufficiently when humidified to be collected with the coarse fraction. It is suggested that the direct application to inhalation studies of dichotomous sampler results should be approached with some caution.     

Mechanism of void formation in cable covering

Solidification after extrusion of coaxial cables has been experimentally simulated. Solidification tests were performed with two HDPE grades and under several pressures; the extrusion velocity was varied in a suitable range so as to detect the critical velocity for void formation. A qualitative analysis of the void formation mechanism is carried out, and the predicted trends favorably compare with the critical velocity data.