激光加热在Al2O3/Ti系梯度功能材料制备过程中的作用及机理

梯度功能材料是一种界面连续化的新型复合材料,本文研究了激光加热在合成Al2O3/Ti系梯度功能材料过程中的作用和机理,同时用激光大光斑加热方法制备出直径11mm厚度3mm完整的FGM试样并加以分析,以及首次采用在试样中埋设微细热电偶成功地测出了激光加热造成的温度梯度分布。     

Matrix unit cell scheduler (MUCS) for input-buffered ATM switches

This paper presents a novel matrix unit cell scheduler (MUCS) for input-buffered asynchronous transfer mode (ATM) switches. The MUCS concept originates from a heuristic strategy that leads to an optimal solution for cell scheduling. Numerical analysis indicates that input-buffered ATM switches scheduled by MUCS can utilize nearly 100% of the available link bandwidth. A transistor-level MUCS circuit has been designed and verified using HSPICE. The circuit features a regular structure, minimal interconnects, and a low transistor count. HSPICE simulation indicates that using 2-μm CMOS technology, the MUCS circuit can operate at clock frequency of 100 MHz     

自发参量下转换制备双光子纠缠态在量子信息学中的应用

叙述了自发参量下转换制备双光子纠缠态技术的发展历程、技术原理以及在量子信息学中的应用，并介绍了国内这一领域的进展。     

柴油机低频排气噪声规律分析

针对柴油机（4－85）低频排气噪声，对其产生机理、规律及其影响因素等作了理论计算、分析及实验。对低频排气噪声信号进行频域分析后可知，其主要由一系列离散的谐波组成，是以柴油机点火频率为基频的一种类周期性噪声，有可能应用有源噪声控制技术。     

对立堵截流难度的认识及其改善措施

 从立堵截流工程实践中,认识到影响截流难度的主要水力因素是截流落差Z、截流流量Q和截流水深h。结合葛洲坝工程、三峡工程等截流工程简要介绍了降低以上3个参数的一般措施。     

苯基荧光酮类试剂在金属及合金光度分析中应用新进展

本文评述了近年来苯基荧光酮类试剂在金属及合金光度分析中应用的发展状况,显色反应的条件,以及相应光度分析方法的检测限和测定范围等。参考文献87篇。     

Eigenstructure assignment by decentralized output feedback-acomplete parametric approach

The problem of eigenstructure assignment in multivariable linear systems by decentralized output feedback is considered. By using a complete parametric solution of a generalized Sylvester matrix equation, parametric representations of both the left and right closed-loop eigenvectors and generalized eigenvectors as well as the feedback gains with respect to the closed-loop eigenvalues and two series of partially free parameter vectors are established. The obtained result does not require any conditions on the closed-loop eigenvalues, and generalizes some previous results in this area. An example shows the effect of the proposed approach     

Dynamic contributions to the DNA binding entropy of the EcoRI and EcoRV restriction endonucleases

Molecular Dynamics simulations on DNA-EcoRI and DNA-EcoRV complexes suggest that the DNA within these complexes is significantly more ordered than free DNA. Similarly, both the protein and the DNA are more ordered in the specific (cognate) DNA-EcoRV complex than they are in the non-cognate DNA-protein complex, consistent with recently proposed analogies between protein folding and sequence-specific DNA-protein recognition. Analysis of the trajectories shows that the net entropy gain upon specific binding to be the result of opposing contributions. Solvent release, which increases entropy versus configurational terms (as measured by the magnitude of the atomic fluctuations), and collective terms from tight coupling between the motions of the protein and the DNA.     

差分式连续时间电流型CMOS跨导—电容低通滤波器

应用信号流图法对电流系统传递函数直接模拟，提出了一种新颖的差分式连续时间电流模式ＣＭＯＳ跨导－电容低通滤波器的实现方案。由于采用了差分式结构和电流负反馈，整个电路方案具有差分式结构和电流型电路的优点；并且仅使用最少数量的ＯＴＡ和电容，与数字ＣＭＯＳ工艺兼容，适于全集成。面向实际电路完成了ＭＯＳ管级的计算机仿真，结果表明，所提出的电路方案正确有效     

深斜井永久式封隔器两种套铣方式风险分析与优化措施

在深斜井大修作业中,为了适应海上修井机作业能力的需要,需要处理井下永久式封隔器。采用磨铣方式处理难度大、周期长、费用高,因此通常采取套铣方式,仅将可钻式永久性封隔器卡瓦及密封套铣掉,再打捞回收或下推至人工井底,直至不妨碍下一步作业。从作业井实际情况出发,针对深斜井永久式封隔器,采用了两种不同动力驱动方式进行套铣处理:一种是地面转盘驱动,井下全部钻具都处于旋转状态,全程摩阻及扭矩大,可以施加较大钻压;另一种为井下马达驱动,即只有马达以下钻具旋转,而马达以上钻具不转,从而降低摩阻,但施加钻压较小,否则容易引起马达失速,所以对马达性能要求较高。通过套铣风险对比分析,分别对两种套铣钻具与参数进行了优化,提出了套铣成功与否的判断依据,为现场应用提供了借鉴。