Theoretical analysis on bending behavior of functionally graded composite beam crack-controlled by ultrahigh toughness cementitious composites

Ultrahigh toughness cementitious composites (UHTCC) obviously show strain hardening property under tensile or bending loading. The failure pattern of the UHTCC components exhibits multiple fine cracks under uniaxial tensile loading with prominent tensile strain capacity in excess of 3%, with merely 60 μm average crack width even corresponding to the ultimate tensile strain state. The approach adopted is based on the concept of functionally-graded concrete, where part of the concrete, which surrounds the main longitudinal reinforcement in a RC (reinforced concrete) member, is strategically replaced with UHTCC with excellent crack-controlling ability. Investigations on bending behavior of functionally-graded composite beam crack controlled by UHTCC has been carried out, including theo- retical analysis, experimental research on long composite beams without web reinforcement, validation and comparison between experimental and theoretical results, and analysis on crack control. In addition to improving bearing capacity, the results indicate that functionally-graded composite beams using UHTCC has been found to be very effective in preventing corrosion-induced damage compared with RC beams. Therefore, durability and service life of the structure could be enhanced. This paper discusses the development of internal force and crack propagation during loading process, and presents analysis of the internal force in different stages, moment-curvature relationship from loading to damage and calculation of mid-span deflection and ductility index. In the end, the theoretical formulae have been validated by experimental results.     

The influence of pH on reaction pathways for O2 reduction on the Au(100) face

Oxygen reduction on the Au(100) face was studied by the rotating disk-ring electrode technique in solutions of anions which adsorb strongly on gold (HSO₄⁻/SO₄²⁻ and/or OH⁻) over the entire pH range. The specific adsorption of OH⁻ anions, which is a pH dependent process, is found to play the key role in determining the reaction pathways. In the absence of OH⁻ adsorption, for pHs below 6, the reduction of O₂ begins as a 2e-process. Due to the increase in local pH during O₂ reduction, the reaction pathway turns into a 4e-reduction at a certain potential depending on the pH of the solution. For pHs higher than 6, O₂ reduction begins as a 4e-process in the potential region where specifically adsorbed OH⁻ anions are present.     

Studies of surface and gas reactions in a catalytically stabilized combustor

A numerical investigation of a catalytically stabilized thermal (CST) combustor was conducted for a multichannel catalyst bed, and both the catalyst bed and thermal combustor were simultaneously modeled. The numerical model handled the coupling of the surface and gas reaction in the catalyst bed as well as the gas reaction in the thermal combustor. The behavior of the catalyst bed was investigated at a variety of operating conditions, and location of the flame in the CST combustor was investigated via an analysis of the distribution of CO concentration. Through parametric analyses of the flame position, it was possible to derive a criterion to determine whether the flame is present in the catalyst bed or the thermal combustor for a given inlet condition. The results showed that the maximum inlet temperature at which the flame is located in the thermal combustor increased with increasing inlet velocity.     

Restoration of depressed prostanoid-induced ileal contraction in spontaneously hypertensive rats by dietary fish oil

We have reported that dietary fish oil (FO) rich in n-3 PUFA modulates gut contractility. It was further demonstrated that the gut of spontaneously hypertensive rats (SHR) has a depressed contractility response to prostaglandins (PG) compared with normotensive Wistar-Kyoto (WKY) rats. We investigated whether feeding diets supplemented with n-3 PUFA increased gut contractility and restored the depressed prostanoid response in SHR gut. Thirteen-week-old SHR were fed diets containing fat at 5 g/100 g as coconut oil (CO), lard, canola oil containing 10% (w/w) n-3 FA as alpha-linolenic acid (1 8:3n-3), or FO (as HiDHA, 22:6n-3) for 12 wk. A control WKY group was fed 5 g/100 g CO in the diet. As confirmed, the SHR CO group had a significantly lower gut response to PGE2 and PGF2alpha compared with the WKY CO group. Feeding FO increased the maximal contraction response to acetylcholine in the ileum compared with all diets and in the colon compared with lard, and restored the depressed response to PGE2 and PGF2alpha in the ileum but not the colon of SHR. FO feeding also led to a significant increase in gut total phospholipid n-3 PUFA as DHA (22:6n-3) with lower n-6 PUFA as arachidonic acid (20:4n-6). Canola feeding led to a small increase in ileal EPA (20:5n-3) and DHA and in colonic DHA without affecting contractility. However, there was no change in ileal membrane muscarinic binding properties due to FO feeding. This report confirms that dietary FO increases muscarinic- and eicosanoid receptor-induced contractility in ileum and that the depressed prostanoid response in SHR ileum, but not colon, is restored by tissue incorporation of DHA as the active nutrient.     

Very long chain PUFA in murine testicular triglycerides and cholesterol esters

Very long chain (VLC) PUFA of the n−6 and n−3 series are known to occur in mammalian testis. The aim of this work was to characterize further two testicular lipid classes with VLCPUFA, cholesterol esters (CE) and total triglycerides (TG) in rat and mouse testis. The VLCPUFA predominating in these lipids were a series of n−6 pentaenes and tetraenes with 24 to 32 carbons, including small amounts of odd-chain PUFA, 28∶5n−6 and 24∶5n−6 prevailing in CE and TG, respectively. Most of the VLCPUFA of TG were concentrated in a small fraction of TG, made up by 1-O-alkyl-2,3-DAG. This TG subclass was absent altogether from the TG of sexually immature testis. The TG and the CE with VLCPUFA only occurred in testis of adult fertile animals. The proportion of VLCPUFA in total TG and CE was higher in rodents than in other mammals. In the n−6 PUFA-rich adult mouse testis, the amounts of testicular triacylglycerols decreased significantly after consumption of fish oil for 2 wk. Whereas 18∶2n−6 was significantly reduced, the amounts of 22∶5n−6 and longer n−6 PUFA were less affected in all mamor testicular lipids including PC and PE, where they were unchanged. The 1-O-alkyl-2,3-DAG and their n−6 VLCPUFA were virtually unaffected by the diet. The VLCPUFA-containing molecular species of CE and TG may represent a form of storage of cholesterol and polyenoic FA required to sustain spermatogenesis. Via chain-shortening, VLCPUFA stored in the neutral lipids may serve as precursors of the major C₂₂ PUFA typical of cell membrane glycerophospholipids, protecting testicular cells against shifts in FA composition induced by dietary changes.     

大孔强酸树脂吸附硫脲金

研究了D072大孔强酸性阳离子交换树脂从硫脲[Tu=CS(NH2)2]浸金液中吸附Au(Tu)2+的性能和机理. 结果表明，pH=2.0时，树脂对Au(Tu)2+有优良的吸附性能，金的交换容量为78.95 mg/g (Au/干树脂)，吸附的硫脲金可用乙醇-硫酸水溶液洗脱，洗脱率可达96.5%. D072树脂对Au(Tu)2+的吸附符合Langmuir吸附模型.     

<Emphasis Type="Italic">Penicillium</Emphasis> sp. ZD-Z1 chitosanase immobilized on DEAE cellulose by cross-linking reaction

Chitosanase obtained fromPenicillium sp.ZD-Z1 was immobilized on DEAE cellulose with glutaraldehyde by cross-linking reaction. The optimal conditions of immobilization were as follows: 0.1 g DEAE cellulose was treated with 5 ml 5% glutaraldehyde solution; then 2.3 mg chitosanase was immobilized on the carrier. The optimal temperature and pH was 60 °C and 4.0, and the K _m value was 18.87 g/L. Under optimal conditions, the activity of immobilized enzyme is 1.5 U/g, and the recovery of enzyme activity is 81.3%. After immobilization, the optimal temperature and K _m value increased (from 50 °C to 60 °C, from 2.49 g/L to 18.87 g/L), whereas the optimal pH was reduced (from 5.0 to 4.0). The enzyme activity loss was less than 20% after 10 times batch reaction; the immobilized enzyme showed good operation stability.     

Hydrothermal synthesis of LA-MN-Hexaaluminates for the catalytic combustion of methane

Hydrothermal synthesis by using urea hydrolysis at 1.0-3.0 MPa and 120-130 ‡C was employed to prepare Mn-substituted hexaaluminate catalysts for methane combustion. The results from DTA-MS demonstrated that CO_3- and Off anions co-exist in the hydrothermal reaction. XRD reveals that the components of carbonates and hydroxides in the hydrothermal reaction are more favorable than those in the (NH₄)₂CO₃ co-precipitation for the formation of the Mn-substituted hexaaluminate phase. After calcination at 1,200 ‡C for 2 h, LaMnAl₁₁O₁₉ is the major phase of the catalyst prepared by the hydrothermal synthesis method while LaAlO₃ is the major one of the catalysts prepared by NH₄OH and (NH₄)₂CO₃ co-precipitation. The catalyst prepared by hydrothermal synthesis has higher activity than that prepared by NH₄OH and (NH₄)₂CO₃ co-precipitation. The major reason is that more Mn²⁺ ions have incorporated into the hexaaluminate lattice. The effect of drying methods on the formation of hexaaluminate phase was also discussed.     

Catalytic degradation of waste polyolefinic polymers using spent FCC catalyst with various experimental variables

Liquid-phase catalytic degradation of waste polyolefinic polymers (HDPE, LDPE, PP) over spent fluid catalytic cracking (FCC) catalyst was carried out at atmospheric pressure with a stirred semi-batch operation. The effect of experimental variables, such as catalyst amount, reaction temperature, plastic types and weight ratio of mixed plastic on the yield and accumulative amount distribution of liquid product for catalytic degradation was investigated. The initial rate of catalytic degradation of waste HDPE was linearly increased with catalyst amount (4-12 wt%), while that was exponentially increased with reaction temperature (350-430 ‡C). Spent FCC catalyst in the liquid-phase catalytic degradation of polymer was not deactivated fast. The product distribution from catalytic degradation using spent FCC catalyst strongly depended on the plastic type. The catalytic degradation of mixed plastic (HDPE: LDPE: PP: PS=3: 2: 3: 1) showed lower degradation temperature by about 20 ‡C than that of pure HDPE.     

Synthesis and Polymerization of Cationic bis(cyclopentadienyliron)arene Complexes Containing Arylazo Dyes

The synthesis of the title complexes was achieved via the reaction of -p-dichlorobenzene- -cyclopentadienyliron cations with 4,4′-bis(4-hydroxyphenyl)valeric acid to produce the diiron complexes which were then reacted with a number of arylazo dyes to give cationic bis(cyclopentadienyliron)arene complexes containing the arylazo dyes. These iron-containing monomers were subsequently polymerized via nucleophilic aromatic substitution using 1,8-octanedithiol, 4,4′-thiobisbenzenethiol, or bisphenol A to produce the desired coloured cationic organoiron polymers. The weight – average molecular weights were estimated to range from 11,800 to 31,600. UV–vis studies conducted in dimethylformamide (DMF) showed that the metallated polymers exhibited of 412–491 nm. Addition of HCl to the polymer solution caused a bathochromic shift into the range of 515–530 nm. Thermogravimetric analysis (TGA) revealed that the iron moieties were cleaved between 205 and 248 °C while the polyether/thioether backbone degraded between 380 and 613 °C. Differential scanning calorimetry (DSC) showed that the polymers exhibited glass transition temperatures (Tg) ranging from 106 to 184°C.This paper is dedicated to Professor Richard J. Puddephatt in recognition of his outstanding contribution to the field of metal-containing polymers.