Pesticide monitoring programme of the Ministry of Health of Brazil

The structure of the recently introduced Brazilian government programme for monitoring pesticide residues in six major agricultural products is described. Residues found from the analysis of samples of tomatoes and strawberries are discussed in detail. The much greater frequency of detection of pesticide residues, many of which are not approved for use in Brazil, in produce being sold on the domestic market, as opposed to that produced for export, is of major concern. It is perceived that this new monitoring programme will become permanent and be used to underpin enforcement actions that will need to be taken to reduce the numbers of incidents of illegal residues occurring, particularly in fresh fruits and vegetables.     

Quantum Critical Ferromagnetism in Ni x Pd1- x Alloys

We analyze the non-Fermi liquid behavior in the proximity of the quantum phase transition induced by the strong polarization of the electrons due to local magnetic moments in Ni _x Pd_1-x alloys. We use the renormalization group approach introduced by Hertz–Mi11is–Moriya (HMM) to estimate the temperature dependence of the electrical resistivity for the case of three dimensional itinerant ferromagnets. We study two different cases, namely, the clean and disordered ferromagnets, and argue that at the present time more experimental data are needed to decide if the HMM theory can accurately describe the physical properties in Ni _x Pd_1-x alloys.     

Influence of the shape of fiber cross section on fabric surface characteristics

Fiber cross sections for use in textiles and composites are becoming more and more complex. Shape impacts fiber or filaments properties and therefore the yarn and fabric characteristics. This paper presents the influence of the fiber cross section on the fabric surface characteristics. The material used was polyester staple fibers, of four different shapes: round, scalloped oval, cruciform and hexachannel. All fibers had the same cut length with different fineness. Yarns obtained from these fibers had nominally the same yarn count, torsion value and structure. Plain jersey fabrics were knitted from each of the yarns under identical conditions and then relaxed prior to testing. Friction behavior was evaluated and a roughness-friction criterion developed. An indirect measurement of the real area of contact was obtained in order to provide roughness and friction properties. The influence of fiber cross section on yarn bending rigidity and on the state of the knitted fabric surface was characterized.     

Thermodynamic Properties of Alloys and Phase Equilibria in the In–Sb System

New thermodynamic data for the In–Sb system are obtained and compared with calculation results available in the literature. An isothermal vacuum cell and a procedure for electrolyte preparation are described which ensure high measurement accuracy.     

High-gain pseudomorphic InGaAs base ballistic hot-electron device

A high-gain ballistic hot-electron device is described. The GaAs-AlGaAs heterostructure device, with a 21-mm-thick pseudomorphic In _0.12Ga_0.88As base, had a current gain of 27 at 77 K and 41 at 4.2 K. As characteristically seen in ballistic devices, transfer into the L valley limited the maximum gain. The Γ-L valley separation in the strained In_0.12Ga_0.88As was estimated to be about 380 meV     

Effects of flux enhancing polymer on the characteristics of sludge in membrane bioreactor process.

A newly developed membrane performance enhancer (MPE) was used to prevent membrane fouling in a membrane bioreactor (MBR) process. It transpired that 1,000 mg/l of MPE reduced polysaccharide levels from 41 mg/I to 21 mg/I on average under the experimental condition. Repeated experiments also confirmed that 50-1,000 mg/l of MPE could reduce membrane fouling significantly and increase the intervals between membrane cleanings. Depending on MPE dosages and experimental conditions, trans-membrane pressure (TMP) increase was suppressed for 20-30 days, while baseline TMP surged within a few days. In addition, MPE allowed MBR operation even at 50,000 mg/l of total solid and reduced permeate COD. However, no evidence of toxicity for sludge was found from respiratory works.     

Towards new indicators for the prediction of solid waste anaerobic digestion properties.

The biochemical composition can be seen as a good indicator of both the biodegradability and the methane potential of a given waste. The work presented here is an attempt to elaborate a typology of wastes and to compare it to the anaerobic degradation characteristics. The first data indicate that there is a link between the ligno-cellulosic content of the waste and the biodegradability. When dealing with application to anaerobic digestion processes, having a tool to predict the ability of the waste to be degraded could be of the greatest interest for preventing failures, estimating biogas production, methane content, or for the management of co-digestion processes.     

An integrated system to remote monitor and control anaerobic wastewater treatment plants through the internet.

The TELEMAC project brings new methodologies from the Information and Science Technologies field to the world of water treatment. TELEMAC offers an advanced remote management system which adapts to most of the anaerobic wastewater treatment plants that do not benefit from a local expert in wastewater treatment. The TELEMAC system takes advantage of new sensors to better monitor the process dynamics and to run automatic controllers that stabilise the treatment plant, meet the depollution requirements and provide a biogas quality suitable for cogeneration. If the automatic system detects a failure which cannot be solved automatically or locally by a technician, then an expert from the TELEMAC Control Centre is contacted via the internet and manages the problem.     

Financial Analysis and Marketing Strategy

A combination of concept (the product portfolio and the product life cycle) and empirical research (the PIMS study) can aid in clarifying the key issues involved in the selection of a firm's core strategies. Strategy control is multistage: periodic re-evaluation of strategy alternatives by use of the marketing audit; an analytical framework for control of chosen strategies by breaking down components and reporting their performance variances; and 'marketing segment' analysis for control of the detailed marketing plan.?