Structural,morphological, dielectric and magnetic properties of Zn-Zr co-doping yttrium iron garnet

In this study, yttrium iron garnet co-doped with Zn and Zr atoms with a chemical formula Y₃Zn_xZr_xFe_(5−2x)O₁₂ (x = 0.0-0.3) has been successfully prepared by the solid-state reaction method. The effects of doping concentration on the microstructure, crystal structure, magnetic properties, and dielectric properties of Y₃Zn_xZr_xFe_(5−2x)O₁₂ were investigated. The microstructure analysis indicates that co-doping of YIG with Zn and Zr can effectively reduce the grain size of the ceramic. The crystal structure results reveal that the doping concentration of Zn–Zr has substantial influence on the lattice parameters of YIG, such as, increases the lattice constant, crystal cell size, and interplanar spacing. However, the second phase of ZrO₂ appears once x ≥ 0.15. Additionally, the dielectric properties of YIG ferrite can be regulated using this Zn–Zr co-doping method. Zn–Zr co-doping can improve the dielectric stability and reduce the dielectric loss at high temperature. The magnetization measurement shows that the saturation magnetization is stabilized at x < 0.15, and the magnetic loss is decreased with the increase in the doping concentration. Overall, the findings show that the ceramic with x = 0.1 exhibits better properties included high saturation magnetization (24.607 emu/g), low magnetic loss (0.0025 @ 1 MHz), and relatively low dielectric loss (496 @ 400°C).     

基于图像增强的去雾快速算法的FPGA实现

基于图像增强方法，本文提出了一种使用亮度映射的图像去雾快速算法。此算法通过调整室外多雾场景图像的对比度，提高了雾中物体的辨识度。算法的复杂度低、处理延迟小，实时性高，利于FPGA的实现。实现时不需外存储器，延时为ns级，并提供了强度调节接口，以适应较广的应用环境。     

Single-Crystalline TiO2(B) Nanobelts with Unusual Large Exposed {100} Facets and Enhanced Li-Storage Capacity

The {100} facet of single-crystalline TiO₂(B) is an ideal platform for inserting Li ions, but it is hard to be obtained due to its high surface energy. Here, the single-crystalline TiO₂(B) nanobelts from H₂Ti₃O₇ with nearly 70% {100} facets exposed are synthesized, which significantly enhances Li-storage capacity. The first-principle calculations demonstrate an ab in-plane 2D diffusion through the exposed {100} facets. As a consequence, the nanobelts can significantly accommodate Li ions in LiTiO₂ formula with specific capacity up to 335 mAh g⁻¹, which is in good agreement with the electrochemical characterizations. Coating with conductive and protective poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate), the cut-off discharge voltage is as low as 0.5 V, leading to a capacity of 160.7 mAh g⁻¹ after 1500 cycles with a retention rate of 66% at 1C. This work provides a practical strategy to increase the Li-ion capacity and cycle stability by tailoring the crystal orientation and nanostructures.     

A dynamic SVR–ARMA model with improved fruit fly algorithm for the nonlinear fiber stretching process

Natural Computing - The fiber stretching process plays the key role in the process of fiber production and its effects is measured by the stretching ratio. The stretching ratio is determined by the...     

基于注意力机制与文本信息的用户关系抽取

随着社交媒体的发展,用户之间的关系网络对于社交媒体的分析有很大的帮助。因此,该文主要研究用户好友关系检测。以往的关于用户好友关系抽取的研究主要基于社交媒体上的结构化信息,比如其他好友关系,用户的不同属性等。但是,很多时候用户本身并没有大量的好友信息存在,同时也不一定有很多确定的属性。因此,我们希望基于用户发表的文本信息来对用户关系进行预测。不同于以往的潜在好友推荐算法,该文提出了一种基于注意力机制以及长短时记忆网络(long short-term memory,LSTM)的好友关系预测模型,将好友之间的评论分开处理,通过分析用户之间的评论来判断是否具备一定的好友关系。该模型将好友双方信息拼接后的结果作为输入,并将注意力机制应用于LSTM的输出。实验表明,用户之间的评论对于好友关系预测确实有较大的实际意义,该文提出的模型较之于多个基准系统的效果,取得了明显的提升。在不加入任何其它非文本特征的情况下,实验结果的准确率达到了77%。     

Facile construction of composition-tuned ruthenium-nickel nanoparticles on g-C3N4 for enhanced hydrolysis of ammonia borane without base additives

Developing high-efficiency and low-cost catalysts for hydrogen evolution from hydrolysis of ammonia borane (AB) is significant and critical for the exploitation and utilization of hydrogen energy. Herein, the in-situ fabrication of well-dispersed and small bimetallic RuNi alloy nanoparticles (NPs) with tuned compositions and concomitant hydrolysis of AB are successfully achieved by using graphitic carbon nitride (g-C₃N₄) as a NP support without additional stabilizing ligands. The optimized Ru₁Ni_7.5/g-C₃N₄ catalyst exhibits an excellent catalytic activity with a high turnover frequency of 901 min^?1 and an activation energy of 28.46 kJ mol^?1 without any base additives, overtaking the activities of many previously reported catalysts for AB hydrolysis. The kinetic studies indicate that the AB hydrolysis over Ru₁Ni_7.5/g-C₃N₄ is first-order and zero-order reactions with respect to the catalyst and AB concentrations, respectively. Ru₁Ni_7.5/g-C₃N₄ has a good recyclability with 46% of the initial catalytic activity retained even after five runs. The high performance of Ru₁Ni_7.5/g-C₃N₄ should be assigned to the small-sized alloy NPs with abundant accessible active sites and the synergistic effect between the composition-tuned Ru–Ni bimetals. This work highlights a potentially powerful and simple strategy for preparing highly active bimetallic alloy catalysts for AB hydrolysis to generate hydrogen.     

气烟囱效应——礁滩相岩性气藏的典型地震响应特征

品质良好的地震剖面上出现的地震模糊带称为气烟囱，发现和识别气烟囱是寻找大型气藏的有效方法。四川盆地东北部长兴组气藏是礁滩相岩性气藏，礁、滩作为一个独立的岩性体，与周围的地层、岩性结构差异较大，由此在构造应力场中形成力学尖点，从而产生气烟囱效应。已知的黄龙场、普光等气田，其气烟囱普遍存在。点礁通常形成下方的气烟囱，台缘礁通常在上方形成气烟囱；礁滩相在构造运动中控制了断层的发育过程，凸起的礁滩相上方可能发育对冲断层；斜坡较陡的台缘礁可能发育叠置的逆冲断层；礁、滩两侧边缘的断层一般都比较发育。断层发育加强了气烟囱效应。模拟试验验证了地震剖面解释结果。根据气烟囱地震相特征，预测黑池梁存在一个大型气藏。     

试油井选层压裂新工艺及现场试验

设计新型可洗井封隔器，保障油井有反洗井通道，有效防止封隔器以上砂埋所引发的管柱砂卡事故，并对新型封隔器、控制开关、密封接头、同心大通径压力计托筒等井下工具组合优化。解决了多层油井任意选层压裂、求产、测井温一体化的难题。     

网络安全事件的关联分析方法的比较研究

随着当前攻击手段和技术的日益复杂化,一次入侵事件往往需要多个步骤才能完成,这些步骤都是彼此相关的。但是传统的入侵检测集中于检测底层的入侵或异常,所检测到的结果也仅仅是一次完整入侵的一部分,所以不能将不同的报警结合起来以发现入侵的逻辑步骤或者入侵背后的攻击策略。关联分析技术将不同分析器上产生的报警进行融合与关联分析,极大地减少了报警的数量,降低了入侵检测的误报率,并且适当的减少了入侵检测的漏报率。文中在对网络安全事件关联分析方法的系统结构进行分析后,着重介绍了当前比较流行的几种网络安全事件关联分析方法,最后对各种方法进行了比较研究。     

Extracting Light from Polymer Light‐Emitting Diodes Using Stamped Bragg Gratings

In this paper, we describe a method for increasing the external efficiency of polymer light‐emitting diodes (LEDs) by coupling out waveguided light with Bragg gratings. We numerically model the waveguide modes in a typical LED structure and demonstrate how optimizing layer thicknesses and reducing waveguide absorption can enhance the grating outcoupling. The gratings were created by a soft‐lithography technique that minimizes changes to the conventional LED structure. Using one‐dimensional and two‐dimensional gratings, we were able to increase the forward‐directed emission by 47 % and 70 %, respectively, and the external quantum efficiency by 15 % and 25 %.