金属间化合物的研究现状及其最新发展趋势

主要介绍了金属间化合物的概念、发展历程、研究现状及几种常用金属间化合物的发展状况，并提出了该类材料的最新发展趋势。     

乙环唑的合成研究

介绍了以2,4-二氯苯乙酮为原料通过催化溴化、缩合反应、与三氮唑钠反应制得原药,原药含量达到92%以上.并对合成条件进行了研究,取得了较为满意的结果.     

普钙产品转化率的数值计算方法

对影响普钙产品转化率的各种因素进行了分析,利用MATLAB 软件包得到了转化率的计算公式,提出了确定未分解磷矿的比例和由倍半氧化物引起的有效磷退化幅度的方法,为生产系统的预测和调整提供了一种途径。     

大冶硫酸四系列干吸塔结构特点

以干燥塔为例，介绍大冶公司硫酸四系列干吸塔的结构特点。除捕沫层简体及出气管为316L不锈钢外，其余塔体均为碳钢内衬瓷砖结构。塔底为球形底，中心排酸。采用槽管式分酸器，分酸点密度为43个/m^2，设可调闸板以保证各槽酸量均匀；闸板外设置带孔板的分布板，以消除进口酸的冲击，保证槽内酸液面平稳。比较了该塔与常规塔的不同之处，强调了设备节点的优化设计。     

广西田阳县生态扶贫产业核心示范区一期工程补水泵站设计

结合广西田阳县生态扶贫产业核心示范区一期工程补水泵站实际情况,通过方案比选,采用河流入江口东岸布置方案,并对泵站进行了设计介绍,总结技术特点,为类似工程提供参考。     

甲氧胺盐酸盐的含量测定方法

提出了以酚酞为指示剂，氢氧化钠为滴定剂测定甲氧胺盐酸盐含量的方法。测定了甲氧胺盐酸盐的离解常数Ka，考察了干扰因素对测定的影响。结果表明，干扰物质NH4Cl在样品中的含量小于5％不影响测定。该方法具有简便、快速，准确等特点,测定了数批样品结果较满意。     

复合泡沫塑料的性能改进研究

为改善复合泡沫塑料的介电性能,采用金属氧化物粒子填充改性双马来酰亚胺空芯玻璃微球复合泡沫塑料得到了高介电常数、低介质损耗因数、低密度、力学性能良好的电介质材料。     

混炼硅橡胶的配合技术(四)

介绍了几种胶辊用混炼硅橡胶的配制,包括低硬度胶辊用混炼硅橡胶、低环硅氧烷含量的胶辊用混炼硅橡胶、送纸胶辊用混炼硅橡胶及工业胶辊用混炼硅橡胶的配制。     

High catalytic activity of PdOx/MnO2 for CO oxidation and importance of oxidation state of Mn

PdO_x/MnO₂ has been examined as a catalyst for CO oxidation using a conventional flow reactor at reaction temperatures between 50 and 150°C. In the reaction conditions of GHSV (gashourlyspacevelocity) of 1.22 × 10⁵/h and CO concentration of 2000 ppm, PdO_x/MnO₂ showed higher catalytic activity compared with PdO_x/Mn₂O₃, which had been previously reported as an effective catalyst due to the cooperative action of Pd and Mn₂O₃ for this reaction. The reason for higher activity of PdO_x/MnO₂ than PdO_x/Mn₂O₃ has been investigated using TPR (temperatureprogrammed reduction) and XPS studies. TPR showed that PdO_x/MnO₂ could be reduced by CO at much lower temperature than PdO_x/Mn₂O₃. During the experiment of reduction and oxidation, XPS showed that the valence of Mn in the PdO_x/MnO₂ was between 4+ and 3+, which is higher than that of Mn in the PdO_x/Mn₂O₃ catalyst of which the valence has been reported to be between 3+ and 2+. It is known that in this catalyst system the support supplies oxygen onto Pd, where the oxidation occurs with adsorbed CO, and the ability of the support to provide oxygen improves the performance of the catalyst. Therefore, it was concluded that the readiness of MnO₂ to be reduced with maintaining a higher oxidation state showed higher CO oxidation activity than Mn₂O₃ as support for PdO_x.     

Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.